Philips SCF250 Manuel utilisateur

SCF250

ENGLISH 6

POLSKI 12

ROMÂNĂ 18

РУССКИЙ 24

ČEŠTINA 31

MAGYAR 36

SLOVENSKY 42

УКРАЇНСЬКА 48

HRVATSKI 54

EESTI 59

LATVIEŠU 65

LIETUVIŠKAI 71

SLOVENŠČINA 76

БЪЛГАРСКИ 81

SRPSKI 87

SCF250

Functional Overview - Product illustration on inside flap

1Bottle and jar lifter

2Hand grips

3Mains plug

4Click-step control knob

5Indicator lamp

6Ring with water cup

7Container

8Cable reservoir

Important Safeguards

◗Read and save these instructions

◗Never use the unit without water in it.

◗Do not touch hot surfaces. Use handles or grips.

◗Do not move an appliance containing hot liquids.

◗Do not immerse appliance, cord or plugs in water or other liquid.

◗Close supervision is necessary when the unit is used nearchildren.

◗Do not let cord hang over edge of table or counter.

◗Do not place on hot surfaces or in a heated oven.

◗Test food on inside of hand before serving to ensure it is at a safe

temperature for your baby.

◗Use only containers that have been approved for boiling.

◗Only use the Baby Bottle Warmer when the ambient

temperature is between +7 cand +37c.

Installation

For use at home

Before connecting the Baby Bottle Warmer to the mains, check to

ensure that the mains outlet is 230V AC.

1Place the Baby Bottle Warmer out of the reach of children and

on a dry, non-slip, horizontal surface.

2Turn the click-step control knob 4to the left to the "." (OFF)

position.

The indicator lamp lights green.

ENGLISH6

3Unreel the required cable length from the cable reservoir 8and

plug into the mains outlet.

Operation

Warming of baby bottles

1Turn the click-step control knob 4to the left to the "." (OFF)

position.

2Connect the bottle warmer to the mains socket.

The indicator lamp lights green.

3Fill the beaker with 10 or 20ml water by using the water cup of

the ring 6.The content is depending on the bottle filling and

start temperature (see Heating Overview on page 100).

4Place the bottle in the middle of the beaker and put the ring 6

on top of it.

5Use the click-step control knob 4to set the correct setting

(see Heating Overview on page 100).

The indicator lamp lights red.

When the right temperature is reached the indicator lamp will light

green.

6Remove the bottle from the container and turn the control knob

to the "." (OFF) position.

7Shake the bottle a little to distribute the heat evenly before you

allow your baby to drink.

8Check that the contents of the bottle are the correct

temperature by pouring a few drops on the back of your hand.

Notes!

- The ring ensures that the hot steam heats up the bottle extremely

fast to the right temperature.Warming the bottle without the ring,

might result in a wrong temperature, therefore never use the bottle

warmer without the ring.

ENGLISH 7

- The dimensions of the bottle or the material of the bottle (glass in

stead of plastic) may influence selecting the correct knob setting.

Therefore always control the end temperature and adjust the

setting of the knob.

Warning!

When you leave the bottle in the bottle warmer after it is heated up,

the temperature might increase a few degrees.

Warming baby food jars

1Turn the click-step control knob 4to the left to the "." (OFF)

position.

2Connect the bottle warmer to the mains socket.

The indicator lamp lights green.

3Remove the label and lid from the jar.

4Fill the beaker with 20ml water by using the water cup of the

ring.

5Place the jar in the middle of the container and put the ring on

top of it.

6Set the click-step control knob to the nsymbol.

The indicator lamp lights red.

When the right temperature is reached the indicator lamp will light

green.

7Remove the jar from the container and turn the control knob to

the left to the "." (OFF) position.

8Stir the contents of the jar to distribute the heat.

9Always check that the contents of the jar are at the correct

temperature by testing some on the back of your hand or via

your mouth.

10 If the temperature is much too low, fill the beaker again with

10ml.Turn the click-step control knob 4to the right until the

indicator lamp lights up red to start the heating up again.

