Power Inspired VIX2060 Manuel utilisateur
VIX SERIES UPS
USER MANUAL
POWER SWITCH
RED LED
YELLOW LED
GREEN LED
VIX2060
VIX2120 / 2150
USB Port
Tel/Fax Surge
Protector
Battery Backed
Outlets
Input Power
Fuse
Surge Only Outlet
(VIX2060 only)
Output Cable
IDENTIFICATION
Remove the input power lead from your computer and connect this to the AC “Input Power”.
Connect one end of the Output Cable provided to a Battery Backed Outlet, and the other to your
computer.
Remove your telecommunications equipment lead from the apparatus and connect to the TEL/FAX
protector. Using the lead provided connect from the additional TEL/FAX protector port to your
apparatus. (NOTE: This is to provide surge protection on telephony lines and is not required for
operation of the UPS).
Connect the USB lead provided to the USB port and the other to a spare USB port on your computer
(NOTE: This is to for software shutdown features –you do not need to install the software for the UPS
to operate).
Install the software on your Windows or Linux based computer following the instructions provided.
The serial number you are required to enter is the serial number on the software sleeve –not the UPS
serial number.
To switch on, press the ‘POWER SWITCH’ button on the front of the UPS. The UPS will emit an
audible alarm to confirm.
If mains power is present the GREEN LED will be illuminated and the UPS will be providing power in
AC Mode.
If no mains power is present the RED LED will be illuminated and the UPS will be providing power
from its batteries in BATTERY Mode.
When operating in AC Mode the UPS will constantly trickle charge the battery and the YELLOW LED
will be illuminated.
If the unit is operating in BATTERY MODE and no load (or a very light load) is connected the UPS will
automatically switch off after 1 minute. This is to protect the batteries against deep discharge.
To switch off, press the ‘POWER SWITCH’ button on the front of the UPS.
YELLOW
LED
GREEN
LED
RED LED
UPS STATUS
ON
OFF
OFF
AC Normal, UPS Off, Charging Battery
ON
ON
OFF
AC Normal, UPS ON in AC Mode. Charging Battery
OFF
OFF
BLINKING
AC Abnormal, UPS ON in BATTERY Mode
OFF
OFF
ON
Low Battery Voltage (UPS about to shut off), UPS Overloaded
(Remove connected load). Short Circuit (Remove fault)
OFF
OFF
OFF
UPS switched off, or auto switch off after discharge.
Buzzer
UPS Status
No Beeps
UPS Normal
Beeps once per 5 seconds
AC Abnormal, UPS in BATTERY Mode
Beeps twice every other second
Battery Voltage Low
Beeps 4 times every 2 seconds
UPS Overloaded (Remove connected load)
Beeps Continuously
UPS Fault / ShCort Circuit
TROUBLESHOOTING
OPERATION
INSTALLATION
MODEL
VIX2060
VIX2120
VIX2150
RATING
VA
600
1200
1500
WATTS (Resistive
Load)
360
720
900
INPUT
AC Input Voltage
230Vac Nominal
Input Frequency
(Typical)
40-70Hz
OUTPUT
AC Output Voltage
230Vac Typical
AC Output Voltage
Tolerance
Nominal ±10%
Output Frequency
50Hz
Output Frequency
Stability (Battery Mode)
<0.5Hz
Output Waveform (AC
Mode)
As Input
Output Waveform
(BATTERY Mode)
Stepped Sine Wave
Power Factor
0.6
Transfer Time
10ms Typical
Batteries (Ratings at 25˚C)
Nominal Voltage
12V
Number & Capacity
1x7Ah
2x7Ah
2x9Ah
Type
12V Sealed Lead Acid Maintenance Free
Service Life
1-3 Years (depending upon use)
Battery Recharge to
90% Capacity
Approx 8 hours
Runtime at full load
>3 minutes
Runtime at 50% load
>8 minutes
Physical
Dimensions (HxWxD
mm)
163 x 96 x 320
225 x 124 x 382
Enclosure
Steel / Plastic IP20
Net / Gross Weight (kg)
6.3 / 6.6
12.8 / 13.3
13.0 / 13.7
Environmental
Safety
EN 50091-1-1
EMC
EN 50091-2
Operating Temp
0 - 40˚C
Audible Sound @ 1m
<45 dBA (Alarm only)
Max Humidity
95% (Non Condensing)
For further help and advice on the VIX Series UPS visit www.powerinspired.com/vix-series-ups-faq/. For any
other issues please contact Power Inspired Ltd at info@powerinspired.com
Power Inspired Ltd., PO BOX 1498, OXFORD, OX3 3BY, UNITED KINGDOM
www.powerinspired.com
HELP & SUPPORT
SPECIFICATIONS
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels Power Inspired UPS
Power Inspired
Power Inspired VFI-C Series 1KR Manuel utilisateur
Power Inspired
Power Inspired VFI6KT Manuel utilisateur
Power Inspired
Power Inspired Willo Manuel utilisateur
Power Inspired
Power Inspired VFI1000QS Manuel utilisateur
Power Inspired
Power Inspired VIX3065 Manuel utilisateur
Power Inspired
Power Inspired iPower-DC2 Manuel utilisateur
Power Inspired
Power Inspired VIS0750 Manuel utilisateur
Manuels UPS populaires d'autres marques
Pylontech
Pylontech Victron & Pylontech US5000 Manuel utilisateur
Tecnoware
Tecnoware EVO DSP PLUS MM 6.8 Manuel utilisateur
Mecer
Mecer ME-1000-WTU Manuel utilisateur
Mustek
Mustek PowerMust 530(B) Plus Manuel d'installation et d'exploitation
Emerson
Emerson Liebert NXL series Manuel utilisateur
MAKELSAN
MAKELSAN BOXER SERIES Manuel utilisateur
