MP200
-3-www.printrex.com
Preparation
Setting the Paper Size
The Recorder is factory set for A-size (8 ½ by 11
inch) media. It is required to adjust the Recorder for
use with A4-size (210 by 297 mm) media. A Number
1 Phillips screwdriver is recommended to make the
adjustment.
The adjustment can be made by placing the Recorder
on its Front Surface (a cloth or towel can be used to
protect the Recorder and table top from scratches).
Locate and loosen (do NOT remove) the five Paper
Size Adjustment screws, see Figures 4 and 5. Slide
the Paper Adjustment Plate inward towards the
center of the Paper Compartment until it stops.
There are two holes in the Paper Adjustment Plate
that can be used to maneuver the Paper Adjustment
Plate into position. Tighten the adjustment screws
while holding the adjustment plate in position.
The Recorder can be reset to accommodate A-sized
media by using the above procedure except sliding
the Paper Adjustment Plate away from the Paper
Compartment then re-tightening the adjustment
screws.
Connecting the Parallel Interface Cable
Locate the Parallel Interface Cable and insert the
end that mates with the Recorder Interface
Connector (Figure-2). Insert the other end of the
Parallel Interface Cable to the Instrument Parallel
Port Connector (refer to the Instrument User
Guide/Service Manual to locate the Parallel Port
Connector).
Accessories equipment connected to the analog and digital
interfaces must be certified to the respective IEC standards (i.e.
IEC 950 for data processing equipment and IEC 601-1 for
medical equipment.) Furthermore all configurations shall
comply with the system standard IEC 601-1-1. Everybody who
connects additional equipment to the signal input part or signal
output part configures a medical system, and is therefore,
responsible that the system complies with the requirements of
the system standard IEC 601-1-1. If in doubt, consult the
technical services department or your local representative.
Connecting the Power Cord
Locate the Power Cord and insert the end that
mates with the Recorder Power Entry Module
(Figure-2). Plug the other end of the Power Cord to
the receptacle location described in the User
Guide/Service Manual of the Instrument the
Recorder is connected to.
Paper Size Adjustment
Screws (top, 3 ea.)
Paper Adjustment Plate
Figure-4
Figure-5
Paper Size Adjustment
Screws (bottom, 2 ea.)
