Model 510/511
Operating Instructions
Model 510/511 Configuration
Model 510/511 Configuration Menu
AutoOff ON(default)/OFF
If Auto Off is ON, the unit will turn off after 30 minutes to save battery life, if there is no user activity. If
Auto Off is OFF the unit will stay on until it is turned off from the keypad. This is typically useful for
Display Units °C (default)/°F
{rtdty
0: The RTD type is fixed as
ordered from the factory and cannot be
hanged.
{rtd ty
efault), Pt100 α=3902, Pt100
α=3916, Pt100 α=3926, Cu10 α=427, Ni110 Bristol,
press
vailable types. Press again to save and
return to the configuration menu.
{rtd ty
efault), Pt100 α=3902, Pt100
α=3916, Pt100 α=3926, Cu10 α=427, Ni110 Bristol,
Ni120 α=672, Ω
manual loading or continuous use.
Pressing the EZ-DialKnob to toggles between °C or °F
RTD
Model 51
pe}
pe} is one of:
Pt100 α=3850 (d
c
Ni120 α=672, Ω
Model 511: To change RTD type,
the EZ-DialKnob. Turn the EZ-Dial
Knob to scroll through the list of
a
pe} is any of:
Pt100 α=3850 (d
EZ-Dial™ Knob
Turning the EZ-DialKnob to adjust the output up or down. Fine adjustments can be made by turning the
EZ-DialKnob. Coarse adjustments can be made by pressing and turning the EZ-Dial™. New values can
e stored into the HI and LO EZ-Check™ positions by pressing down on the EZ-DialKnob until “STORED”
is indicated on the display.
b
EZ-Check™ Switch
The EZ-Check™ Switch has three positions: HI, DIAL, and LO. Its position is shown at the left edge of the
display with “HI” and “LO” indicators. The output is adjustable in all three positions. The EZ-Check™
witch allows user-selected values to be stored in the HI and LO positions when used in combination with
To stor
positions.
2. Press down on the EZ-DialKnob until the confirmation message “STORED” appears.
iously set EZ-Check™ positions, the DIAL position always
calls the last output value it was dialed to. The HI and LO positions will recall the last STORED value,
lt. This
ctile feature allows continuous monitoring of the device being calibrated without looking back at the
odel 510/511 display. This is also useful in poor lighting or under difficult operating conditions.
S
the EZ-DialKnob.
e new EZ-Check™ value(s):
1. Dial the display to match the desired stored outputs for the HI or LO
3. Recall the values by moving the switch between HI, DIAL, and LO.
Operational description: When returning to prev
re
NOT the last output value it was last dialed to.
Hint: For faster calibrations, the product has been designed so the position of the switch can be fe
ta
M
841
Holt
Road
#1
•Webster, NY 14580 Tel: 585-872-9350 •Fax: 585-872-2638 [email protected] •http://www.piecal.com/Practical Instrument Electronics, Inc. Copyright 2003. All rights reserved. 510/511-9002 2/25/04 2-4
