- 6 -
Now push the pump qonto the mounting yso that the drive shaft e
projects into the thread of the drive shaft w, and the pins of the mounting
yare located in the reception holes on the pump q.
Let the drill ustart to run in a clockwise rotation and at low revolutions
and then guide the pump qstraight onto the drive shaft e. The drive
shaft eis thereby secured to the pump q.
Attach the suction hose to the connection oand the pressure hose to the
connection a. Pay heed to the direction of flow detailed on the
pump q.
When using a chuck with SDS fitting and the long drive
shaft r...
Attach the long drive shaft rinto the chuck.
Insert the electric drill u, with the pre-assembled drive shaft rin the
chuck, into the mounting y.
Tighten the cross-headed screw on the mounting yfirmly, so that the drill u
cannot jolt around.
Now push the pump qonto the mounting yso that the drive shaft r
projects into the thread of the drive shaft wand the pins of the mounting
yare located in the reception holes on the pump q.
Allow the electric drill uto run with a clockwise rotation and low revoluti-
ons and guide the pump qstraight on to the drive shaft r. With this the
drive shaft rwill be fixated onto the pump q.
Attach the suction hose to the connection oand the pressure hose to the
connection a. Pay heed to the direction of flow detailed on the
pump q.
IB_75640_PBMP30A1_LB4.qxd 06.06.2012 12:13 Uhr Seite 6
