Directory
Directory___________________________________________________________________________________________________ 3
Indication and Use of the instructions ___________________________________________________________________________ 3
Safety instructions ___________________________________________________________________________________________ 3
Mechanical Data ____________________________________________________________________________________________ 4
Load diagram for static load capacity CS-3000 neXt ________________________________________________________________ 4
Installation and adjustment ___________________________________________________________________________________ 4
Mounting to plant or machine _______________________________________________________________________________ 4
Tube mounting vertically____________________________________________________________________________________ 5
Tube mounting horizontally _________________________________________________________________________________ 5
Vertical tube adjustment (also possible later) ___________________________________________________________________ 6
Horizontal tube adjustment (also possible later) _________________________________________________________________ 6
Mounting to enclosure _______________________________________________________________________________________ 7
Mounting to control enclosure by using coupling or elbow coupling ________________________________________________ 7
Mounting to control enclosure by using adapter (narrow sections) __________________________________________________ 7
Mounting to control enclosure by using panel coupling___________________________________________________________ 8
Screwing the clamping lever___________________________________________________________________________________ 8
Modification of firmness ______________________________________________________________________________________ 9
Joint cap mounting and dismounting ___________________________________________________________________________ 9
Attitude of the tightness of torque (M)___________________________________________________________________________ 10
Accessories_________________________________________________________________________________________________ 11
Tube Cutoff_________________________________________________________________________________________________ 14
Earthing ___________________________________________________________________________________________________ 15
Earthing example____________________________________________________________________________________________ 17
The sequence of the chapters is not necessarily the operation or assembly sequence.
Not all chapters apply for each component.
Indication:
Pick out the pictogram for the corresponding component shown on the title page
You will see in the chapters pictograms for which the mounting step applies
Mounting starts with the plant, machine or wall mounting and the corresponding chapter
Do not reach into the tubes
The excessive crushing, stretching and bending of power lines has to be avoided.
The power line system has to be checked for abrasion points regularly.
Mounting or the electrical connection of the power line system must be carried out by a qualified electrician.
Do not damage seals during installation as otherwise the technical characteristics cannot be complied with.
When using panel coupling components, always ensure that the stability of the mounting surface is suitable
for mounting.
The coupling components are designed for mounting centrally on the control enclosure.
Off-center installation is not permitted.
The tightening torques of the screw connections should be inspected on a regular basis.
Indication and Use of the instructions
Safety instructions
Attention
Attention
Attention
Attention
Attention
Attention
Attention
Attention
