Peerless-AV KLR62232 Manuel utilisateur

12019-06-14 #:150-9227-1

ENG

KLR62232, KLR64255

22019-06-14 #:150-9227-1

Symbols

ENG

WARNING

ENG

Skip to step.

ENG

Do not overtighten screws.

ENG

ENG - This product is designed to be installed on wood stud, solid concrete or cinder block walls. Hardware is

included for wood stud, solid concrete and cinder block installation. Do not begin to install product until you have

read and understood the instructions and warnings contained in this user guide. Before installing make sure

the supporting surface will support the combined load of the equipment and hardware. Screws must be tightly

secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the Maximum

Load Capacity. Always use an assistant or mechanical lifting equipment to safely lift and position equipment. This

product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal

injury. Be careful not to pinch ngers when operating the mount. To reduce the risk of electric shock or re, do not

expose product to water or moisture. Be sure power cord is routed so that it will not be tripped on, stepped on,

or pinched by heavy items. Avoid overloading electrical outlets or extension cords. Always disconnect the power

cord from the power outlet when installing, servicing, or not using the product for an extended period of time. Do

not block ventilation slots or fan exhaust on product. Blocking airow could damage product. Arrange product to

allow air to ow freely around product. Keep product away from direct sunlight or any source of heat. For support

please call 800-4-SIGNAGE.

WARNING

32019-06-14 #:150-9227-1

Tools Needed for Assembly.

ENG

ENG To properly tighten screws: Tighten until screw

head makes contact, then tighten another 1/2

turn. Do not overtighten screws.

+1/2

5/32"

(4mm)

5/16"

(8mm)

3/8"

(10mm)

42019-06-14 #:150-9227-1

A (1)

enclosure B (1)

wall mount

G (1)

hook-on

bracket

F (1)

locking bracket

Parts List KLR62232

Part #

KLR64255

Part #Description Qty

Aenclosure 1 152-1544 152-1545

Bwall mount 1 ST635 ST640

C#14 x 2-1/2" wood screw 4 5S1-015-C03 5S1-015-C03

D8mm concete anchor 4 590-0320 590-0320

Epower strip 1 600-0370 600-0370

Flocking bracket 1 152-T1502 152-T1511

Ghook on bracket 1 152-T1508 152-T1520

HM5 x 20mm 3 510-1065 510-1065

Parts (Before beginning, make sure you have all parts shown below).

ENG

E (1)

power strip

52019-06-14 #:150-9227-1

D (4)

8mm concrete anchor

C (4)

#14 x 2-1/2" wood screw

H (3)

M5 x 20mm

Follow and complete instructions for included wall

mount.

ENG

62019-06-14 #:150-9227-1

Hold enclosure over display in desired location,

and make sure that it is level. Mark the top

location of the enclosure.

ENG

Remove display.

ENG

Loosen.

ENG

4mm

72019-06-14 #:150-9227-1

ENG - When installing Peerless wall mounts on a wood stud wall covered with gypsum board (drywall), verify that

the wood studs are a minimum of 2" x 4" nominal size. Do not install over gypsum board thicker than 5/8".

WARNING

Wood stud wall.

ENG Concrete/Cinder block.

ENG

4a-1 Use stud nder to locate and

mark stud center lines.

ENG

82019-06-14 #:150-9227-1

4a-2

⅛"

Mark mounting holes on stud center lines.

Mounting holes should be positioned 1/8" under

the horizontal cover line.

ENG

cover line

ENG

cover line

ENG

92019-06-14 #:150-9227-1

4a-4

3/8"

(10mm)

4a-3

5/32"

(4mm)

C (2)

Mounting hole must center on stud.

ENG

2.5"

(64mm)

5/32"

(4mm)

Drill mounting holes into supporting surface

(2.5" (64mm) minimum depth required).

ENG

Level wallplate. Install using wood screws provided.ENG

Maximum 80 in. • lb (9 N.M.).

ENG

10 2019-06-14 #:150-9227-1

4b-1

4b-2

5/16"

(8mm)

ENG - When installing Peerless wall mounts on a concrete wall, the wall must be at least 8" thick with a minimum

compressive strength of 2000 psi. When installing Peerless wall mounts on a cinder block wall, the cinder blocks

must meet ASTM C-90 specications and have a minimum nominal width of 8". Do not drill into mortar joints!

