Philips AJ300DB Manuel utilisateur
Docking Entertainment System AJ300DB
User manual
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 1
DOCK
@
0
7
1
2
3
4
8
9
2
7
5
#
1
&
*
(
$
^
3
POWER
PRESET VOL
MUTE
SLEEP
TUNER
AUX 6
5
!
8
4
6
)
%
1
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 2
2
3
4
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 3
English
SUPPLIED ACCESSORIES
– 1XAC/DC 18V adapter
– Docking kit
•1X Apple iPod dock (pre-installed with AJ300D);1 X Philips GoGear jukebox
dock;
• dock adapters (8 adapters for different iPod types, and 4 adapters for
different Philips GoGear types)
– 1XAUX-IN cable
CONTROLS
(See 1)
1POWER
–switches the system on or to standby mode
–stops active alarm for 24 hours
–deactivates the sleep function
2
¡1 /2™
–adjust clock/alarm time
–selects previous/next tracks in the dock mode
–fast searches forward/backward in the dock mode (only available to iPod)
3PRESET 1-5
–stores, recalls and shows radio station
4SLEEP
–activates the sleep function
–
deactivates the sleep function
5DOCK
–selects dock mode for Apple iPod and Philips GoGear
6TUNER/ AUX
–selects FM radio mode
–selects AUX mode
72;
–starts/pauses playback in the dock mode
–selects 12 hour or 24 hour mode
8VOL+/-
–
adjusts the sound level
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 4
9
MUTE
–switches playback sound off and on.
0Display
–
shows clock/alarm times and status of the set
!Dock connector (30 pins)
–
connects iPod/Philips GoGear player
@
ALM 2
–
activates/confirm ALARM 2 time setting
–displays ALARM 2 time
–switches off ALARM 2 time
#
REPEAT
ALARM /
BRIGHTNESS CONTROL
–switches off the alarm for a 9 minute period
–changes the brightness of the display illumination
$POWER jack
–
socket for AC/DC 18V adapter
%
Pigtail –improves FM reception
^
ALM
1
–
activates/confirm ALARM 1 time setting
–displays ALARM 1 time
–switches off ALARM 1 time
&TIME SET
–activates/confirm clock time/date setting
*
(Wake-up mode) DOCK•BUZZER •TUNER
–selects alarm mode: dock, buzzer or radio
(AUX IN jack (3.5 mm)
–
connects to external audio source
)
RESET
–clears clock time setting
POWER SUPPLY
Mains adapter
1
Connect the mains adapter to the set's DC 18V socket and to the power socket.
Helpful hints: To avoid damage to the set, use only the adapter supplied!
The type plate is located on the bottom of the set.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 5
Remote control
Important!
• Before using the remote control, remove the insulation plastic tab as
shown in the figure.
• If the remote control does not function correctly or the operating
range is reduced, replace the battery with a new (CR2025) type
battery.
1.
Pull the battery tray out as shown in the figure.
2.
Replace a new battery according to polarity indication, and fully insert the
battery tray back to the original position.
Battery contain chemical substances, so they should be disposed of
properly.
SELF-POWERED BACK-UP
The self-powered back-up conveniently allows your preset stations, alarm and clock
time settings to be stored for up to 10 minutes when there is a power interruption
e.g. AC power failure. The complete clock radio and backlight illumination will be
switched off.
If power supply returns after 10 minutes and the display shows:
•clock time blinking - indicates you need to re-adjust the clock time.
2
3
1
CAUTION
Visible and invisible laser radiation. If the cover is open, do not look
at the beam.
High voltage! Do not open.You run the risk of getting an electric
shock. The machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of
EMC or other unsafe operation.
This product complies with the radio interference requirements of
the European Community.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 6
BASIC OPERATION.
Switching on the system
•Press POWER.
™
The system will switch to the last selected source.
•Press TUNER/AUX or DOCK.
™
The system will switch to the selected source.
Switching the system to standby mode
•In any source mode, press POWER.
Switching off the volume temporarily
Press MUTE on the remote control to stop sound play-back instantly.
™
Playback will continue without sound and the display shows MUTE .
•To start sound playback you can:
– press MUTE again;
– adjust the volume controls;
– change source.
Illumination brightness
Press REPEAT
ALARM /
BRIGHTNESS CONTROL once or more.
•
The brightness of the display can be adjusted:
Bright ➟Low ➟Off ➟Bright
.
SETTING THE CLOCK AND DATE
1. In any mode, press and hold TIME SET until clock digits flashes.
2.
Press
2;
to select 12 Hours/ 24 Hours mode.
3.
Hold down or press ¡1 /2™ repeatedly to set and adjust the hours.
4. Press TIME SET
to confirm.
™
The clock digits for the minutes flash.
5.
Repeat the steps 3 - 4 until you complete all the other settings for minutes,
year, month and days.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 7
TUNER
1
Press
TUNER/AUX
once to switch on the radio (FM only).
™
Display shows the radio frequency of the last selected waveband. Your pre-
set station is also shown if you are listening to a preset.
(
See 2
)
2
Adjust the sound using VOL+/-
.
3To select preset stations, press the respective PRESET button (1-5).
TUNING TO RADIO STATIONS
1Press and hold
¡1 /2™
until the frequency in the display starts changing.
™Display shows “Scrh” during automatic tuning.
™After the system tunes to a station of sufficient reception, display shows its frequency.
•To tune to a weak station, press
¡1 /2™
briefly and repeatedly until an
optimal reception is found.
To improve reception (FM):
Extend and position the pigtail fully to obtain optimum reception.
STORING AND USING PRESET STATIONS
You can store up to 5 FM radio stations in the memory.
