OPERATION MANUAL LC2000
LC2000 Operation Manual.docx July 8, 2017
PAGE 4
This manual is intended to be used for instruction on operation and basic sensor programming of the
LC2000 using it’s front panel controls, display and optional printer. Much more extensive
programming is available using the TMSComm communications software provided on CD ROM.
SECTION 1 – SYSTEM OVERVIEW
1.0 GENERAL
The LC2000 series Leak and Point Level Alarm Console offers essentially all of the sensor-related
features of the TMS series Tank Management Systems, and will interface to all of the same sensor
model types, including discriminating and non-discriminating electronic or mechanical secondary
containment leak sensors as well as single and multi-point level float sensors. All sensor inputs can
be programmed for either alarm or relay control applications, including time delay, conditional logic
and latching functions for pump/valve controls. Optional printer and numerous communications
options are also supported.
1.1 FRONT PANEL DESCRIPTION
The front panel of the LC2000 is available in four different configurations as listed below:
LC2000-1... Console without display or printer
LC2000-2... Console with display, no printer
LC2000-3... Console with display and internal printer
LC2000-4... Console with display and internal printer w/autowinder
This manual describes operational procedures pertaining to -2, -3, and -4 consoles. The LC2000-1
"Black Box" Remote Acquisition Unit is described in a separate Pneumercator document for operating
the LC2000 using TMS Communicator.
As illustrated in Figure 1-1 below, the LC2000 front panel consists of an array of green, yellow and
red LED indicators for sensor status, power LED, audible alarm annunciator, ultra-bright summary
alarm LED strobe (optional), membrane pushbutton controls, security lock, and optional printer with
or without autowinder.
WARNING
This product is wired to sensors installed in hazardous, explosive environments.
Initial application of AC power to this system should occur only after complete
verification of safe, proper installation by authorized Pneumercator-certified
service personnel. Failure to do so may result in serious injury and/or property
loss.
