Polycom RealPresence Group Series Manuel

Polycom®RealPresence®Group Series Media Center

with 65 Inch Dual Displays

SETUP SHEET

This supplement describes how to attach 65 inch dual displays on the Polycom®RealPresence®Group Series

Media Center. Follow the instructions in Setting Up the Polycom RealPresence Group Series Media Center,

1725-08510-00X, and use this supplement to replace the steps to install the displays.

Single 55/65 inch Lower Display Rail, 1354-67626-002

(2) Dual 65 inch Lower Display Rail Extension, 1354-68667-002

Dual 65 inch Center Top Display Rail, 1354-68669-001

(2) Dual 65 inch Upper Display Rail Extension, 1354-68671-001

(4) Display Mounting Bracket

Assembly

2342-67629-001

(4) M8 x 20 Button Head Cap Screw

1601-52713-001

(4) M8 Hex Flange Nut

1600-52845-001

(4) M10 x 25 Flanged Socket Head

Cap Screw

1601-67617-002

M8 Wrench

1102-68064-001

For more information about the components of the RealPresence Group Series Media Center,

refer to the documentation at

http://support.polycom.com/PolycomService/support/us/support/video/group_series/group_packaged_solutions.html.

The Media Center components are heavy. Polycom recommends that two people perform the installation.

www.polycom.com

Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. No portion hereof may be reproduced

or transmitted in any form or by any means, for any purpose other than the recipient’s personal use, without the express written permission of Polycom.

1725-68117-002B

Polycom RealPresence Group Series Media Center Setup Sheet 2

Install the lower display rail by aligning the holes in

the display rail with the holes in the vertical

supports. Attach with four M10 x 25 flanged socket

head cap screws. Do not fully tighten.

Install a lower display rail extension to each side of

the lower display rail using two M8 x 20 button

head cap screws and two M8 hex nuts per side.

Ensure the edge of the rail extension is 3.97 inches

from the inner cut edge of the bottom display rail.

Tighten using the supplied M8 wrench.

Attach an upper display rail extension to each end of the center top display rail using two M10 x 25 flanged

socket head cap screws per extension.

Polycom RealPresence Group Series Media Center Setup Sheet 3

Install the upper display rail assembly by aligning the holes in the display rail with the holes in the vertical

supports. Attach with two M10 x 25 flanged socket head cap screws per vertical support. Do not fully tighten.

Attach the rear panel by inserting the two tabs at the

bottom of the door into the slots in the base. This

serves as an alignment tool to ensure the frame is

properly aligned before tightening all bolts. Using

the L-key, tighten the socket head cap screws at

the bottom of the base, the lower display rail, and

the upper display rail. Remove the rear door.

On the back side, install a handle on both ends

of the bottom display rail.

Polycom RealPresence Group Series Media Center Setup Sheet 4

Install the display mount brackets on the display. For the LG display, position the display mounting bracket

using the sixth hole from the top with the top mounting hole on the display. The bottom hole on the display is

the seventh hole up from the bottom of the bracket.

For the Sampo display, position the third hole down from the top of the display bracket with the third hole

down from the top of the display. The bottom hole on the display lines up with the fifth hole up from the bottom

of the display bracket.

Install the supplied 1/4-20 x 3.5 inch socket head cap screws at the top of each display bracket. Leave the

screws adjusted up before mounting the display to the top rail.

Repeat with the second display.

With the assistance of another person, lift the display and position the display bracket hooks above the edge

of the upper horizontal display rail on the Media Center. Carefully lower the display onto the rail, ensuring the

hooks are fully engaged with the rail and that the outer most bracket is positioned within the safety tab on the

outer rail end (1). Repeat with the second display.

Adjust the leveler screws as needed to help eliminate any gap between the two displays when they are tightly

abutted (2).

Polycom RealPresence Group Series Media Center Setup Sheet 5

Center the displays on the Media Center. Insert one M6 x 16 flanged button head screw into each outer

display bracket to lock the displays.

Power Rating:

Voltage rating: 100-240 VAC, 50/60Hz

Maximum power consumption (configured with Grou

Series 500 codec and EagleEye IV camera under full

load operating conditions):

231.4W with Sampo display

165.4W with LG display

Approximate system weight (including displays,

codec, camera, and sound system):

715 lbs. with Sampo display

689 lbs. with LG display

Regulatory Notices:

This equipment is intended for indoor use only.

