Philips SCF355 Manuel utilisateur

SCF355

English 3

 16

Čeština 32

Ελληνικά 45

Eesti 61

Hrvatski 74

Magyar 87

Қазақша 102

Lietuviškai 118

Latviešu 132

Polski 145

Română 160

 175

Slovensky 192

Slovenščina 206

Srpski 219

 233

3ENGLISH

Important

Read this user manual carefully before you use the bottle warmer and save it for future reference.

Danger

- Do not immerse the cord, plug or appliance in water or other liquid.

Warning

- Only use the appliance indoors.

- Do not let the mains cord hang over the edge of a table or worktop.

Excess cord can be stored in the base of the bottle warmer.

- Keep the mains cord away from hot surfaces.

- Only connect the appliance to an earthed wall socket. Always make

sure that the plug is inserted into the wall socket properly.

- Check if the voltage indicated on the bottom of the appliance

corresponds to the local mains voltage before you connect the

appliance.

- If you need to use an extension cord, make sure it is an earthed

extension cord with a rating of at least 13 amperes.

- Do not use the appliance if the plug, the mains cord or the

appliance itself is damaged. If the mains cord is damaged, you must

have it replaced by Philips, a service centre authorised by Philips or

similarly qualied persons in order to avoid a hazard.

- Do not place the appliance on or near a hot gas or electric cooker,

or in a heated oven.

- This appliances can be used by persons with reduced physical,

sensory or mental capabilities or lack of experience and knowledge

if they have been given supervision or instruction concerning use of

the appliance in a safe way and understand the hazards involved.

- Cleaning and user maintenance shall not be made by children.

- This appliance shall not be used by children. Keep the appliance

and its cord out of reach of children.

- Children shall not play with the appliance.

- Do not spill water on the mains plug.

- Only use the appliance as described in the user manual to avoid

potential injury due to misuse.

- Do not preheat the appliance.

4ENGLISH

- Always place a fully assembled bottle with cap in the bottle warmer

before you add water.

- Make sure you add water before you switch on the bottle warmer.

- Hot water can cause serious burns. Be careful when the bottle

warmer contains hot water.

- The accessible surfaces of the appliance may become hot during

use and are subject to residual heat after use.

- Do not move the appliance when it contains hot water.

- When the food or milk has reached the required temperature,

remove the bottle or container from the bottle warmer. If you leave

food or milk in the bottle warmer, the temperature of the food or

milk increases.

- Always check the food temperature before you feed your child.

Gently swirl the bottle and check by sprinkling a few drops on the

inside of your wrist.

Caution

- This appliance is intended to be used in household and similar

applications such as farm houses, bed and breakfast type

environments, sta kitchen areas in shops, oces and other working

environments, and by clients in hotels, motels and other residential

type environments.

- Unplug the appliance when it is not in use.

- The surface of the heating element is subject to residual heat after

use.

- Let the appliance cool down before you clean it.

- Follow the descaling instructions to avoid irreparable damage.

- Do not try to open or repair the appliance yourself. You can

contact the Philips Consumer Care Center in your country (see

www.philips.com/support).

- The food should not be heated for too long.

The production date code YYWW is located in the cord storage compartment in the base of the

bottle warmer.

Electromagnetic elds (EMF)

This Philips appliance complies with all applicable standards and regulations regarding exposure

to electromagnetic elds.

5ENGLISH

Introduction

Congratulations on your purchase and welcome to Philips Avent! To fully benet from the support

that Philips Avent oers, register your product at www.philips.com/welcome.

With this bottle warmer, you can safely warm all Philips Avent feeding bottles and milk/baby food

in containers and other baby food jars.

Note: Philips Avent breast milk bags and Philips Avent 2 oz/60 ml bottles cannot be used in this

bottle warmer.

Using the bottle warmer

Product overview

Bottle warmer

Light

Setting knob

Keep warm setting

Express milk warming

setting 1

Defrost setting

Food warming setting

O setting Express milk warming

setting 2

6ENGLISH

Explanation of settings

The bottle warmer is switched o and the light is o. On every other setting,

the appliance is switched on and the light is lit.

Select this setting when you want to quickly warm a bottle of milk at room

temperature (22 °C/72 °F) with a content from 60 ml/2 oz to 330 ml/11 oz or at

cold temperature (5 °C/40 °F) with a content from 60 ml/2 oz to 240 ml/8 oz.

The bottle has to be taken out immediately after warming to the right

temperature, otherwise the milk will be overheated.

Select this setting when you want to quickly warm a bottle of milk at cold

temperature (5° C/40 °F) with a content from 270 ml/9 oz to 330 ml/11 oz.

The bottle has to be taken out immediately after warming to the right

temperature, otherwise the milk will be overheated.

Select this setting when you want to warm a container/jar of baby food.

This setting warms milk at a slower speed and then keeps it warm.

Defrost a bottle/container of milk/baby food to liquid state. No Warming

occurs.

Using the bottle warmer with express milk warming setting

1 Put the mains plug in the wall socket. Place a bottle in the bottle warmer.

2 Fill the bottle warmer with drinking water up to the level of the milk in the bottle. In case of

large amounts of milk, the maximum level of water is approximately 1 cm below the top of

the bottle warmer. An accurate water level ensures correct warming performance.

7ENGLISH

3 Select the desired setting based on the milk volume. See the express warming reference

table at the end of this chapter to check how long the milk needs to be warmed in the

selected setting.

Note

• The speed of warming milk depending on the amount of the milk warmed and on its initial temperature,

i.e. room temperature (22 °C) or fridge temperature (5 °C).

