Omega Engineering BVLS Series Manuel utilisateur

BVLS Series

Limit Switch for BVP70, BVPS70, BVP80 &

BVPS80 Series Actuated Ball Valves

2

3

MATERIALS OF CONSTRUCTION

BODY / COVER: Aluminium with TeflonImprenated Hard Anodized (PolyLube)Surfaces

PROBES: 316 Stainless Steel

SEALS - COVER, PROBES: Buna N

RATINGS / SPECIFICATIONS

TEMPERATURE: 10 F to 180 F

CONDUIT CONNECTION: 1/2” NPT

ELECTRICAL RATING: 10 amp. 250VAC maximum; 1/2 amp. 125VDC; 1/4 amp. 250VDC; 5 amp.

125VAC lamp load. Note: each pole must be the same polarity to utilize these ratings.

MICROSWITCHES: Mechanical S.P.D.T. (Single Pole Double Throw)

INTERNAL WIRING CONNECTIONS: Screw Clamp

NEMA STANDARDS: NEMA 1 (General Purpose); NEMA 4 (Watertight & Dusttight); NEMA 7 (Haz-

ardous Locations, Class I Groups B, C, & D); NEMA 9 (Hazardous Locations, Class II, Groups E, F, &

G); NEMA 12 (Oiltight and Driptight); and NEMA 13 (Oiltight and Dusttight).

UL LISTINGS: Industrial Control Equipment for use in Hazardous Locations, Class I, Groups B,C, & D

and Class II, Groups E, F, & G

MAINTENANCE

The BVLS normally requires no maintenance. However, in certain situations the switch adjustment

screws may require some attention to either advance or retard the cam actuated switch point. This

enables precise adjustment of the switch timing throughout the life of the unit.

Switch Adjustment

Screws

Terminal Strip

Electrical Schematic as

Shown - Inside Cover

4

Attachment of Limit Switch / NAMUR Mounting Pad

1. Remove the position indicator from atop the actuator and secure

the NAMUR 30 Shaft Coupling to the actuator Shaft Extension with

the #6-32 Set Screw using a medium strength (nonpermanent) thread

locker (not included in mounting kit).

2. Place the Limit Switch / NAMUR Mounting Pad on top of the actua-

tor. Be sure that the lower flats of the NAMUR 30 Shaft Coupling are

oriented such that they align with the Limit Switch Mounting holes on

the Limit Switch / NAMUR Mounting Pad.

3. Fasten the Limit Switch / NAMUR Mounting Pad to the actuator

using the (2) Mounting Bracket Screws.

4. Slide the position indicator over the NAMUR 30 Shaft Coupling

until it ‘snaps’ into place just above the bracket.

Attachment of Limit Switch

1. Fit the bushings, which extend from the Limit Switch housing, into the matching holes in the mounting pad. Push

switch housing against pad and verify that switch body touches pad. Secure switch body to pad with two #10-24

setscrews using a medium strength (nonpermanent) thread locker (not included in mounting kit). Note: Hex wrench sup-

plied with Mounting Kit.

Wiring Instructions

1. Route the wire to be terminated through the conduit hub and up

through the access space to the terminal block.

2. Strip insulation back 1/4”, insert the stripped ends directly into the

proper terminal clamps and tighten screws.

3. Internal interconnections between terminal-block and switches are

diagrammed inside the Limit Switch Cover.

Note: If the Switch is installed in a hazardous location i.e. where

flammable vapors or dust are present in the atmosphere, replace

the cover and tighten securely before connecting the electrical sup-

ply circuit. If necessary, a screwdriver shank or similar tool may be

engaged in the cover wrenching lugs to assist removal and replace-

ment.

Wiring Specifications

Switch Ratings

AC 250 volts; 10 amps

DC 250 volts; 0.25 amps

125 volts; 0.50 amps

Lamp Load 125 volts; 5 amps

Wire Size

#12 AWG Max.

#24 AWG Min.

65

M-4153/0405

M-4153/0405

6

Ce manuel convient aux modèles suivants

4

Table des matières

Autres manuels Omega Engineering Changer

Omega Engineering

Omega Engineering LV-60 Manuel utilisateur

Omega Engineering

Omega Engineering LV-1201 Manuel utilisateur

Omega Engineering

Omega Engineering PSW32 SERIES Manuel utilisateur

Omega Engineering

Omega Engineering PSW400 Manuel utilisateur

Omega Engineering

Omega Engineering PSW18H Seriers Manuel utilisateur

Omega Engineering

Omega Engineering LVP-51 LVP-51 Series Manuel utilisateur

Omega Engineering

Omega Engineering FSW-410 Series Manuel utilisateur

Omega Engineering

Omega Engineering LVCN700 Series Manuel utilisateur

Omega Engineering

Omega Engineering PSW2000 Manuel utilisateur

Omega Engineering

Omega Engineering PSW1000 Manuel utilisateur

Omega Engineering

Omega Engineering PSW495B Manuel utilisateur

Omega Engineering

Omega Engineering LV-510 Series Manuel utilisateur

Omega Engineering

Omega Engineering LVH-200 Series Manuel utilisateur

Omega Engineering

Omega Engineering PSW141 series Manuel utilisateur

Omega Engineering

Omega Engineering 430 Manuel utilisateur

Omega Engineering

Omega Engineering LVUN-600 Manuel utilisateur

Omega Engineering

Omega Engineering PSW-180 Series Manuel utilisateur

Omega Engineering

Omega Engineering FSW-50 Series Manuel utilisateur

Omega Engineering

Omega Engineering LVU-230 Manuel utilisateur

Omega Engineering

Omega Engineering LVU-700 Manuel utilisateur

Omega Engineering

Omega Engineering LVR300 Series Manuel utilisateur

Omega Engineering

Omega Engineering LVK-10 Manuel utilisateur

Omega Engineering

Omega Engineering LV-1101 Manuel utilisateur

Omega Engineering

Omega Engineering PSW490B Manuel utilisateur

Manuels Changer populaires d'autres marques

URC

URC Total Control MFS-8 Manuel utilisateur

Azbil

Azbil HPQ-D11 Manuel utilisateur

Sony

Sony DFS-900M Manuel utilisateur

SICK

SICK i17S Manuel utilisateur

F&F

F&F SZR-277 Manuel utilisateur

Shure

Shure UAMS/BK Manuel utilisateur

Dräger

Dräger X-zone Switch Off Manuel utilisateur

Asco

Asco Joucomatic 349 Series Manuel utilisateur

BT

BT Mini Hub Manuel utilisateur

D-Link

D-Link DES-1226G Manuel utilisateur

Johnson Controls

Johnson Controls FS80-C Manuel utilisateur

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Manuel utilisateur

MicroNet

MicroNet SP1200A Manuel utilisateur

Ruijie

Ruijie RG-PF2920 Series Manuel d'installation et d'exploitation

Altinex

Altinex DA1914SX Manuel utilisateur

MiLAN

MiLAN MIL-SM2401M Manuel utilisateur

RJM

RJM MASTERMIND PBC/6X Manuel utilisateur

Atlas

Atlas MMK-KVM8 Manuel utilisateur