Philips HP3641 Manuel utilisateur

InfraCare half-body treatment

HP3641

ENGLISH 6

POLSKI 15

ROMÂNĂ 25

РУССКИЙ 33

ČESKY 43

MAGYAR 52

SLOVENSKY 61

УКРАЇНСЬКІЙ 70

HRVATSKI 80

EESTI 88

LATVISKI 96

LIETUVIŠKAI 104

SLOVENŠČINA 113

БЪЛГАРСКИ 121

SRPSKI 131

HP3641

Introduction

With the InfraCare you can comfortably treat muscular problems and

relieve pain at home. It allows you to treat a large part of your body in

one go. Just like the sun, the appliance emits infrared light.The special

filter only passes the type of light required to achieve the intended

therapeutic effect.

General description (fig. 1)

AFan

BLamp housing

CHinge for tilting lamp housing

DPedestal pole

EHeight adjustment ring

FVelcro cord wrap

GMains cord

HControl panel

IFilter

JInfrared halogen lamp

KHandgrips

Important

The symbols on the InfraCare have the following meaning:

◗Read these instructions for use carefully before using the

appliance and save them for future reference (fig. 2).

◗This appliance is double insulated according to Class II.You can

therefore safely plug it into an unearthed wall socket (fig. 3).

◗The surface marked with this symbol becomes hot (fig. 4).

◗This appliance meets the requirements of Medical Device

Directive MDD93/42/EEC.

◗Check if the voltage indicated on the appliance corresponds to

the mains voltage in your home before you connect the

appliance.

◗If the wall socket used to power the appliance has poor

connections, the plug of the appliance will become hot. Make sure

you plug the appliance into a properly connected wall socket.

ENGLISH6

◗If the mains cord is damaged, it must be replaced by Philips, a

service centre authorised by Philips or similarly qualified persons

in order to avoid a hazard.

◗Do not subject the appliance to heavy shocks.

◗Water and electricity are a dangerous combination! Do not use

this appliance in wet surroundings (e.g. in the bathroom or near a

shower or swimming pool).

◗Do not let water run into the appliance or spill water onto the

appliance.

◗Do not leave the appliance unattended when it is switched on.

◗Always unplug the appliance after use and in case of a power

failure.

◗Keep the appliance out of the reach of children.

◗Place the appliance on a stable, level surface and make sure there

is at least 35 cm free space around it to prevent overheating.

◗Do not use the appliance at room temperatures lower than 10cC

or higher than 35cC.

◗Make sure the vents in the back of the appliance remain open

during use.

◗The appliance has been fitted with an automatic protection

against overheating. If the appliance is insufficiently cooled (e.g.

because the vents are covered), the appliance will switch off

automatically. Once the cause of overheating has been removed

and the appliance has cooled down, the appliance can be switched

on again by pressing the on/off button or by unplugging the

appliance and then plugging it in again.

◗Let the appliance cool down for approx. 15 minutes before

cleaning or storing it.

◗If you have just been swimming or have just taken a shower, make

sure you dry your skin properly before using this appliance.

◗Do not look into the lamp's light when it is on. Keep your eyes

closed.

◗The filter becomes very hot when the appliance is switched on.

Do not touch it!

◗Never use the appliance when the filter is damaged, broken or

missing.

ENGLISH 7

◗Avoid too intense cooling of the body part immediately after

treatment.

◗Do not fall asleep during treatment.

◗Painkillers reduce the sensitivity to heat. Do not use this

appliance when you are on painkillers without having consulted

your doctor first.

◗If you are oversensitive to infrared light, you should be extra careful

when using this appliance. Consult your doctor in case of doubt.

◗Do not use the appliance if you have a swelling or an

inflammation, as heat could aggravate the complaints. If in doubt,

consult your doctor.

◗If there is no improvement after 6-8 treatments, stop using the

appliance and consult your doctor.

Using the appliance

The effect of the InfraCare

The InfraCare produces infrared light, which penetrates deeply into the

skin.This warms the skin, dilating the blood vessels and thus stimulating

blood circulation.

The blood transports the substances necessary for rebuilding and

nourishing the body's tissues more rapidly, while at the same time

waste substances are removed more quickly.

This means treatment with the InfraCare can relieve muscular problems

and pain.

Therapeutic applications

The InfraCare is a local warmth therapy appliance.

Possible applications:

- Treatment for occasional or chronic muscle pains, stiff muscles and

stiff joints

- Treatment of lower-back ache (lumbago)

- Treatment of chilblains

- Preparation for another treatment such as a massage

- Treatment of sprains and bruises

ENGLISH8

- To relieve pain, e.g. due to rheumatic disorders

For more information about the health benefits, see www.philips.com

searchword InfraCare.

Preparing for use

1Fully unwind the mains cord.

2Place the appliance on a stable, level surface and make sure there is at

least 35 cm free space around it to prevent overheating (fig. 5).

Thanks to the pedestal, you can use the appliance in many different

positions. Below you find some examples.

◗Place the appliance beside a bed, with the lamp housing in highest

position and tilted down, and lie down comfortably on your belly

to treat your back from shoulders to hips (fig. 6).

