3 9499 040 61241
Keys and Displays
Keypad Operation
The unit is programmed by using three keys on the front panel.
The available key functions are listed as following table.
Press and release quickly to increase the value of the displayed parameter.
Press and hold to accelerate increment speed.
Press and release quickly to decrease the value of the displayed parameter.
Press and hold to accelerate decrement speed.
Select the parameter in a direct sequence.
Allow access to more parameters in user menu, also used to Enter manual
mode, auto-tune mode, default setting mode and save calibration data
during calibration procedure.
Select the parameter in a reverse sequence during menu scrolling.
Select the operation Mode in sequence.
Reset the front panel display to a normal display mode, also used to leave
the specific Mode execution and ending the auto-tune and manual control
execution, and quit the sleep mode.
The controller enters the sleep mode if the sleep function ( SLEP ) is enabled
( select YES ).
By entering correct security code to allow execution of engineering programs.
This function is used only in the factory to manage the diagnostic reports.
The user should never attempt to operate this function.
Press
for at least 3 seconds
Press
for at least 6 seconds
Press
Press
Press
Press
Press
for at least 3 seconds
Up Key
Down Key
Scroll Key
Enter Key
Start Record Key
Reverse Scroll Key
Mode Key
Reset Key
Sleep Key
Factory Key
TOUCHKEYS FUNCTION DESCRIPTION
Reset historical values of PVHI and PVLO and start to record the peak
process value.
Front Panel Description
O1
O2
A1
C
Alarm 1
Indicator
Output 2
Indicator
3 Silicone Rubber Buttons
for ease of control setup
and set point adjustment.
Output 1
Indicator
4-digit Display
to display process value,
set point value, menu symbol,
parameter value, control output
value and error code etc.
KS10-I economy PMA
