PHASEONE RP1-2300 AUTOCOLUMN XL installation manual V1.0 7
2.5.2 Applying the baseboard without extenders
Before applying the baseboard to the base, make sure locking screws [E]
inside base couplers [B] are fully loosened. Apply the baseboard to the
base by uniformly sinking the baseboard pins in the base couplers. Make
sure to retighten the locking set screws [E 4x] after the placement.
Figure 6 Applying the baseboard to the base
2.6 Wall mount installation
Besides mounting the column to the base it is optional to order brackets for
a wall mounted system. When installing the wall mounted system start by
applying the top bracket [A] to the wall. Make sure the distance between
the floor and the bottom mounting hole is at least 225CM. Fix the top
bracket to the wall first with a minimum of one screw on each side. Use a
sprit level during mounting to make sure the bracket is fixed to the wall
leveled.
Now fix the bottom bracket to the bottom of the column by using the two
bolts [D] and washers [C]. Place the bolts in the designated holes of the
bottom mounting block of the column. Fix the column to the wall mounted
to bracket. Level the brackets and column by using a spirit level and fix the
bottom bracket to the wall with at least one screw on each side.
For fine tuning the position of the column both the top and bottom bracket
contain a set screw [E]. Before using the set screws, slightly loosen bolts
[D] then tighten or loosen set screws [E]. when the column is leveled,
retighten bolts [D].
