Philips CSP620 Manuel utilisateur

EN User manual

CSP620 CSP6920

www.philips.com/welcome

a b

Amplifier

Right White lined White lined

Right

Left

Black

Left

CSP620

CSP6920

f g

English

1. Important

Safety

Read and understand all instructions before you use the apparatus.•

If damage is caused by failure to follow instructions, the warranty does

not apply.

Use only the supplied mounting hardware for a safe and secure•

installation.

Do not continuously use the speaker system beyond the peak power•

handling capacity.

Keep credit cards, watches, recorded tapes etc. with magnetic coding•

away from the speaker system to prevent damage caused by the

magnets in the speakers.

Clean the apparatus with soft, damp cloth. Never use substances such•

as alcohol, chemicals or household cleaners on the apparatus.

Notice

Environmental information

All unnecessary packaging has been omitted. We have tried to make

the packaging easy to separate into three materials: cardboard (box),

polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)

Your system consists of materials which can be recycled and reused if

disassembled by a specialized company. Please observe the local regulations

regarding the disposal of packaging materials, exhausted batteries and old

equipment.

Any changes or modications made to this device that are not expressly

approved by Philips Consumer Lifestyle may void the user’s authority to

operate the equipment.

Specications are subject to change without notice. Trademarks are the proper ty of Koninklijke Philips

Electronics N.V. or their respective owners. Philips reserves the right to change products at any time

without being obliged to adjust earlier supplies accordingly.

2.Your car stereo speakers

Congratulations on your purchase, and welcome to Philips!

To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

Introduction

With the speakers, you can enjoy high power music with vivid sound.

What’s in the box A

Check and identify the contents of your package:

aSpeakers (x2)

bGrille net + Frame (x2)

cSpeaker wire (x2)

dScrew (x8)

eShrapnel (x8)

3. Installation

A depth of at least 46mm is required to mount the speaker. Measure the

depth of the area where you are to mount the speaker, and ensure that

the speaker does not obstruct any other components of the car.

Option 1: Mount on door (front or rear) B

You can mount the speakers on the front/rear door of your car. a

Note

•Make sure that nothing obstructs around the mounting location of the door.

A hole for mounting may already be cut out of the inner panel of the door

•

(front or rear). In this case, you need to modify the board only.

Ensure that the speaker terminals, frame or magnet do not interfere with any

•

inner parts, such as the window mechanism in the door (when you open or

close the window), etc. Also ensure that the speaker grille does not touch any

inner ttings, such as the window cranks, door handles, arm rests etc.

1 Turn off the car ignition key.

If the power is on, the click noise generated by the connection

•

may damage the speakers.

2Cut out the mounting template from the packing box.

3Paste the template on the location selected for mounting the

speaker.

4Mark the cut-off hole and the 4 bolt holes. b

5Cut out the marked area and drill the bolt holes. c

6Remove the grille net. d

7 Strip the speaker wires and connect them to the amplier. e

Black wire: connect to “-“ (negative) terminal

•

Black (white lined): connect to “+“ (positive) terminal

•

Note

Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may

•

degrade sound quality.

Two 4-ohm speakers, wired in stereo, present a 8 ohm load to each channel

•

of the amplier. Most two channel ampliers work well in this conguration.

However, if two 4-ohm speakers, wired in parallel to a bridged two -channel

amplier, present a 2-ohm mono load to the amplier. Most 2-channel ampliers

do not support 2-ohm mono operation! Amplier damage may result!

8Mount on the speaker as shown below. f

9Press and insert the edges of the grille net. g

Tip

The speaker grille can be mounted without the grille net, if you like.

•

Option 2: Mount on rear tray C

You can also mount the speakers into the surface of the rear tray.

Follow the steps in section “Option 1: Mount in door” to mount the

speakers into the rear tray:

4. Product information

Note

Product information is subject to change without prior notice.•

Model CSP620 CSP6920

Speaker type 16.5cm, 3-way triaxial

speaker

16x24cm, 5-way coaxial

speaker

RMS power (Watts) 80W 80W

Peak music power (Watts) 400W 480W

Sensitivity (dB/W/m) 90dB 91dB

Frequency response (Hz) 35-32kHz 27-33kHz

Impedance (ohms) 4 ohms 4 ohms

Magnet mass (Oz) 8.6Oz 22Oz

Mounting depth (mm) 59mm 88.1 mm

5.Troubleshooting

To keep the warranty valid, never try to repair the system yourself.

If you encounter problems when using this apparatus, go to the Philips

web site (www.philips.com/welcome). When you contact Philips, ensure

that the apparatus is nearby and the model number and serial number

are available.

CSP620_51_UM_V2.0

Autres manuels pour CSP620

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Philips Intervenants

Philips

Philips BT6000 Manuel utilisateur

Philips

Philips MMS8085B/94 Manuel utilisateur

Philips

Philips SPA2210V Fiche d'information produit

Philips

Philips EverPlay BT3900 Manuel utilisateur

Philips

Philips 2000 series Manuel utilisateur

Philips

Philips CSS2123/05 Manuel utilisateur

Philips

Philips SBCBC250/05 Manuel utilisateur

Philips

Philips HTL3160B/96 Manuel utilisateur

Philips

Philips HTL2153B Manuel utilisateur

Philips

Philips HTL2160C/G/M/S/T/W/12/F7/93 Manuel utilisateur

Philips

Philips SPA1330 Manuel utilisateur

Philips

Philips CSS5123/12 Manuel utilisateur

Philips

Philips SPA3300 Manuel utilisateur

Philips

Philips Fidelio DS3880W/10 Manuel utilisateur

Philips

Philips HTL3120 Manuel utilisateur

Philips

Philips TANX20 Manuel utilisateur

Philips

Philips SPA4270BT Manuel utilisateur

Philips

Philips HTL5110/F7 Manuel utilisateur

Philips

Philips MMS322 Manuel utilisateur

Philips

Philips HTL4110B Manuel utilisateur

Philips

Philips AW5000 Manuel utilisateur

Philips

Philips HTL2160 Manuel utilisateur

Philips

Philips SPA2300 Manuel utilisateur

Philips

Philips HTL2101A Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur