4
•Selective input response: 10 / 500ms
•Tamper protection: Back + cover
LED INDICATION
•Upon successful learning: short flash sequence
•Normal operation: brief light upon transmission
•Low battery: short flash sequence during transmission
OPERATING MODE
The DCM reports events from IN2 and from the magnetic reed switch. In normal
operation mode, an alarm is sent when the input or magnet are triggered. When
restored, it transmits a restoral message.
NOTE: If configured as Roller Shutter, the magnetic reed switch will not function.
INSTALLATION
Step 1: Battery Insertion
1. Remove the front cover (Fig. 1-1 to 1-5).
2. Remove battery from the insulation material and reinsert it into the transmitter,
paying attention to the polarity (Fig. 1-6).
Step 2: Enrolling the DCM in the System
1. For complete description of the wireless configuration and device enrollments,
refer to Programming Guide for the FORCE and VISION Alarm Systems
2. Enrollment of the DCM in the system can be performed manually or automatically
via the keypad.
Auto Enrolling (using RF Communication):
1. Enter Installer menu, and select: System Configuration > Peripherals > Wireless
Peripherals > Enroll and delete > Detectors >Enroll >Auto Enrollment
2. Send an enrollment message by pressing the front tamper switch (without
detaching back bracket) for at least 3 seconds. The serial number should appear in
the keypad.
3. Select Enroll and press.
Manual Enrolling:
1. Enter Installer menu, and select: System Configuration > Peripherals > Wireless
Peripherals > Enroll and delete > Detectors >Enroll >Manual Enrollment
2. Enter the serial number and press .
3. Select Enroll and press .
Enrolling using the Force Manager Software:
For information about enrolling the DCM using the Force Manager software, refer to
the Force Manager Manual.