Be sure to mount in a solid part of the block, generally 1" (25 mm) minimum from the side of the block. It is

suggested that a standard electric drill on slow setting is used to drill the hole instead of a hammer drill to avoid

breaking out the back of the hole when entering a void or cavity. Never attach concrete expansion anchors to

concrete or cinder block covered with plaster, drywall or other nishing material.

WARNING

Mark mounting holes on stud center lines.

Mounting holes should be positioned 1/8" under

the horizontal cover line.

ENG

cover line

ENG

2.5"

(64mm)

5/16"

(8mm)

Do not drill into mortar joints.

ENG

Drill mounting holes into supporting surface

(2.5" (64mm) minimum depth required).

ENG

cover line

ENG

⅛"

cover line

ENG

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels peerless-AV Support et étagère

peerless-AV

peerless-AV ACC-SPARK70 Manuel utilisateur

peerless-AV

peerless-AV MOD-PRSKIT100-B Manuel utilisateur

peerless-AV

peerless-AV MOD-CPI Manuel utilisateur

peerless-AV

peerless-AV ACC-SPARK55 Manuel utilisateur

peerless-AV

peerless-AV SMARTMOUNT Series Manuel d'instructions

peerless-AV

peerless-AV PA740-S Mode d’emploi

peerless-AV

peerless-AV ACC-SB2 Manuel utilisateur

peerless-AV

peerless-AV DS-LEDA27 Series Manuel utilisateur

peerless-AV

peerless-AV SA752PU Mode d’emploi

peerless-AV

peerless-AV ACC185 Manuel utilisateur

peerless-AV

peerless-AV DCT500 Manuel utilisateur

peerless-AV

peerless-AV SA746P Manuel utilisateur

peerless-AV

peerless-AV SR598-HUB2 Manuel utilisateur

peerless-AV

peerless-AV MSA-101 Mode d’emploi

peerless-AV

peerless-AV CMJ500R1 Manuel utilisateur

peerless-AV

peerless-AV MOD-FCSKIT300-B Manuel utilisateur

peerless-AV

peerless-AV ACC973 Manuel utilisateur

peerless-AV

peerless-AV SMARTMOUNT SFP680 Manuel utilisateur

peerless-AV

peerless-AV SP840 Manuel utilisateur

peerless-AV

peerless-AV DS-MBZ647L Manuel utilisateur

peerless-AV

peerless-AV SR560G Manuel utilisateur

peerless-AV

peerless-AV HA747PU Manuel utilisateur

peerless-AV

peerless-AV PWA-14 Manuel utilisateur

peerless-AV

peerless-AV Smartmount ST24D Mode d’emploi

Manuels Support et étagère populaires d'autres marques

Salamander

Salamander Acadia AC/W/L400/WH Manuel utilisateur

Fohhn

Fohhn VAT-09 Guide de l'utilisateur

ricoo

ricoo FS0522 Manuel utilisateur

AMSOIL

AMSOIL BMK-22 Guide rapide

Kargo Master

Kargo Master 48220 Manuel utilisateur

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Manuel utilisateur

ricoo

ricoo S1222 Manuel utilisateur

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Manuel utilisateur

VidaBox

VidaBox VB MNT FFS2 Manuel utilisateur

Welch Allyn

Welch Allyn 48960 Manuel utilisateur

Arkon

Arkon CM035-ST-2 Manuel utilisateur

PROEL

PROEL PLWIN60C Manuel utilisateur

Agilent Technologies

Agilent Technologies E2609B Manuel utilisateur

Mustang

Mustang MV-ARM4 Manuel utilisateur

Mounting Solutions

Mounting Solutions WRM-320 Manuel utilisateur

Pyle

Pyle PMKSPAD1 Manuel utilisateur

ShelterIt

ShelterIt 21208 Manuel utilisateur

SPL

SPL RackPack?4 1040 Manuel utilisateur

peerless-AV KLR62232 Manuel utilisateur

Manuels Support et étagère populaires d'autres marques