Only use this equipment with the displays supplied by

Polycom.

Do not use a power cord that is damaged. This could cause

fire or electric shock. Contact the manufacturer for a

replacement cord, if necessary.

Only use a power cord which is appropriately rated and

approved relevant to the country of use.

This equipment should be used only on even surfaces.

When moving or positioning the system, only use the

handles located at the bottom of the display rail at the rear

of the unit.

This equipment has lockable wheels which should be

applied while the cart is stationary.

When connecting to the mains supply, connect only to an

earthed supply outlet which is installed near the equipment

and is easily accessible.

Keep ventilation openings free from any obstructions.

The ambient operating temperature rating of this equipment

is 0 - 40ºC and should not be exceeded.

Do not immerse the system in any liquid or place any liquids

on it.

Do not spray liquids directly onto the system when cleaning.

Always apply the liquid first to a static-free cloth.

For further information concerning the individual components

of this equipment, please refer to the respective product

literature.

For support or service, please contact your Polycom®

distributor or go to Polycom Support at

www.polycom.com/support.

Autres manuels pour RealPresence Group Series

Table des matières

Autres manuels Polycom Système de conférence

Polycom

Polycom MGC-100 Manuel utilisateur

Polycom

Polycom VSX VSX 6000 Manuel utilisateur

Polycom

Polycom ViaVideo Manuel utilisateur

Polycom

Polycom CX5000 Manuel utilisateur

Polycom

Polycom HDX Series Manuel utilisateur

Polycom

Polycom ViewStation H.323 Manuel utilisateur

Polycom

Polycom RealPresence Group Series Manuel de service

Polycom

Polycom RPX HD 400 Series Comment utiliser

Polycom

Polycom ViaVideo Manuel utilisateur

Polycom

Polycom CX8000 Instructions d'utilisation

Polycom

Polycom QSX Manuel utilisateur

Polycom

Polycom VSX 3000 Manuel utilisateur

Polycom

Polycom MGC+100 ReadiConvene Manuel utilisateur

Polycom

Polycom CX5000 Manuel utilisateur

Polycom

Polycom RealPresence Group Series Comment utiliser

Polycom

Polycom G7500 Manuel utilisateur

Polycom

Polycom CX5000 Guide de configuration rapide

Polycom

Polycom 3000 Manuel utilisateur

Polycom

Polycom realpresence trio 8800 Manuel utilisateur

Polycom

Polycom VSX VSX 6000 Manuel utilisateur

Polycom

Polycom HDX 9001 Instructions d'utilisation

Polycom

Polycom HDX Desktop Systems Guide de référence rapide

Polycom

Polycom VSX Series Manuel utilisateur

Polycom

Polycom Vortex EF2280 Manuel utilisateur

Manuels Système de conférence populaires d'autres marques

Kramer

Kramer VIA GO Manuel utilisateur

AVT

AVT MAGIC AC1 Go Manuel utilisateur

ProSoft Technology

ProSoft Technology AN-X4-AB-DHRIO Manuel utilisateur

Sony

Sony PCS-I150 Manuel utilisateur

Middle Atlantic Products

Middle Atlantic Products VTC Series Manuel utilisateur

Prentke Romich Company

Prentke Romich Company Vanguard Plus Mode d’emploi

Speakerbus

Speakerbus iD 712 Manuel utilisateur

Trelleborg

Trelleborg SafePilot CAT PRO Manuel utilisateur

Sennheiser

Sennheiser ADN Manuel utilisateur

ADTRAN

ADTRAN NetVanta 7100 Manuel utilisateur

AINA

AINA PTT Voice Responder Manuel utilisateur

Yamaha

Yamaha ProjectPhone PJP-100H Manuel utilisateur

vissonic

vissonic VLI Series Manuel utilisateur

Panasonic

Panasonic KX-VC500 Manuel utilisateur

Poly

Poly Trio 8300 Manuel utilisateur

Crestron

Crestron Mercury CCS-UCA-SMK Dessin dimensionnel

Inmarsat

Inmarsat mini M Manuel utilisateur

Tenveo

Tenveo ALL-IN-ONE Manuel utilisateur