1Tune to your desired station (see TUNING TO RADIO STATIONS).
2To store a preset, hold down briefly on a PRESET button 1-5 until you hear a dou-
ble beep.
™
Display shows the preset number of your station.
3Repeat steps 1 and 2 to store your other stations.
•You can overwrite a preset station by storing another frequency in its place.
4
Press a
PRESET button 1-5 (or PRESET 4/ 3on the remote control) to listen to
a preset station.
™
To display clock time, press
2;
on the set.
USING THE ALARM
GENERAL
Two different alarm times can be set. This can be useful when you need to be
woken up at a different time e.g. during the week and at the weekend, and you
can set different wake-up modes:
•tuner mode.
•buzzer mode. The gentle wake buzzer alarm increases its beep tone frequency within seconds.
•dock mode (only for Apple iPod and Philips GoGear SA9100 and SA9200)
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 8
SETTING THE ALARM TIME
(See 3)
1In any mode, press and hold ALM1 or ALM2 for two seconds.
™
ALM1
/
ALM2
icon and the hour digits flash. And the icon for the current
alarm mode also flashes.
2
Hold down or press ¡1 /2™ repeatedly to set and adjust the hours.
3Press ALM1 or ALM2
to confirm.
™
ALM1
/
ALM2
icon and the minutes digits flash. And the icon for the cur-
rent alarm mode also flashes.
4
Hold down or press ¡1 /2™ repeatedly to set and adjust the mintues.
5Press ALM1 or ALM2
to confirm.
SETTING THE ALARM MODE
1Press POWER to switch to standby mode.
2
Select your choice of alarm mode: either docked player (
only for Apple iPod and
Philips GoGear SA9100 and SA9200),
buzzer, or radio by using the
DOCK•BUZZER •TUNER slider.
•
At the set alarm time, the docked player (
only for Apple iPod and Philips GoGear
SA9100 and SA9200)
or radio or buzzer will switch on automatically.
Helpful hints:
–
If you have selected TUNER alarm mode,make sure you have properly tuned to a
station before turning off the set.
–
If you have selected DOCK alarm mode
(
only for Apple iPod and Philips GoGear
SA9100 and SA9200), make sure you have docked the compatible player, or the
buzzer mode will be selected automatically.
–
To check the alarm time setting for ALM1 or ALM2, press ALM1 or ALM2.
SWITCHING OFF THE ALARM
There are three ways of switching off the alarm. Unless you cancel the alarm
completely, the 24-hour ALARM RESET will be automatically selected after 59
minutes from the time your alarm first goes off.
24 HOUR ALARM RESET
If you want the alarm mode to be stopped immediately but also wish to retain
the same alarm setting for the following day:
•
Press
POWER
.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 9
REPEAT ALARM
This repeats your alarm call at 9 minute intervals.
•
During the alarm call, press REPEAT
ALARM /
BRIGHTNESS CONTROL..
™
Display shows
ALM1
or
ALM2
flashing during a repeat alarm.
•
Repeat if desired (up to a maximum of 6 times).
CANCELING THE ALARM COMPLETELY
•
Press
ALM
1or
ALM
2button once or more until
ALM1
or
ALM2
disappears.
DOCK (See 4)
By connecting the iPod/Philips GoGear to your AJ300D, you can listen to the
sound of the docked player through the powerful speakers of the Hi-Fi system.
Important!
• AJ300D comes with two dock types. Use the designated dock type, as
indicated on the top panel of the dock supplied, to work with either
Apple iPod or Philips GoGear.
COMPATIBLE PORTABLE PLAYER
•
Most Apple iPod models with 30-pin dock connector as follows:
20GB, 40GB, 20/30GB photo, 40/60GB photo, 30GB video, 60GB video, mini
and nano.
•Philips GoGear players with dock connectors as follows:
- HDD1420, HDD1620, HDD1630, HDD1635;
- HDD1820, HDD1830, HDD1835;
- HDD1840, 1850;
- HDD6320, HDD6330
- SA9100, SA9200
CHANGING THE DOCK
The iPod connector is pre-installed with the AJ300D main unit. For Philips
GoGear users, change to the supplied Philips GoGear connector before use.
1
Slide the dock switch located near the dock connector to .
2
Take the dock out.
3Correctly
place the suitable dock in. Then firmly hold down the dock, and
simultaneously push the dock switch back to position.
IFU_AJ300D_eur_eng 2006.11.9 11:04 Page 10
Autres manuels pour AJ300DB
1
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Philips Station d'accueil
Philips
Philips DC-291 Manuel utilisateur
Philips
Philips AZ1330D Manuel d'utilisation
Philips
Philips DCB291/12 Manuel utilisateur
Philips
Philips DC291/17 Manuel utilisateur
Philips
Philips AD300 Manuel utilisateur
Philips
Philips Fidelio DS9800W Manuel utilisateur
Philips
Philips AJ300D/79 Manuel utilisateur
Philips
Philips BTM630/12 Manuel utilisateur
Philips
Philips MCM138D Manuel utilisateur
Philips
Philips AJ5350D Manuel utilisateur
Philips
Philips MCM108D/98 Manuel utilisateur
Philips
Philips AZD1755 Manuel utilisateur
Philips
Philips DC290B Manuel utilisateur
Philips
Philips dcb310 Manuel utilisateur
Philips
Philips DCM250/12 Manuel utilisateur
Philips
Philips DTM5096 Manuel utilisateur
Philips
Philips AZ1330D/12 Manuel d'utilisation
Philips
Philips DCD7010 Manuel utilisateur
Philips
Philips DC350V37 Manuel utilisateur
Philips
Philips DCM250/93 Manuel utilisateur