◗Place the appliance beside a bed, with the lamp housing in lowest

position, and lie down comfortably on one side to treat your

back (fig. 7).

◗To treat your upper back and shoulders, place the appliance

behind a chair or other seat, with the lamp housing in horizontal

position, and sit down comfortably with your back towards the

appliance (fig. 8).

◗To treat your back, place the appliance beside a chair or stool,

with the lamp housing in vertical position, and sit down

comfortably with your back towards the appliance (fig. 9).

◗Place the appliance beside a chair, with the lamp housing in

horizontal position, and sit down comfortably to treat the hip and

upper leg area (fig. 10).

ENGLISH 9

3Adjust the lamp housing

◗Turn the height adjustment ring to the left, pull the lamp housing

up or push it down to the desired height and then lock it into

position by turning the ring to the right (fig. 11).

◗To tilt the lamp housing upwards or downwards, grasp it by its

handgrips and move it to the desired position (fig. 12).

◗You can also turn the lamp housing to horizontal or vertical

position by grasping it by the handgrips and turning it to the

required position (fig. 13).

◗Make sure the pedestal base is horizontal. If it is placed at an

angle, the appliance will switch off automatically (fig. 14).

4Sit or lie down at the right distance from the appliance.

- At a distance of 40-50 cm to the body, the InfraCare treats an area

of about 40 cm by 60 cm. At a larger distance, the area treated

becomes larger and the infrared light and therefore the warmth

less intense. At a smaller distance, the area treated is smaller and

the infrared light and therefore the warmth more intense.

- Make sure the distance between your body and the appliance is

large enough to prevent accidental contact with the hot filter.

- Choose a distance at which the heat is comfortable.

BPlease note that the warmth of the appliance does not reach its full

intensity until several minutes after switching the appliance on.This does

not mean, however, that the appliance is not effective during these first

minutes.

Duration of treatment

The duration of the treatment depends on the person to be treated

and the type of use.We recommend a few short treatments a day, e.g.

2 treatments of 15 minutes, on a number of consecutive days to get a

result.

BPractice has shown that a few short treatments a day produce a better

result than one longer treatment.

Always consult your doctor in case of doubt!

ENGLISH10

Autres manuels pour HP3641

Table des matières

Langues :

Autres manuels Philips Accessoires

Philips

Philips HF3490/01 Manuel utilisateur

Philips

Philips RQ1050 with charger Manuel utilisateur

Philips

Philips CRP302 Manuel utilisateur

Philips

Philips EasySense SNS200 Manuel utilisateur

Philips

Philips LivingWhites 69165/31/PH Manuel utilisateur

Philips

Philips CRP144 Manuel utilisateur

Philips

Philips 22PP1101 Manuel utilisateur

Philips

Philips CRP136 Manuel utilisateur

Philips

Philips HD7001 Mode d’emploi

Philips

Philips sonicare 3000 Series Manuel utilisateur

Philips

Philips DLA81823H Manuel utilisateur

Philips

Philips SCF156/01 Manuel utilisateur

Philips

Philips SVC2523W/27 Manuel utilisateur

Philips

Philips CRP331 Manuel utilisateur

Philips

Philips Senseo HD7003 Manuel utilisateur

Philips

Philips P-5759-D Manuel utilisateur

Philips

Philips 6918231PH Manuel utilisateur

Philips

Philips GoPure GP5611 Manuel utilisateur

Philips

Philips SmartSleep Manuel utilisateur

Philips

Philips HP3616 Manuel utilisateur

Philips

Philips HX7990/02 Manuel utilisateur

Philips

Philips Norelco HQ6/32 Manuel utilisateur

Philips

Philips ActiLume G2 Manuel utilisateur

Philips

Philips SH91/51 Manuel utilisateur

Manuels Accessoires populaires d'autres marques

Hillco

Hillco 2810 Manuel utilisateur

Siemens

Siemens QSA2700D Manuel de l'opérateur

Contours

Contours ZY024 Manuel utilisateur

Saivod

Saivod VS621 Manuel utilisateur

Virtuox

Virtuox VirtuCLEAN 2.0 Manuel utilisateur

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Manuel utilisateur

Z-Wave

Z-Wave HSD-200Z Manuel utilisateur

turck

turck FMX-IM-2UPLI63FX Manuel utilisateur

Decagon Devices

Decagon Devices 10HS Manuel utilisateur

UPPAbaby

UPPAbaby Cup Holder Manuel utilisateur

Elko

Elko SmartSensor Leakage Wireless Manuel utilisateur

Grizzly

Grizzly H8371 Manuel utilisateur

Panasonic

Panasonic HG-T Series Manuel utilisateur

IFM Electronic

IFM Electronic Efector 250 Series Guide de référence

DigiDesign

DigiDesign 888/24 I/O Manuel utilisateur

PROZIS

PROZIS QUAY Manuel utilisateur

patagonia

patagonia PSI Vest Manuel utilisateur

SFC Energy

SFC Energy EFOY GO! Manuel utilisateur