Nordcap M95 Manuel utilisateur
Display cooler M95
GB Instructions for use
DE Bedienungsanleitung
FR Mode d’emploi
DK Brugsanvisning
2
GB
As the appliance contains a ammable
refrigerant, it is essential to ensure that the
refrigerant pipes are not damaged.
The quantity and type of the refrigerant
used in your appliance is indicated on
the rating plate.
Standard EN378 species that the room in
which you install your appliance must have
a volume of 1m³ per 8 g of hydrocarbon
refrigerant used in the appliances. This is
to avoid the formation of ammable gas/air
mixtures in the room where the appliance is
located in the event of a leak in the refriger-
ant circuit.
WARNING:
Keep ventilation openings in the applian-
ce’s cabinet or in the built-in structure clear
of obstruction
WARNING:
Do not use other mechanical devices or
other means to accelerate the defrosting
process than those recommended by the
manufacturer
WARNING:
Do not damage the refrigerant system
WARNING:
Do not use electrical appliances inside the
refrigerated storage compartment, unless
they are of a type recommended by the
manufacturer
WARNING:
Do not expose the appliance to rain
WARNING:
This appliance is not intended for use by
children and above and persons with redu-
ced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe
way and understand the hazards involved
WARNING:
Do not store explosives, such as aerosol
cans with ammable propellants in the unit.
WARNING: Danger risk of re or explosion
if ammable refrigerant are
used. To be repaired only by
trained personnel.
WARNING:
Cleaning and user maintenance shall not be
made by children without supervision
● Always keep the keys in a separate place
and out of reach of children
● Before servicing or cleaning the appli-
ance, unplug the appliance from the
mains or disconnect the electrical power
supply
● If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or similarly qualied persons in
order to avoid a hazard
●Relevant for Australia: Supply cord
tted with a plug complies with AS/NZS
3112.
●Please note that changes to the appli-
ance construction will cancel all warranty
and product liability
Warning
3
GB
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance. Keep the instructions for future
reference. On receipt, check to ensure that
the appliance has not been damaged dur-
ing transport. Transport damage should be
reported to the local distributor before the
wine cooler is put into use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth. If the appliance has been laid
down during transport, or if it has been
stored in cold surroundings (colder than
+5°C), it must stabilise in an upright position
for at least one hour before being switched
on.
Warning ..................................................2
Before use ..............................................3
Get to know your Dispaly Cooler. ...........4
Eletrical connection ................................5
Installation and start-up ..........................5
Change of hinge side..............................8
Operation and function ...........................9
Defrosting,
cleaning and maintenance....................10
Removing the shelves ..........................10
Fault nding .......................................... 11
Warranty, spare parts and service ........12
Disposal ................................................13
Contents Before use
4
GB
g.1
Get to know your Dispaly cooler
Rating plate (on the back)
Lighting
Control panel
Shelf
Kick plate
Adjustable feet
5
GB
Installation and start-up
Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Room temperature
The climate class is stated on the rating
plate (see g. 1 on page 4 and on page
12).
Note that the appliance operates best at
room temperatures from 10°C to 32°C.
Electrical connection
Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2006/95 EEC. and Electromagnetic Com-
patibility Directive 2004/108/EC
The socket should be freely accessible.
Connect the appliance only to 220/240 V
/ 50Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a
technician only.
The rating plate provides various techni-
cal information as well as type and serial
number.
6
GB
The appliances can be installed as built-in
units in kitchen elements or be placed free-
standing (g. 3).
At built-in condition ensure sufcient airow
through the kitchen base in front of the ap-
pliance. Individual air duct clearance must
be at least 5 mm.
Along with your new cabinet is a replace-
able kick plate which can be xed with the
two screws. These two screws are located
in the accessories
NOTE: The kick plate should not be
installed if the unit installed behind a
kitchen shelf.
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame
or similar. It is important that the appliance
be absolutely level. It can be levelled by
screwing the adjustable feet at the front of
the appliance up or down (g. 2).
Use a spirit level to check that the appliance
is absolutely level sideways.
g. 2
g. 2
7
GB
g. 3
If needed there is a kit in the accessories
bag, for xing the cabinet up against a table
top.
g. 4
8
GB
Change of hinge side
The door can be changed from right-hinged to left-hinged and vice versa as follows:
1) Screw 2) Bottom hinge, right 3) Door pin 4) Top hinge, right 5) Door
6) Cabinet 7) Top hinge, left 8) Bottom hinge, left
● Ensure that the cabinet is not connected
to the mains and place the cabinet on the
back
● Dismount the screws (1) SUPPORT THE
DOOR! See g. 5.1
● Dismount the door by pulling it forwards
and free from the top hinge. See g. 5.2
● Dismount the right top hinge and save it
for later use. See g. 5.3
● Mount the left top and bottom hinge en-
closed (7 + 8). See g. 5.4
● Remount the door pin previously dis-
mounted (3) in the bottom hinge
●Mount the door in the top hinge (7)
towards the door pin (3), tighten the door
pin (1)
● Lift up the cabinet again and wait 1 hour
before connecting it to the mains to avoid
oil in the cooling system
g. 5.1
g. 5.4g. 5.3
g. 5.2
9
GB
Operation and function
● LIGHT
Control the interior light ON/OFF
● RUN
When it’s ON, the cooling system runs.
● POWER
control this appliance turn on/off. ( press
and hold this buttons for approximately 3
seconds)
● “UP” BUTTON
Press once the “UP” button, the tempera-
ture will raise 1
● “DOWN” BUTTON
Press once the “DOWN” button, the tempe-
rature will lower 1
● “DISPLAY”
Display the actual temperature indoor.
The temperature setting can be adjusted
from 3° to 18° C.
The temperature preset at the factory is 6°C
g. 6
10
GB
Automatic defrosting
The wine cooler is defrosted automatically.
Defrost water runs through a pipe and is
collected in a tray above the compressor
where the heat generated by the compres-
sor causes it to evaporate.
Cleaning
Before cleaning the appliance, unplug it
from the main supply. The cabinet is best
cleaned using warm water (max. 65°C) with
a little mild detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly. Never
use sharp or pointed implements. Avoid un-
necessary cleaning of the wooden shelves,
as these are made of untreated natural
material. Cleaning agents may discolour the
shelves.
The sealing strip around the door must be
cleaned regularly to prevent discolouration
and prolong service life. Use clean water.
After cleaning the sealing strip, check that it
continues to provide a tight seal.
Dust collecting on the condenser under-
neath the cabinet, on the compressor and
in the compressor compartment is best
removed using a vacuum cleaner.
Defrosting, cleaning, and maintenance.
Replacing the lighting
Light-emitting diodes designed to last the
entire service life of the appliance are
used. If it, however, becomes necessary
to replace the light source, please call for
service.
CLASS 1 LED PRODUCT
Ce manuel convient aux modèles suivants
2
Table des matières
Langues :
Autres manuels Nordcap Accessoires
