POSline ITT4300 Manuel utilisateur
ITT4300
Label Printer
CONTENTS
Checking Your Box ...............................................................................3
Power Supply........................................................................................5
Parts and Features................................................................................7
Loading the Ribbon...............................................................................9
Loading the Media...............................................................................12
Operator Controls................................................................................16
LED Indicators.....................................................................................17
Buttons................................................................................................18
Performing Calibration ........................................................................20
Printing Configuration Report..............................................................21
Resetting the Printer to Factory..........................................................22
Default Settings...................................................................................22
Hooking up the Printer & Computer....................................................23
Communicate with the Printer.............................................................24
Set the Parameters.............................................................................26
Troubleshooting ..................................................................................35
D. Miscellaneous.................................................................................37
Caring for your Printer.........................................................................39
Reference Technical Information........................................................40
POSline ITT4300 Label Printer
3
Checking Your Box
Receiving the box of your printer, you are advised to
check first for the possible shipping damage. There are two ways you
can do it:
1. Inspect the outer appearances of both the box and the printer for
possible damage.
2. Raise the top cover of the printer to see if the media compartments
are in order.
If damages did occur, immediately file the claim to the shipping
company for settlement.
Having performed the primary inspections,next step,
please check whether you have received the following accessories
together with the printer. If there is any item missing, contact your
local dealer to get i t.
POSline ITT4300 Label Printer
4
POSline ITT4300 Label Printer
5
Power Supply
Setting up the Printer
Before setting up the printer you should first consider the following:
•Find a solid flat surface with adequate room for the printer. Make
sure there is enough room on the top side for the media and
ribbon access.
•The location should be near the host or terminal. Consider the
distance between host and printer for the communication cable
(serial or parallel cable)
•Clear the ground and isolate from other electrical cables for the
power adapter.
•Connecting the Power Cord
Note: For ITT4300, make sure the power switch on rear panel been
switched to correct position and fit local power source.
•Leave the power switch at the ”O” position.
•Connect the power supply plug to the power jack and the other
end to your AC source.
POSline ITT4300 Label Printer
6
POSline ITT4300 Label Printer
6
Parts and Features
Front Access Door
POSline ITT4300 Label Printer
6
POSline ITT4300 Label Printer
6
Loading the Ribbon
Notes:
1. This section is applicable to the transfer thermal printing.
2. Attached ribbon is coating inside.
1. Lift the top access door and the front access door to expose the
compartment. ( Figure 1 )
2. Push the head latch by anti-clockwise, and then fold the bracket.
( Figure 2 )
3. Unwrap the ribbon roll pack and separate the ribbon roll and the
bare core.
4. Insert the ribbon roll into the ribbon supply spindle. ( Figure 3 )
5. Lead the bare core through the print head module. ( Figure 4 )
6. Attach the edge of the ribbon on the bare core and wind it a little bit
onto the core.
Note: The dull side of the ribbon should be faced down.
7. Insert the bare core into the ribbon pick-up spindle. ( Figure 5 )
8. Turn the pick-up spindle to ensure the ribbon is tightly wound.
POSline ITT4300 Label Printer
6
Table des matières
Autres manuels POSline Étiqueteuse
