Philips Premium GC4440 Manuel utilisateur

Steam Iron

GC4440, GC4430, GC4420, GC4410

ENGLISH 6

DEUTSCH 17

NORSK 29

SVENSKA 40

SUOMI 51

DANSK 62

GC4440, GC4430, GC4420, GC4410

General description

ASpray nozzle

BCap of filling opening

CSteam boost

DSpray button

ESteam control

FIonic steam button (GC4440/GC4430)

GIonic steam light (GC4440/GC4430)

HTemperature dial

IAmber temperature light (GC4420/GC4410) and red automatic

shut-off (AUTO/OFF) indication (GC4420 only)

JAmber temperature light and red automatic shut-off (AUTO/OFF)

indication (GC4440/GC4430)

KMains cord

LType plate

MSoleplate

NCalc-Clean button

Not shown: Heat-resistant protective cover (GC4440 only)

Important

Read these instructions for use carefully before using the appliance and

save them for future reference.

◗Check if the voltage indicated on the type plate corresponds to

the local mains voltage before you connect the appliance.

◗Only connect the appliance to an earthed wall socket.

◗Do not use the appliance if the plug, the cord or the appliance

itself shows visible damage, or if the appliance has been dropped

or is leaking.

◗Check the cord regularly for possible damage.

◗If the mains cord is damaged, it must be replaced by Philips, a

service centre authorised by Philips or similarly qualified persons

in order to avoid a hazard.

◗Never leave the appliance unattended when it is connected to

the mains.

◗Never immerse the iron and the stand, if provided, in water.

ENGLISH6

◗Keep the appliance out of the reach of children.

◗The soleplate of the iron can become extremely hot and may

cause burns if touched.

◗Do not allow the cord to come into contact with the soleplate

when it is hot.

◗When you have finished ironing, when you clean the appliance,

when you fill or empty the water tank and also when you leave

the iron even for a short while: set the steam control to position

0, put the iron on its heel and remove the mains plug from the

wall socket.

◗Always place and use the iron and the stand, if provided, on a

stable, level and horizontal surface.

◗This appliance is intended for household use only.

Before first use

1Remove any sticker, protective foil or plastic from the soleplate.

2Rinse and clean the filling cup.

BThe iron may give off some smoke when you use it for the first time.

This will cease after a short while.

Preparing for use

Filling the water tank

1Make sure the appliance is unplugged.

2Set the steam control to position 0 (= no steam) (fig. 2).

3Open the cap of the filling opening.

4Tilt the iron backwards and fill the water tank with tap water up

to the maximum level by means of the filling cup (fig. 3).

Do not fill the tank beyond the MAX indication.

Do not put perfume, vinegar, starch, descaling agents, ironing aids or

other chemicals in the water tank.

ENGLISH 7

◗If the tap water in your area is very hard, we advise you to mix it

with an equal portion of distilled water, or to use distilled water

only.

5Close the cap of the filling opening ('click') (fig. 4).

Setting the temperature

1Type GC4440 only: remove the heat-resistant protective cover

(fig. 5).

Do not leave the heat-resistant protective cover on the soleplate

during ironing.

2Put the iron on its heel and set the required ironing temperature

by turning the temperature dial to the appropriate position (fig. 6).

-1Synthetic fabrics (e.g. acrylic, nylon, polyamide, polyester)

-1Silk

-2Wool

-3Cotton

- MAX linen

If you do not know what kind or kinds of fabric an article is made of,

determine the right ironing temperature by ironing a part that will not

be visible when you wear or use the article.

Silk, woollen and synthetic materials: iron the reverse side of the fabric

to prevent shiny patches.Avoid using the spray function to prevent

stains.

Start ironing the articles that require the lowest ironing temperature,

such as those made of synthetic fibres.

3Put the mains plug in an earthed wall socket.

◗The amber temperature light goes on (fig. 7).

4When the amber temperature light has gone out, wait a while

before you start ironing.

The temperature light will go on from time to time during ironing.

ENGLISH8

Using the appliance

Steam ironing

1Make sure that there is enough water in the water tank.

2Select the recommended ironing temperature (see chapter

'Preparing for use').

3Select the appropriate steam setting. Make sure that the steam

setting you select is suitable for the ironing temperature selected:

(fig. 8).

- 1 - 3 for moderate steam (temperature settings 2to 3)

- 4 - 6 for strong steam (temperature settings 3to MAX)

BThe iron will start steaming as soon as the set temperature has been

reached.

BIf the selected ironing temperature is too low (MIN to 2) water may

drip from the soleplate (see section 'Drip stop').