ENGLISH8

Note!

The ring ensures that the hot steam heats up the jar extremely fast to

the right temperature.Warming the jar without the ring, might result in

a wrong temperature, therefore never use the bottle warmer without

the ring.

Keeping warm

With the Baby Bottle Warmer you can also keep the bottles and jars

warm for a short time.

To do this set the control knob to the vsymbol. Do not add water.

The thermostat ensures that the set temperature is maintained.

For microbiological and hygienic reasons baby food should never be

kept warm for longer than one hour.

Note!

Never hold the Baby Bottle Warmer in your hands when in use.

Maintenance

Cleaning

Disconnect the Baby Bottle Warmer from the mains socket and allow it

to cool down. Clean the container and the outside of the Baby Bottle

Warmer with a damp cloth.

Notes:

- Never immerse the Baby Bottle Warmer in water.

- Do not use cleaning or scouring agents.

Warning:

If a fault occurs, consult a Philips' service centre. Under no

circumstances should you try to repair the Bottle Warmer yourself; do

not dismantle. Servicing should be performed by qualified service

personnel only.

ENGLISH 9

220-240V AC

250 Watts

between +7cC and +37cC

PTC temperature controlled heating

system

Technical Specifications

Power supply (mains):

Power consumption (mains):

Operational ambient temperature:

Protection:

ENGLISH10

Problem solving

Solution

Turn the click-step control knob 4to

the right until the indicator lamp lights

up red to start the heating up again.

Check ring filling and start

temperature.

Lower the adjustment setting.

Check ring filling and start

temperature.

Stir the contents from time to time

while heating. Check that the click-step

control knob is in the nposition

Wait 15 minutes between consecutive

uses to allow the safety cut-out to

reset.

This is normal; it may turn on or off

while heating.

Shield indicator from ambient light to

improve visibility.

Hard water deposits are normal and

may increase if your water is very

hard; remove the deposits periodically

with white vinegar (see maintenance).

Problem

Temperature too low.

Temperature too high.

The jar has not heated correctly.

Unit does not warm up.

The indicator light switches on and off

while keeping warm.

Indicator light does not seem to light.

The bottom of the tank is spotted.

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Chauffe-biberon

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT SCF355/07 Manuel utilisateur

Philips

Philips AVENT SCF358 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SBCSC215/87 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SCF256 Manuel utilisateur

Philips

Philips SBC SC205 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF282/22 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355/04 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355/03 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT SCF358 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips AVENT SCF356/00 Manuel utilisateur

Philips

Philips SBCSC250 Manuel utilisateur

Manuels Chauffe-biberon populaires d'autres marques

Topcom

Topcom KD-4302 Manuel utilisateur

SEVERIN

SEVERIN BK-3177 Manuel utilisateur

SEVERIN

SEVERIN BK 3176 Manuel utilisateur

Chicco

Chicco 06867 MU Manuel utilisateur

Reer

Reer Multimax 2 in 1 -travel Manuel utilisateur

Lionelo

Lionelo Thermup Go Manuel utilisateur

TEFAL

TEFAL Disney Baby TD1100K0 Manuel utilisateur

TrueLife

TrueLife INVIO BW Single Manuel utilisateur

Gourmia

Gourmia JBW-250 Manuel utilisateur

König Electronic

König Electronic HC-BW10 Manuel utilisateur

Gourmia

Gourmia JBW-150 Manuel utilisateur

NUK

NUK MEDICPRO 10.256.467 Manuel utilisateur

Petra

Petra DI 6.00 Manuel utilisateur

Philips AVENT

Philips AVENT Electric Bottle and Baby Food Warmer Manuel utilisateur

babymoov

babymoov Auto Speed Bib Manuel utilisateur

Alecto

Alecto BW600 Manuel utilisateur

Lionelo

Lionelo Thermup Manuel utilisateur

Vinotemp

Vinotemp VT-Chiller Manuel utilisateur