Philips GC6028/03 Manuel utilisateur

Provapor GC6026,6024,6022,6020,6019

G I HJ

ENGLISH 6

DEUTSCH 14

FRANÇAIS 23

NEDERLANDS 32

ESPAÑOL 40

ITALIANO 49

PORTUGUÊS 58

NORSK 67

SVENSKA 75

SUOMI 83

DANSK 91

 99

GC6026,GC6024,GC6022,GC6020,GC6019

General description

A) Cap of the steam tank

B) Steam tank

C) Iron stand

D) On/off switch with built-in pilot light

E) 'Steam tank heating up' pilot light (types GC6024/6026 only).The

pilot light goes out when the appliance is ready for steam ironing

F) Steam control (types GC6024/6026 only).q= moderate steam

R= maximum steam

G) Temperature pilot light

H) Steam activator button

I) Temperature control

J) Supply hose

K) Soleplate

L) Mains cord

M) Anti-calc funnel (type GC6026 only)

N) Shot of steam (type GC6026 only)

Important

For optimal safety,read these instructions carefully and look at the

illustrations before you start using the appliance.

- Do not put perfume,vinegar,descaling agents or other chemicals in

the water tank.

- Never use the appliance if it is damaged in any way.Regularly check if

the mains cord and the supply hose are still undamaged and safe.

- If the mains cord of this appliance is damaged,it must always be

replaced by Philips or a service centre authorised by Philips,as

special tools and/or parts are required.

- Do not use any other cap on the steam tank than the cap that has

been supplied with the appliance,as this cap also functions as a safety

valve.

- Check if the voltage indicated on the bottom of the steam tank

corresponds to the mains voltage in your home before you connect

the appliance.

- Only connect the appliance to an earthed wall socket.

- Never immerse the iron or the steam tank in water.

- Never leave the iron unattended when it is connected to the mains.

- When you have finished ironing and even when you leave the iron

for a short while,unplug the iron and put it on the iron stand.

- Always place the steam tank on a stable,level and horizontal surface.

Do not put the steam tank on the soft part of the ironing board.

- Always place the iron on the iron stand or on its heel.Do not put

the hot iron on the supply hose or the mains cord.Make sure the

cord does not come into contact with the hot soleplate.

- The iron stand and the soleplate of the iron can become extremely

hot and may cause burns if touched.If you want to move the steam

tank,do not touch the stand.

- Do not allow the cord to come into contact with the hot soleplate.

ENGLISH6

- Infirm persons should not be allowed to use the appliance without

supervision.Keep an eye on children to make sure that they do not

play with the appliance.

- If steam escapes from under the steam tank cap when the appliance

is heating up,switch the appliance off and contact a service centre

authorised by Philips.

- Do not remove the cap from the steam tank when the steam tank is

under pressure.Follow the instructions under 'Fast refill'.

Preparing the appliance for use

1Check if the voltage indicated on the type plate corresponds to

the mains voltage in your home.

2Remove any sticker or protective foil from the soleplate and

clean the soleplate with a soft cloth.

3Fully unwind the mains cord (L) and supply hose (J).

4Place the steam tank (B) on a stable,level surface.

5Place the iron on the iron stand (C).

Filling the steam tank

Never immerse the steam tank in water.

1Make sure the on/off switch (D) has been set to 'off' and

remove the plug from the wall socket.

C2Slowly unscrew the cap (A) of the steam tank.

You may hear a sound when you remove the cap.This sound is caused

by the cold tank being under vacuum.This is perfectly normal.

3Pour water into the steam tank (max.1 litre).

Use cold tap water to fill the tank up to the maximum level.

If the tap water in your area is very hard, we advise you to mix tap

water with an equal portion of distilled water,or to use distilled water

only.

Do not use perfume,vinegar, starch or chemically descaled water.

4Screw the cap onto the filling aperture of the steam tank.

ENGLISH 7

Fast refill

C1First set the on/off switch (D) to 'off'.

2Press the steam activator button until you no longer hear any

steam escaping from the appliance.

3Keep the steam activator button pressed in and slowly unscrew

the cap of the steam tank by turning it anti-clockwise.This will

depressurise the steam tank.

4Remove the mains plug from the wall socket.

5Fill the steam tank as described in section 'Filling the steam

tank' and let the appliance heat up again.

Setting the temperature

Always place the steam tank on a stable,level and horizontal surface

Do not put the steam tank on the soft part of he ironing board.

Always place the iron on the iron stand or on its heel.Do not put the

hot iron on the supply hose or the mains cord.Make sure the cord

does not come into contact with the hot soleplate.

C1Set the temperature dial to the required ironing temperature

by turning it to the appropriate temperature indication.

- Check the garment label for the required ironing temperature:

-1Synthetic fabrics (e.g.acrylic,viscose,polyamide, polyester)

-1Silk

-2Wool

-3Cotton,linen

- When you do not know what kind of fabric the article is made of,

try to iron a spot which will be invisible when you wear it.

ENGLISH8

Steam control

Temperature

dial

Type of fabric

Synthetic fabrics,e.g.acetate,

acrylic,viscose,polyamide,

polyester, and silk

Wool

Cotton,linen

Please note:Zin the table

means that the article cannot

be ironed.

Label with

ironing

instructions

- Silk,woollen and synthetic materials:iron the reverse side of the

fabric to prevent shiny patches.

- Start ironing the articles that require the lowest ironing temperature,

such as those made of synthetic fibres.