Ironing with Ionic DeepSteam (GC4440/GC4430 only)

When you use the ionic function during steam ironing, the steam

produced will be finer than during regular steam ironing. Fine steam

penetrates deeper into the fabric.This helps you to easily remove

stubborn creases.

1Follow steps 1 to 3 in section 'Steam ironing'.

2Switch the ionic function on by pressing the ionic steam button

('click') (fig. 9).

◗The ionic steam light goes on and you will hear a humming sound

(fig. 10).

3You can now start ionic steam ironing.

◗The humming sound automatically stops when you put the iron

on its heel, although the ionic function stays on.

4To deactivate the ionic function, press the ionic steam button

again ('click').You will continue ironing with normal steam.

ENGLISH 9

BThe ionic function is only effective when it is used in combination with a

steam setting and a temperature setting between 2and MAX.

Switch off the ionic steam function when ironing without steam and/or

at low temperature settings. However, ironing at low temperatures

without steam with the ionic function switched on will not damage the

iron.

BThe ionic steam output may vary from time to time, depending on the

ironing temperature.

Ironing without steam

1Set the steam control to position 0 (= no steam) (fig. 2).

2Make sure the ionic function is off.

3Select the recommended ironing temperature (see chapter

'Preparing for use').

Features

Spray function

You can use the spray function to remove stubborn creases at any

temperature.

1Make sure that there is enough water in the water tank.

2Press the spray button several times to moisten the article to be

ironed (fig. 11).

Concentrated steam boost from the special SteamTip

A shot of steam from the soleplate helps remove stubborn creases.The

steam boost enhances the distribution of steam into every part of your

garment.

The steam boost function can only be used at temperature settings

between 2and MAX.

1Press and release the steam boost button (fig. 12).

ENGLISH10

Autres manuels pour Premium GC4440

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Fer

Philips

Philips GC2980 Manuel utilisateur

Philips

Philips GC9620 Manuel utilisateur

Philips

Philips GC4884 Manuel utilisateur

Philips

Philips GC92 series Manuel utilisateur

Philips

Philips GC8952-30 Manuel utilisateur

Philips

Philips CompactCare GC6500 Series Manuel utilisateur

Philips

Philips GC8700 series Manuel utilisateur

Philips

Philips Powerlife Plus GC2982/30 Manuel utilisateur

Philips

Philips Azur GC4233 Manuel utilisateur

Philips

Philips HD1173 Manuel utilisateur

Philips

Philips GC4430/02 Manuel utilisateur

Philips

Philips HD1301/02 Manuel utilisateur

Philips

Philips EasyCare GC8330 Manuel utilisateur

Philips

Philips RI3620/12 Manuel utilisateur

Philips

Philips GC9500 Series Manuel utilisateur

Philips

Philips Premium GC4440 Manuel utilisateur

Philips

Philips GC9500 Series Manuel utilisateur

Philips

Philips GC8600 Series Manuel utilisateur

Philips

Philips Perfect Care Elite Plus GC9660 Manuel utilisateur

Philips

Philips GC9612/21 Manuel utilisateur

Philips

Philips GC6704 FastCare Compact Manuel utilisateur

Philips

Philips HI228/22 Manuel utilisateur

Philips

Philips sGC4711/07 Manuel utilisateur

Philips

Philips Intellicare GC8030 Manuel utilisateur

Manuels Fer populaires d'autres marques

Clatronic

Clatronic DB 3703 Manuel utilisateur

TEFAL

TEFAL FV4093Z0 Manuel utilisateur

Gorenje

Gorenje SIH 2200 BS Manuel utilisateur

Bosch

Bosch 2 Series Manuel utilisateur

Riffel

Riffel Catena KB-819 Manuel utilisateur

Texi

Texi Hestia Manuel utilisateur

Maxwell

Maxwell MW-3010 Manuel utilisateur

TREVIDEA

TREVIDEA Girmi ST60 Manuel utilisateur

Primula

Primula Vapormat Manuel utilisateur

Magio

Magio MG-541 Manuel utilisateur

Scarlett

Scarlett SC-1334S Manuel utilisateur

Bosch

Bosch Sensixx B22L Manuel utilisateur

Vitek

Vitek VT-1247 VT Manuel utilisateur

Cleanmaxx

Cleanmaxx 3397 Manuel utilisateur

dyras

dyras ESI-2400AC Manuel utilisateur

GE 169061 Manuel utilisateur

Gorenje

Gorenje SIH 2200 GC Manuel utilisateur

AEG

AEG DBS 5591 Manuel utilisateur