4
Ⅶ.Configuration
(1) Temperature System Selection
1.Keep pressing configuration button for more than 3 seconds and then F1 is displayed on LED.
2.Press“+” button once to select Celsius(℃)
3.Press“-”button to select Fahrenheit(℉)
(2)Warning Threshold Value Setup
1.Keep pressing configuration button for more than 3 seconds and then F1 is displayed on LED.
2.Press configuration button once again to display F2
3.Press “+” button once to increase warning threshold value by 0.1℃ each time.
4.Press “-” button to decrease warning threshold value by 0.1℃ each time.
Note: Warning threshold value is between 33.0℃ and 40.0℃,the default value is 37.5 ℃.
(3)Display Mode Switch between Forehead Temperature & Body Temperature.
1.Keep pressing configuration button for more than 3 seconds and then F1 is display on LED.
2.Press configuration button twice to display F3.
3.Press “+” button to display “1”, which means that it will display forehead temperature.
4. Press “-” button to display “0”, which means that it will display body temperature. Note: The display
result of body temperature is based on dynamic compensation working temperature and forehead
temperature.
(4)Integer Offset Value Setup
1.Keep pressing configuration button for more than 3 seconds to display F1 ON LED.
2.Press configuration button three times to display F4.
3.Press “+” to increase warning threshold value by 0.1℃ 4.Press “--” button to
decrease warning threshold value by 0.1℃.
Note: The actual temperature may be adjusted according to the actual measurement distance and measurement
environment, which adjustment range varies between -0.3 ℃ and +0.3℃. For example, the body temperature
result is 35.9℃ in same special environment, while the actual body temperature is 36.6℃.In this case, you may
get the correct result 36.6℃ using the F4 setup value.
(5)Voice identification Setup
1. Keep pressing configuration button for more than 4 seconds and then F5 is display on LED.
2. The “1” symbol showing, press the “—“ button then it transfer to “0” , closing the voice identification.
3. Press “+ “ back to “1 “ symbol and keep the voice identification setting.
(6)Quit Configuration Mode
1.Keep pressing configuration button for more than 3 seconds to display F1 on 4 LED.
2.Press configuration button four times to quit configuration mode.
(7)Battery Replacement
Display: When the signal “Battery” is displayed on LED, it means that the batteries are almost running out power.
Operation: Open battery cover and replace the old batteries with two pieces of new AA-5 alkaline
batteries.