C2Put the plug in the wall socket and let the appliance heat up by

setting the on/off switch (D) to 'on'.

3The steam tank and the soleplate will now be heated up.

Heating up of the soleplate takes approx.2 minutes and heating

up of the steam tank takes approx.8 minutes.

4Types GC6024/6026 only:As soon as the steam tank is hot

enough for steaming,the pilot light (E) will go out.You can now

start ironing.

Tips

◗If the fabric consists of various kinds of fibres,always select the

temperature required by the most delicate fibre,i.e.the lowest

temperature.For example:if an article consists of 60% polyester

and 40% cotton,it should be ironed at the temperature indicated

for polyester (1) and without steam.

◗When steam ironing woollen fabrics,shiny patches may occur.You

can prevent this by using a dry pressing cloth or by turning the

article inside out and ironing the reverse side.

◗Velvet and other fabrics that tend to acquire shiny patches should

be ironed in one direction only (along with the nap) while applying

very little pressure.

◗Do not use steam when you are ironing coloured silk.This could

cause stains.

Steam ironing

Make sure that there is enough water in the steam tank.

Steam ironing is only possible at higher ironing temperatures:

1Set the temperature dial to the recommended position.

See 'Setting the temperature'.

C2Keep the steam activator button (H) pressed in while you are

steam ironing.

3Wait until the 'steam tank heating up' pilot light has gone out.

BSteaming will start as soon as the set temperature has been reached.

ENGLISH 9

Types GC6024/6026 only:During steam ironing,pilot light G will come

on from time to time to indicate that the steam tank and the iron are

being heated up to the right temperature and pressure.You can simply

continue ironing while this happens.

If you have not used the steaming facility for some time, the steam that

was still present in the supply hose will have condensed into water.

When you start steam ironing again,this may cause some spluttering in

the appliance and a few droplets of water may escape from the

soleplate.

BTo prevent droplets from falling onto your garments,hold the iron over an

old cloth and press the steam activator button (H) until the steam

production has normalised before you start steam ironing again.

Ironing without steam

1Set the temperature dial to the recommended position.

See 'Setting the temperature'.

2Do not press the steam activator button (H).

◗Some steam will escape if you press the steam button by accident

while you are ironing.If the steam tank is empty or has not heated

up yet,you will hear a clicking sound inside the tank.This

phenomenon is caused by the opening of the steam valve and is

perfectly harmless.

◗If you have been ironing at a high temperature and subsequently

set the temperature dial (I) to a lower setting,wait until the

temperature pilot light (G) goes on again before you continue

ironing.This will prevent damage to your fabrics.

Other features

Steaming in vertical position.

C1Hanging curtains and clothes (jackets,suits,coats) can be steam

ironed by holding the iron in vertical position.

Never direct the steam at people.

ENGLISH10

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Fer

Philips

Philips GC4522 Manuel utilisateur

Philips

Philips GC8600 Series Manuel utilisateur

Philips

Philips PerfectCare Expert GC9500 Series Manuel utilisateur

Philips

Philips GC7035/20 Manuel utilisateur

Philips

Philips EasySpeed Plus GC2049 Series Manuel utilisateur

Philips

Philips GC9620 Manuel utilisateur

Philips

Philips GC9200 Series Manuel utilisateur

Philips

Philips GC7011 Manuel utilisateur

Philips

Philips GC4800 series Manuel utilisateur

Philips

Philips Provapor GC6268 Manuel utilisateur

Philips

Philips GC4620 Manuel utilisateur

Philips

Philips GC 6606/20 Manuel utilisateur

Philips

Philips PerfectCare Xpress GC5060 Manuel utilisateur

Philips

Philips GC500 Series Manuel utilisateur

Philips

Philips PerfectCare 6000 Series Manuel utilisateur

Philips

Philips PerfectCare Pure GC7620/30 Manuel utilisateur

Philips

Philips Azur Elite GC5030 Series Manuel utilisateur

Philips

Philips GC6611 Manuel utilisateur

Philips

Philips GC6600 series Manuel utilisateur

Philips

Philips Mistral GC2425 Manuel utilisateur

Philips

Philips GC3620 Manuel utilisateur

Philips

Philips GC330 Series Manuel utilisateur

Philips

Philips GC4400 series Manuel

Philips

Philips GC9400 SERIES Manuel utilisateur

Manuels Fer populaires d'autres marques

Clatronic

Clatronic DB 3703 Manuel utilisateur

TEFAL

TEFAL FV4093Z0 Manuel utilisateur

Gorenje

Gorenje SIH 2200 BS Manuel utilisateur

Bosch

Bosch 2 Series Manuel utilisateur

Riffel

Riffel Catena KB-819 Manuel utilisateur

Texi

Texi Hestia Manuel utilisateur

Maxwell

Maxwell MW-3010 Manuel utilisateur

TREVIDEA

TREVIDEA Girmi ST60 Manuel utilisateur

Primula

Primula Vapormat Manuel utilisateur

Magio

Magio MG-541 Manuel utilisateur

Scarlett

Scarlett SC-1334S Manuel utilisateur

Bosch

Bosch Sensixx B22L Manuel utilisateur

Vitek

Vitek VT-1247 VT Manuel utilisateur

Cleanmaxx

Cleanmaxx 3397 Manuel utilisateur

dyras

dyras ESI-2400AC Manuel utilisateur

GE 169061 Manuel utilisateur

Gorenje

Gorenje SIH 2200 GC Manuel utilisateur

AEG

AEG DBS 5591 Manuel utilisateur