1a. Place a shell in the SHALLOW DIE (LEFT) The edge of the
shell slots into the round channel in the die. The shell should
t exactly into the slot.
1b. Place your cut-out artwork over the shell. It should t snugly
in the available space.
1c. Place a piece of mylar on top of your artwork.
1d. Place the pinned-back into the DEEP PICKUP DIE RIGHT
it should sit snugly in the depression in the die. Make sure the
pin is aligned the same way as your artwork. The hook and
pin side of the back should be facing down.
1. Get Your Button Parts Ready
PLASTIC INSERT
RING
(2.25” only)
MYLAR
ARTWORK
SHELL
SHALLOW
PICK-UP DIE
DEEP
PICK-UP DIE
INSERT PINNED BACK
PIN SIDE DOWN
*If you are making 2.25” buttons the white plastic insert ring must be placed
in the deep pickup die before the pinned-back.
**For best results, use the post on the back of the dies to orient your artwork,
if you point the top of your both artwork and the top of your pinned back
towards these posts your buttons will come out right side up!
(for some add-on sizes)
