Pioneer DVR 117D - DVD±RW Drive - IDE Manuel utilisateur

DRIVE INSTALLATION

IN AN INSTANT

Step 1 – Prepare the Computer

1) Turn OFF the computer and disconnect the power cord.

2) Remove the bezel and the open drive bay cover from the computer’s front panel.

Note: Your computer may be a tower

model as shown on the left or a

desktop model as shown below. This

drive works in either PC model style.

Step 2 – Prepare the Drive

3) Attach slide rails to the drive if required for your drive model.

Slide rails are sold separately through computer retailers.

4) Position the drive close to the open computer bay.

Horizontal Installation Vertical Installation

Step 3 – Connect the Cables

5) Connect the power cable from the computer to the drive.

Pay close attention to the polarity of the cable.

6) Connect the IDE cable to the drive.

Confirm that Pin 1 on the drive corresponds to Pin 1 on the cable.

7) Connect the drive’s audio output to the sound card if one is present.

DRIVE INSTALLATION

IN AN INSTANT

Step 4 – Finish the Installation

8) Place the mounting screws in the appropriate holes and tighten by hand.

When mounting screws are loose, vibrations from the spinning disc may cause a ripping sound.

9) Replace the bezel and power ON the computer.

Setting the Jumper For Use in a Master/Slave PC

If you have a Master/Slave type of computer, you probably have two IDE channels, Primary and Secondary. The hard

drive is using the Primary IDE channel and any drives are using the Secondary channel. Install this drive as the Master

device on the Secondary channel and any other devices as Slaves to this new drive. Follow the directions below to

change your older drives or other equipment on the Secondary channel to a Slave device.

1) Disconnect the following drive cables in the order listed below.

Power cable

IDE cable

Audio cable

2) Remove the drive from the drive bay.

3) Use your fingers or a tool to move the jumper to the new setting.

4) Return the drive to the drive bay.

5) Reconnect the cables in the reverse order, Audio, IDE then Power.

Jumper: (jumpered = ON; no jumper = OFF)

Set the jumper to select the drive type for your computer.

Pin Name Function

1 MA on Drive set to Master mode

2 SL on Drive set to Slave mode

3 CS on Drive set to Cable Select mode

4 Reserved

5 Reserved

Master Slave Cable Select

Setting the Jumper For Use in a Cable-Select PC

Some computers support a data exchange method called Cable Select. If your PC uses Cable Select then all devices

need to be set to Cable Select as well. Also, the IDE cable must be designed for Cable Select communication.

Simply position the jumper for Cable Select and install the drive according to the instructions beginning on the opposite

side of this paper. No other changes are required when using Cable Select computers.

Do Not jumper the drive to Cable Select unless your PC uses this method.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Pioneer Lecteur DVD

Pioneer

Pioneer DVD-R7783 Manuel utilisateur

Pioneer

Pioneer DVR-A04 Manuel utilisateur

Pioneer

Pioneer BDR-205 - BD-RE Drive - Serial ATA Manuel utilisateur

Pioneer

Pioneer LaserMemory DVD-117 Manuel utilisateur

Pioneer

Pioneer DCR-111 Manuel utilisateur

Pioneer

Pioneer dvd-u05s Manuel utilisateur

Pioneer

Pioneer DVD-D7563 Manuel utilisateur

Pioneer

Pioneer BDC-TD03RS Manuel du propriétaire

Pioneer

Pioneer DVR-112D - DVD±RW Drive - IDE Mode d’emploi

Pioneer

Pioneer DVR-212 Manuel utilisateur

Pioneer

Pioneer LaserMemory DVD-A05S Manuel utilisateur

Pioneer

Pioneer DVR-112D Manuel utilisateur

Pioneer

Pioneer DVR-110DBKU Manuel utilisateur

Pioneer

Pioneer DVD-103S Manuel utilisateur

Pioneer

Pioneer DVR-115DBK Manuel utilisateur

Pioneer

Pioneer DVD-R7322 Manuel utilisateur

Pioneer

Pioneer DVR 117D - DVD±RW Drive - IDE Manuel utilisateur

Pioneer

Pioneer DVR-109 Manuel utilisateur

Pioneer

Pioneer DVR-116D Manuel utilisateur

Pioneer

Pioneer DVR-1910LS - DVD±RW / DVD-RAM Drive Manuel utilisateur

Pioneer

Pioneer LaserMemory DVD-U03S Manuel utilisateur

Pioneer

Pioneer DVR-710 Manuel d'installation

Pioneer

Pioneer DVR-2810 Manuel

Pioneer

Pioneer LaserMemory DVD-115 Manuel utilisateur

Manuels Lecteur DVD populaires d'autres marques

Panasonic

Panasonic CFVDM732U - DVD Manuel utilisateur

LG GSA-4160B Manuel utilisateur

Panasonic

Panasonic VW-BN1 - DVD-RW / DVD-RAM Drive Manuel utilisateur

Sony

Sony DRU-500AX Manuel utilisateur

LG GSA-2164D Manuel utilisateur

Plextor

Plextor PX-755SA Manuel utilisateur

Samsung

Samsung SM-332B Manuel utilisateur

Freecom

Freecom MOBILE DVD RW II Manuel utilisateur

Plextor

Plextor PX-712 Manuel utilisateur

NEC

NEC ND-3550A Manuel utilisateur

Emprex

Emprex Slim Writer DVD R/RW USB 2.0 External Drive Manuel utilisateur

Philips

Philips PCA532K Manuel utilisateur

Sony

Sony AD-7740H Manuel utilisateur

Philips

Philips PCDV5016 Series Guide de référence

Samsung

Samsung SE-S224Q Manuel utilisateur

IBM

IBM 71P7285 Manuel utilisateur

IBM

IBM 27L2579 Manuel utilisateur

Samsung

Samsung SH-D162D Manuel utilisateur