Pioneer DRM-600 Manuel utilisateur

Attaching Pioneer CD-ROM Drives to Computers Running Windows95

August 1995

Windows95 operating system contains built in drivers for Pioneer's DRM-624X, DRM-604X, DRM-602x and

DRM-600 CD-ROM drives. These drivers also support the Pioneer DR-U124X. Users can connect the

Pioneer CD-ROM drives following the instructions below, Power ON the computer with Windows95 loaded

and separate icons with assigned drive letters will be visable in My Computer window for each CD-ROM

tray available.

Installing a Pioneer CD-ROM Drive

Note: If a Pioneer CD-ROM Drive has been connected to your system under DOS or Windows 3.x remove

old Pioneer Drivers from the system before installing Windows95.

The follow these steps to use your Pioneer CD-ROM drive in Windows95:

1. If you are newly installing a SCSI controller card, Windows95 should automatically detect

the card on boot up. See the Windows95 User's Manual for information about installing

new cards. Also, refer to Troubleshooting, point #1 in this document.

2. After you have confirmed that the SCSI controller card is properly installed, power down

the Pioneer CD-ROM drive and the computer system. Securely attach the SCSI cable

between the drive and the SCSI controller in the computer.

3. If the Pioneer drive is the last devicve in the SCSI chain, make sure it is terminated.

DRM-624X Termination ON = DIP SW 2 UP

DRM-604X Termination ON = Set separate Termination Switch ON

DRM-602X Termination ON = DIP SW 2 UP

DR-U124X Termination ON = DIP SW 5 (from right to left) not Jumpered

Note: All units can be easily terminated by using an External Terminator Block and

turning the internal termination switch OFF.

If the Pioneer Drive is in the middle of the SCSI Chain, make sure termination is OFF.

The last device on the SCSI chain and the SCSI controller card must be terminated. If

you also have an internal SCSI device connected to the controller, disable termination on

the controller.

4. Verify that each SCSI device is set to a unique SCSI ID address.

5. Power ON the Pioneer CD-ROM drive.

6. Power ON the computer running Windows95.

7. On boot-up you will see the floppy drives, hard drives and CD-ROM drive icons appear

under the "My Computer" window. One icon will appear for each CD-ROM disc installed in

the Pioneer CD-ROM drive.

Troubleshooting

If the CD-ROM icon fails to appear in "My Computer" window after launching under Windows95"

1. Check for SCSI Card Conflicts

If after following the steps to connect the Pioneer CD-ROM drive, the CD-ROM drive icons are not

visable on boot-up, check for SCSI card conflicts.

Follow this path:

My Computer / Control Panel / System / Device Manager / SCSI Controllers

Select the SCSI controller you have installed, then select "Properties" and the click on "Resources".

This will allow you to check information about the SCSI card, such as:

I/O Address (Input/Output Address)

IRQ Address (Interrupt Request Address)

DMA Address (Direct Memory Access)

A box in the lower portion of the window will indicate if the address is conflicting with the address of

another card. If this is the case, please refer to the manual that ships with the SCSI controller card or

other cards you have installed and changed the conflicting address. Note: The address must be

physcially changes on the card or by using software provided by the card manufacturer.

If Windows95 launches but does not recognize the SCSI controller card, you may want to select:

My Computer / Control Panel / Add New Hardware / SCSI Controllers / Resources

Make sure all setting's for the card match those physically set on the card and that there are no

conflicts.

Note: Only use "Add New Hardware" to check information about SCSI controllers. Do not use it as

part of the installation process for the CD-ROM drive. Pioneer's CD-ROM drive is not considered "New

Hardware" belonging to the computer.

2. Check Hardware

Verify the Integrity of the SCSI Chain:

1. Power down the computer and CD-ROM drive.

2. Verify the CD-ROM drive has been assigned it's own unique SCSI ID.

3. Check that the SCSI cables are securely attached.

4. Make sure the last device on the SCSI chain is terminated.

5. If the CD-ROM drive is in the middle of the chain it must be un-terminated.

6. Run a self test on the unit the unit to make sure it is functioning properly.

7. Refer to bulletin on running self test.

8. Verify that the CD-ROM discs are properly loaded into the drive.

9. Make sure the discs are loaded shiny side up in the DRM-624X/604X/602X.

10. Disc should be loaded shiny side down in the DR-U124X.

For the name of the closest Authorized Pioneer Service Center, contact Pioneer Electronic Service:

800-872-4159

Table des matières

Autres manuels Pioneer Lecteur CD/CDR

Pioneer

Pioneer DR-U104X Manuel utilisateur

Pioneer

Pioneer DVR-112 Manuel utilisateur

Pioneer

Pioneer BDR-S13UBK Manuel utilisateur

Pioneer

Pioneer LaserMemory DR-744 Manuel utilisateur

Pioneer

Pioneer BDR-XS07TUHD Manuel utilisateur

Pioneer

Pioneer BDR-XS07UHD Manuel utilisateur

Pioneer

Pioneer BDR-X13EBK Manuel utilisateur

Pioneer

Pioneer BDR-2207 Manuel utilisateur

Pioneer

Pioneer DR-UA124X-2 Manuel utilisateur

Pioneer

Pioneer BDR-212UBK Manuel utilisateur

Pioneer

Pioneer DVR-S201 Manuel utilisateur

Pioneer

Pioneer DR-R102 Manuel utilisateur

Pioneer

Pioneer LaserMemory DR-5045 Manuel utilisateur

Pioneer

Pioneer DVR-117D Manuel utilisateur

Pioneer

Pioneer BDR-212DBK Manuel utilisateur

Pioneer

Pioneer BDR-XD08B Manuel utilisateur

Pioneer

Pioneer BDR-X13E-S Manuel utilisateur

Pioneer

Pioneer BDR-XS07TS Manuel utilisateur

Pioneer

Pioneer DR-R7181 Manuel utilisateur

Pioneer

Pioneer DR-U124X-7 Manuel utilisateur

Pioneer

Pioneer DR-944 Manuel utilisateur

Pioneer

Pioneer DR-704S Manuel utilisateur

Pioneer

Pioneer DVR-111D Manuel utilisateur

Pioneer

Pioneer DR-504S Manuel utilisateur

Manuels Lecteur CD/CDR populaires d'autres marques

Philips

Philips CDD3610 Manuel utilisateur

QPS

QPS Que!Fire Manuel utilisateur

LG GCC-4241N Manuel utilisateur

Plextor

Plextor 12X-3 Mode d’emploi

Samsung

Samsung SN-324B Manuel utilisateur

Teac

Teac CD-211E Manuel utilisateur

SmartDisk

SmartDisk Firewire CD-R/W Manuel utilisateur

Axis

Axis CD-ROM SERVER Manuel utilisateur

LG CRD-8322B Manuel utilisateur

Memorex

Memorex 32023234 - 52x32x52x External USB2.0 CD... Instructions d'installation

Yamaha

Yamaha CD Recordable/Rewritable Drive CRW3200 Manuel utilisateur

Sony

Sony CRX230AE Manuel utilisateur

Sony

Sony CRX - 160E Manuel utilisateur

Panasonic

Panasonic KX-LD742 Manuel utilisateur

Panasonic

Panasonic LK-MC606BP Manuel utilisateur

Panasonic

Panasonic CF-VCW Series Manuel utilisateur

LG CRD-8320B Manuel utilisateur

Conner

Conner CFP2107 Series Manuel utilisateur