—7—
General Safety Rules –Save These Instructions–
5. AERO®STAND SAFETY
!DANGER
Read and understand the Aero® Press operations
manual before using the press in the Aero Stand.
!CAUTION
Avoid pinch points during the assembly
and in operation. Exercise caution when
moving weights or liing and positioning
ofcomponents.
Exercise care to avoid unbalanced component
conditions during assembly.
Do not cut or kink the liing cables during
handling, assembly, or operation of the
AeroStand.
!WARNING
Two persons are required for assembly of the
Aero Stand. Portions of the process are dicult
for one person to perform without risk of injury.
Ensure that Aero Press is secure in stand prior
tooperation.
Do not move the press stand to a dierent
location while the press is installed.
Do not exceed weight capacity of the Aero
Stand cradle. e Aero Stand retrot kit is
designed to accommodate the 625, 925, and
1225, as well as with the 900, 1200 and 1500.
Ensure that the weight pins are installed
securely in the proper position before operating
the stand.
Ensure that the vertical column door is closed
and latched during operation of the stand.
Avoid raising/lowering of the upper beam with
excessive speed.
4. SERVICE AND MAINTENANCE
!CAUTION
When servicing a tool, use only original
replacement parts. Use of unauthorized parts or
failure to follow Maintenance Instructions, may
create a risk of injury.
Do not wipe plastic parts with solvent. Solvents
such as gasoline, thinner, benzene, carbon
tetrachloride, and alcohol may damage and
crack plastic parts. Do not wipe them with
such solvents. Wipe plastic parts with a so
cloth lightly dampened with soapy water and
drythoroughly.
!WARNING
Only qualied repair personnel must perform
tool service. Service or maintenance performed
by unqualied personnel could result in a risk
ofinjury.
NEVER use a tool, which is defective or
operating abnormally. If the tool appears to be
operating unusually, making strange noises,
or otherwise appears defective, stop using it
immediately and arrange for repairs.
Maintain tools with care. Keep machine parts
clean. Properly serviced tools are less likely
to bind or clutter material and are easier
tocontrol.
