Philips SCF355 Manuel utilisateur
Question?
有疑问?
Contact Philips
请联系飞利浦
SCF355
1
SCF355
ENGLISH 6
简体中文 16
6
General description (Fig. 1)
1 Bottle warmer
2 Light
3 Settings knob
4 Off setting
5 Defrost setting
6 Keep warm setting
7 Express warming setting
Important
To fully benet from the support that Philips offers, register your
appliance at www.philips.com/welcome.
Read this user manual carefully before you use the bottle warmer and
save it for future reference.
Danger
- Do not immerse the cord, plug or appliance in water or other liquid.
Warning
- Only use the appliance indoors.
- Do not let the mains cord hang over the edge of a table or worktop.
Excess cord can be stored in the base of the bottle warmer.
- Keep the mains cord away from hot surfaces.
- Only connect the appliance to an earthed wall socket. Always make
sure that the plug is inserted into the wall socket properly.
- Check if the voltage indicated on the bottom of the appliance
corresponds to the local mains voltage before you connect the appliance.
- If you need to use an extension cord, make sure it is an earthed
extension cord with a rating of at least 13 amperes.
- Do not use the appliance if the plug, the mains cord or the appliance
itself is damaged. If the mains cord is damaged, you must have it
replaced by Philips, a service centre authorised by Philips or similarly
qualied persons in order to avoid a hazard.
- Do not place the appliance on or near a hot gas or electric cooker,
or in a heated oven.
ENGLISH
- This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
- Keep the appliance and its cord out of the reach of children.
- Do not spill water on the mains plug.
- Only use the appliance as described in the user manual to avoid
potential injury due to misuse.
- Do not preheat the appliance.
- Always place a fully assembled bottle with cap in the bottle warmer
before you add water.
- Make sure you add water before you switch on the bottle warmer.
- Hot water can cause serious burns. Be careful when the bottle
warmer contains hot water.
- The accessible surfaces of the appliance may become hot during use.
- Do not move the appliance when it contains hot water.
- When the food or milk has reached the required temperature,
remove the bottle or container from the bottle warmer. If you leave
food or milk in the bottle warmer, the temperature of the food or
milk increases.
- Always check the food temperature before you feed your child.
Caution
- This appliance is intended to be used in household and similar
applications such as farm houses, bed and breakfast type
environments, staff kitchen areas in shops, ofces and other working
environments, and by clients in hotels, motels and other residential
type environments.
- Unplug the appliance when it is not in use.
- The surface of the heating element is subject to residual heat after use.
- Let the appliance cool down before you clean it.
- Follow the descaling instructions to avoid irreparable damage.
ENGLISH 7
- Do not try to open or repair the appliance yourself.You can contact
the Philips Consumer Care Centre in your country
(see www.philips.com/support).
You can nd the production date code YY/MM/DD in the cord storage
compartment in the base of the bottle warmer.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and
regulations regarding exposure to electromagnetic elds.
Using the bottle warmer
With this bottle warmer, you can quickly warm all Philips Avent feeding
bottles and milk/baby food in containers and other baby food jars.
Note: Philips Avent breast milk bags and Philips Avent 2oz/60ml bottles
cannot be used in this bottle warmer.
Explanation of settings
- Off setting: the bottle warmer is switched off and the light is off.
On every other setting, the appliance is switched on and the light is lit.
(Fig. 2)
- Defrost setting: defrost a bottle/container of milk/baby food to liquid
state. No warming occurs.
- Keep warm setting: the milk/baby food is warmed slowly and kept
warm until you switch off the appliance.
- Express warming setting: the milk/baby food will be warmed quickly.
The bottle needs to be taken out immediately after warming,
otherwise the milk will overheat.
Using the bottle warmer with defrost setting
1 Put the mains plug in the wall socket (Fig. 3).
2 Place the bottle or container in the bottle warmer (Fig. 4).
3 Fill the bottle warmer with drinking water up to the level of the
milk/baby food in the bottle/container. In case of large amounts of
milk, the maximum level of water is approximately 1 cm below the
top of the bottle warmer. (Fig. 5)
ENGLISH8
4 Select the position of defrost (Fig. 6).
At this setting, your frozen milk/baby food can be defrosted till liquid
state. Depending on the milk volume it can take up to 2 hours to defrost
your milk/baby food. When your milk/baby food is defrosted, choose the
keep warm setting or express warming setting to warm your milk/baby
food. Consider the start temperature of your milk around fridge
temperature for the warming timings as rough guideline.
