Phoenix DryTAG RH Manuel utilisateur
USEPHOENIX.COM |800-533-7533
DRYTAG RH INSTALLATION INSTRUCTIONS
Setting Up Your DryTAG RH
1. Using the two screws near the battery pull tab using a Phillips #1.
2. Remove the battery pull tab and discard.
3. Tighten the two screws.
4. Follow instructions on TS- 1131 to add the DryTAG RH to DryLINK.
5. After installation onto equipment (see below), check that equipment shows as “on” within
DryLINK.
Installing Onto Equipment
General
The DryTAG RH can be mounted with cable ties or screws. We recommend using cable ties.
STEP MOUNTING INSTRUCTIONS
1Ensure the dehumidifier is unplugged.
2Remove lay-flat duct ring.
3Using a T20 Torx screwdriver, remove
the 4 screws securing the outlet grill in
place.
4Remove grill.
DRYTAG RH MOUNTING INSTRUCTIONS
Mounting DryTAG RH on a Phoenix R250
STEP MOUNTING INSTRUCTIONS
5Place DryTAG RH on the grill as shown.
6Thread zip ties through the slots in the
DryTAG RH.
7Pull each end of the zip ties through the
holes in the grill.
8Secure zip ties.
DRYTAG RH MOUNTING INSTRUCTIONS
Mounting DryTAG RH on a Phoenix R250
STEP MOUNTING INSTRUCTIONS
9Using a side cutter, trim off excess.
10 Re-install grill onto unit.
11 Re-install screws.
12 Re-install lay-flat duct ring.
DRYTAG RH MOUNTING INSTRUCTIONS
Mounting DryTAG RH on a Phoenix R250
USEPHOENIX.COM |800-533-7533
DRYTAG RH MOUNTING INSTRUCTIONS
STEP MOUNTING INSTRUCTIONS
9Install complete.
Mounting DryTAG RH on a Phoenix R250
Table des matières
Autres manuels Phoenix Régulateurs de température
Manuels Régulateurs de température populaires d'autres marques
Swegon
Swegon LUNAd MB Manuel utilisateur
Lucky Reptile
Lucky Reptile Thermo Control II Manuel utilisateur
SENSORMETRIX
SENSORMETRIX Argon 100 Manuel utilisateur
Fuji Electric
Fuji Electric PXE4 Manuel utilisateur
Yuyao gongyi
Yuyao gongyi XMT-808 series Manuel utilisateur
Selec
Selec TC544C Manuel utilisateur