4 The orange light goes on whenyou select a setting. This indicates that the bottle warmer is

on.

Note

• Whilst warming the milk circulates and heats evenly.

5 Check the express warming reference table for the time required to warm the milk. After the

time indicated in the express warming reference table has passed, remove the bottle for

feeding or turn the knob to “Keep Warm” to keep milk warm at a right temperature.

8ENGLISH

Tip

• When you nd the milk is not warm enough, you can place the bottle back into the appliance for

a maximum of 30 seconds of extra warming. This will create a slightly warmer result but without

overheating.

Caution

• If you leave the bottle in the bottle warmer longer than the time indicated in the settings table, the milk

may become overheated.

• If you overheat breast milk, valuable nutrients and vitamins may be lost.

6 Always check the temperature before you feed your baby. Gently shake the bottle or milk

storage container and check the temperature of the milk by sprinkling a few drops on the

inside of your wrist.

7 Turn the knob back to the ‘o’ position.

Caution

• The water in the bottle warmer might be hot after nishing warming milk / baby food. Be careful that hot

water can cause serious burns.

• If you do not turn the knob back to the ‘o’ position, the water keeps heating up and will reach a very high

temperature.

9ENGLISH

Express warming reference table

ml/oz

22°C/72°F 5°C/40°F 5°C/40°F

min min min

60 ml/2 oz - <150 ml/5 oz 2 - 3 5 - 6 -

150 ml/5 oz - <210 ml/7 oz 3 - 4 6 - 7 -

210 ml/7 oz - <270 ml/9 oz 4 - 5 7 - 9 -

270 ml/9 oz - 330 ml/11 oz 5 - 6 - 8 - 10

Note

• Indicated warming times are based on Philips Avent Natural and Classic+ polypropylene bottles. Be

aware that warming times of Philips Avent Anti-colic with AirFree vent polypropylene bottles and Natural

glass bottles deviate from these indications. In addition to bottle type and material, characteristics like

thickness may also impact warming time. Therefore it may take less time to warm a larger volume of milk.

• The milk may feel cool to you, but for a newborn baby its temperature is very pleasant.

Using the bottle warmer to warm baby food

1 Follow the same steps as indicated in the previous chapter.

2 Make sure to stir the baby food during warming as it does not circulate automatically. Be

careful not to burn your ngers when holding the container/jar while stirring.

After warming test the baby food with a spoon to ensure it is not too hot. If the baby food is not

warm enough, put the container back into the bottle warmer and warm the baby food until it has

the desired temperature.

Note

• Due to the high variety of baby food consistencies, it is strongly recommended to continuously stir and

check while you are warming the baby food for an optimal result.

• Due to the high variety of baby food consistencies, it is not possible to indicate warming timings for baby

food.

10 ENGLISH

Using the keep warm setting to warm milk

1 Put the mains plug in the wall socket. Place the bottle or container in the bottle warmer.

2 Fill the bottle warmer with drinking water up to the level of the milk in the bottle/container.

In case of large amounts of milk, the maximum levelof water is approximately1 cm below

the top of the bottle warmer.

3 Select the position of keep warm.

At this setting, you can warm your milk at a slow pace and keep it warm at the right end

temperature. E.g. to warm a bottle of 4 oz milk starting from room temperature, it will take

15-20 minutes. The warming time may be longer or shorter depending on the milk volumes and

starting temperature.

Autres manuels pour SCF355

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Autres manuels Philips Chauffe-biberon

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT SCF358 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SCF250/00 Manuel utilisateur

Philips

Philips SBCSC250/00 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SBC SC205 Manuel utilisateur

Philips

Philips SCD278/00 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SCF287 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips SCF255/51 Manuel utilisateur

Philips

Philips AVENT SCF355/00 Manuel utilisateur

Philips

Philips AVENT scf356 Manuel utilisateur

Philips

Philips HD4331/01 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips Avent SCH820/00 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips SBCSC215/23 Manuel utilisateur

Philips

Philips AVENT SCF358 Manuel utilisateur

Philips

Philips SCF355 Manuel utilisateur

Philips

Philips AVENT Anti-colic Manuel utilisateur

Manuels Chauffe-biberon populaires d'autres marques

Topcom

Topcom KD-4302 Manuel utilisateur

SEVERIN

SEVERIN BK-3177 Manuel utilisateur

SEVERIN

SEVERIN BK 3176 Manuel utilisateur

Chicco

Chicco 06867 MU Manuel utilisateur

Reer

Reer Multimax 2 in 1 -travel Manuel utilisateur

Lionelo

Lionelo Thermup Go Manuel utilisateur

TEFAL

TEFAL Disney Baby TD1100K0 Manuel utilisateur

TrueLife

TrueLife INVIO BW Single Manuel utilisateur

Gourmia

Gourmia JBW-250 Manuel utilisateur

König Electronic

König Electronic HC-BW10 Manuel utilisateur

Gourmia

Gourmia JBW-150 Manuel utilisateur

NUK

NUK MEDICPRO 10.256.467 Manuel utilisateur

Petra

Petra DI 6.00 Manuel utilisateur

Philips AVENT

Philips AVENT Electric Bottle and Baby Food Warmer Manuel utilisateur

babymoov

babymoov Auto Speed Bib Manuel utilisateur

Alecto

Alecto BW600 Manuel utilisateur

Lionelo

Lionelo Thermup Manuel utilisateur

Vinotemp

Vinotemp VT-Chiller Manuel utilisateur