Note: Due to the high variety of baby food consistencies, it is strongly
recommended to continuously stir and check while you are defrosting the
baby food for an optimal result.
5 Turn the knob back to the ‘off’ position when the bottle/container
is removed from the bottle warmer. (Fig. 7)
Using the bottle warmer with keep warm setting
1 Put the mains plug in the wall socket (Fig. 3).
2 Place the bottle or container in the bottle warmer (Fig. 4).
3 Fill the bottle warmer with drinking water up to the level of the
milk/baby food in the bottle/container. In case of large amounts of
milk, the maximum level of water is approximately 1 cm below the
top of the bottle warmer. (Fig. 5)
4 Select the position of keep warm (Fig. 6).
At this setting, you can warm your milk/baby food at a slow pace and
keep it warm at the right end temperature. Depending on the milk/baby
food volumes and the baby food consistencies, the warming time will take
longer/shorter.
Note: Philips Avent recommends to feed your baby as soon as possible after
the milk/baby food is warmed.We advise not to reheat the milk/baby food
after it has cooled down again.
Note:Always check the temperature before you feed your baby.
5 Turn the knob back to the ‘off’ position when the bottle/container
is removed from the bottle warmer. (Fig. 7)
ENGLISH 9
Using the bottle warmer with express warming setting
1 Put the mains plug in the wall socket (Fig. 3).
2 Place the bottle or container in the bottle warmer (Fig. 4).
3 Fill the bottle warmer with drinking water up to the level of the
milk/baby food in the bottle/container. In case of large amounts of
milk, the maximum level of water is approximately 1 cm below the
top of the bottle warmer.An accurate water level ensures correct
warming performance (Fig. 5).
4 Select a position in the express warming area. Consider the
beginning of this area as milk content volume up to 180ml and the
end of the area as milk content volume over and including 180 ml,
see the express warming reference table for you reference. (Fig. 6)
Baby food can also be warmed quickly if you select a position in this area.
Make sure to stir and check the food regularly during warming. Be careful
not to burn your ngers during stirring.
Note:The speed of warming milk/baby food depends on the amount of the
milk/baby food warmed and on its initial temperature, i.e. room temperature
(20°C) or fridge temperature (5°C).
5 The orange light goes on when you select a setting.This indicates
that the bottle warmer is on (Fig. 8).
Note:Whilst warming the milk circulates and heats evenly.
6 Check the warming reference table for the time required to warm
the milk. Remove the bottle/container from the bottle warmer
immediately after the warming is nished (Fig. 9).
Caution: Please make sure to check the milk/baby food on a regular
basis for temperature during warming.
Caution: If you leave the bottle/container in the bottle warmer too
long, the milk/baby food may become overheated.
Note: Due to the high variety of baby food consistencies, it is strongly
recommended to continuously stir and check while you are warming the baby
food for an optimal result.
ENGLISH10
Autres manuels pour SCF355
22
Table des matières
Autres manuels Philips Chauffe-biberon
Philips
Philips AVENT SCF355/00 Manuel utilisateur
Philips
Philips SCF355 Manuel utilisateur
Philips
Philips SCF355 Manuel utilisateur
Philips
Philips SCF287 Manuel utilisateur
Philips
Philips SCF255/52 Manuel utilisateur
Philips
Philips SCF250 Manuel utilisateur
Philips
Philips AVENT scf356 Manuel utilisateur
Philips
Philips SBCSC215/87 Manuel utilisateur
Philips
Philips SCF355 Manuel utilisateur
Philips
Philips SCF282/22 Manuel utilisateur
Philips
Philips AVENT scf356 Manuel utilisateur
Philips
Philips HD4331/01 Manuel utilisateur
Philips
Philips SCF215/86 Manuel utilisateur
Philips
Philips SCF355 Manuel utilisateur
Philips
Philips SCF256 Manuel utilisateur
Philips
Philips SBCSC230/05 Manuel utilisateur
Philips
Philips SBC SC205 Manuel utilisateur
Philips
Philips SBC SC215 Manuel utilisateur
Philips
Philips SCF355 Manuel utilisateur
Philips
Philips AVENT scf356 Manuel utilisateur
