Smart Sensor Adapter Case (S-ADAPT-6)
12441-B MAN-S-ADAPT-6
Items included:
•One case
•One plastic case cover
•Four mounting feet
•Four small Phillips-head screws (for attaching mounting feet
to case)
•Four long Phillips-head screws (for attaching case to wall)
•Six cable guide plugs
The smart sensor adapter case allows you to connect up to six
smart sensors in a moisture-resistant enclosure to a single smart
sensor extension cable back to a HOBO® station. The case is
tested to NEMA 4X (IP65) Standards for protection from
corrosion, wind-blown dust and rain, splashing water, and hose-
directed water.
Assembly Instructions
This section explains how to connect smart sensors in the case, including the tools required for assembly.
To complete the assembly, you will need the following items:
•Phillips head screwdriver
•Pen, pencil, or other blunt instrument (for removing cable guide)
•Adjustable 8 inch or 10 inch crescent wrench (for tightening dome nut)
•Utility or pocket knife (for removing anti-snag flap on connector and cutting cable guide)
Follow this procedure for each access point in the case:
1. Remove anti-snag flap on cable connector. Some sensors have an anti-snag flap on the connector, as shown below. If your sensor has
this flap, remove it with a knife so that the sensor connector can fit through the cable access hole in the case.
2. Unscrew the dome nuts from the cable access points.
3. Remove rubber cable guides from the cable access points. You may need to push the cable guide out using a pen (capped end), pencil
(eraser end), or other blunt instrument.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
