Overview
This document contains instructions necessary for the installation and
operation of the Perle 10/100 and Gigabit (10/100/1000) Advanced
Powered Ethernet Extenders. These Ethernet Extenders enable
Ethernet communication across a single pair of copper wires such as
2-wire twisted pair telephone wire or coax cable using VDSL2
technology for extended distances.
The Perle Advanced Power Ethernet Extenders are available in L and
E models such as the eXP-1S110E and the eXP-1S110L. In order to
use the advanced power functions, an L model must always be used
in conjunction with an E model. These Ethernet Extenders can also
be used with other Perle Ethernet Extenders if advanced power
functionality is not required.
In a typical installation the L model would be at a central site and the
E model at a remote site and the L model would power the E model
via the VDSL line.
L Models Characteristics
The L models, such as the eXP-4S1110L-RJ are typically used in the
central location and have the following characteristics.
•Can provide power over the VDSL line and communicate with a
remote Extender (E or PE model) over the same VDSL line.
•Can communicate with any other Perle Ethernet Extender if remote
powering is not required.
•Can draw power from the Terminal Block connector, Barrel
connector or from the Ethernet port 1 (if connected to a compatible
PoE Power Sourcing Device (PSE) such as a switch).
E and PE Models Characteristics
The E or PE models such as the eXP-4S110E-RJ are typically used
in the remote location and have the following characteristics.
•Can be powered by and communicate with an L model over the
VDSL line. Alternatively, they can draw power from the Terminal
Block or Barrel connector.
•They can communicate with any other Perle Ethernet Extender if
power by VDSL link is not required
•Can act as a PSE to power equipment connected to the Ethernet
port.
