Nordcap M85 Manuel utilisateur
Bottle Cooler M85
GB Instructionsforuse
DE Bedienungsanleitung
FRModed`emploi
DKBrugsanvisning
2
GB
In case this appliance contains hydrocar-
bon refrigerant please refer to guidelines
listed below.
As the appliance contains a ammable
refrigerant, it is essential to ensure that the
refrigerant pipes are not damaged.
Standard EN378 species that the room in
which you install your appliance must have
a volume of 1m³ per 8 g of hydrocarbon
refrigerant used in the appliances. This is
to avoid the formation of ammable gas/
air mixtures in the room where the appli-
ance is located in the event of a leak in the
refrigerant circuit. The quantity of the refrig-
erant used in your appliance is indicated on
the rating plate.
WARNING: Keep ventilation openings in
the appliance’s cabinet or in
the built-in structure clear of
obstruction.
WARNING: Do not use other mechanical
devices or other means to ac-
celerate the defrosting process
than those recommended by
the manufacturer
WARNING: Do not damage the refrigerant
system
WARNING: Do not use electricalappli-
ances inside the refrigerated
storage compartment, unless
they are of a type recommend-
ed by the manufacturer
WARNING: Do not expose the appliance
to rain
WARNING: This appliance is not intended
for use by young children or
inrm persons unless they have
been adequately supervised by
a responsible person to ensure
that they can use the appliance
safely. Young children should
be supervised to ensure that
they do not play with the appli-
ance
● Always keep the keys in a separate place
and out of reach of children
● Before servicing or cleaning the appli-
ance, unplug the appliance from the
mains or disconnect the electrical power
supply
● If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or similarly qualied persons in
order to avoid a hazard
● RelevantforAustralia: Supply cord
tted with a plug complies with AS/NZS
3112.
● Frost formation on the interior evaporator
wall and upper parts is a natural phenom-
enon. Therefore, the appliance should
be defrosted during normal cleaning or
maintenance
● Please note that changes to the appli-
ance construction will cancel all warranty
and product liability
Warning.
3
GB
Warning.
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance. Keep the instructions for future
reference. On receipt, check to ensure that
the appliance has not been damaged dur-
ing transport. Transport damage should be
reported to the local distributor before the
wine cooler is put into use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth. If the appliance has been laid
down during transport, or if it has been
stored in cold surroundings (colder than
+5°C), it must stabilise in an upright position
for at least one hour before being switched
on.
Warning ..................................................2
Before use ..............................................3
Technical data.........................................3
Get to know your bottle cooler. ...............4
Installation and start-up ..........................5
Change of hinge side..............................6
Operation and function ...........................7
Defrosting,
cleaning and maintenance......................8
Removing the shelves ............................8
Fault nding ............................................9
Warranty, spare parts and service ........10
Disposal ................................................ 11
Thankyou for purchasing your new
bottle cooler. Please note that these instruc-
tions apply to all bottle coolers in the Com-
pact wine range. Illustrations and ttings
may therefore not necessarily correspond
exactly to your model.
Contents Beforeuse.
Technicaldata.
This device complies with relevant EU
directives including Low Voltage Directive
2006/95 EEC. and Electromagnetic Com-
patibility Directive 2004/108/EC
The rating plate provides various techni-
cal information as well as type and serial
number.
4
GB
Rating plate (on the back)
Lighting
Control panel
Door handle
Shelf
Adjustable feet
Gettoknowyourbottlecooler.
g.1
5
GB
Gettoknowyourbottlecooler. Installationandstart-up.
Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
M85 is only for free-standing and sufcient
free air around the appliance must be
ensured.
Onlyindooruse.
Roomtemperature
The climate class is stated on the rating
plate. This species the optimum room
temperature.
Climate
class
Optimumroomtempera-
ture
SN +10 ºC to +32 ºC
N +16 ºC to +32 ºC
ST +18 ºC to +38 ºC
T +18 ºC to +43 ºC
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame
or similar. It is important that the appliance
be absolutely level. It can be levelled by
screwing the adjustable feet at the front of
the appliance up or down (g. 2).
Use a spirit level to check that the appliance
is absolutely level sideways.
g. 2
6
GB
The door can be changed from right-hinged to left-hinged and vice versa as follows:
Changeofhingeside-M85.
1. Rubber plug 2. Screw 3. Hinge cover 4. Screw 5. Top hinge
6. Door 7. Screw 8. Bottom hinge 9. Cabinet foot
● Ensure that the cabinet is not connected
to the mains
● Remove the rubber plugs (1). See g. 5.1
● Remove the screws (2) and take off the
hinge cover (3)
● Remove the 3 screws (4) which hold the
top hinge and lift off the top hinge (5)
SUPPORT THE DOOR! See g. 5.2
● Lift off the door (6) and place the cabinet
on the back
● Remove the 3 screws (7) which hold the
bottom hinge (8) . See g. 5.3
● Dismount the cabinet foot (9) from the ca-
binet and remount it on the opposite side
● Move the bottom hinge enclosed to the
left side and mount the low cabinet foot in
this one
● Mount the bottom hinge in the left side
using the 3 screws (7)
● Mount the door on the bottom hinge
● Mount the top hinge, hinge cover, and
rubber plugs. See g. 5.4.
● Mount the door handle on the opposite
side
● Lift up the cabinet again and wait 1 hour
before connecting to the mains to avoid
oil in the cooling system
Abb. 5.3 Abb. 5.4
Abb. 5.1 Abb. 5.2
7
GB
RUN
Indicator light illuminates to signify the
cooling mode is currently in operation.
LIGHT
To control the inner light on/off
POWER
To control this appliance turn on/off
(press and hold this button for approxi-
mately 3 seconds)
DISPLAY
Displays the internal temperature.
TEMP.SET
Displays the selected temperature.
Operationandfunction
The temperature that you desire will in-
crease or decrease in 1°C steps by pushing
the UP or DOWN button. The setting range
will be from 2°C to 10°C.
1. Rubber plug 2. Screw 3. Hinge cover 4. Screw 5. Top hinge
6. Door 7. Screw 8. Bottom hinge 9. Cabinet foot
8
GB
Automaticdefrosting
The bottle cooler is defrosted automatically.
Defrost water runs through a pipe and is
collected in a tray above the compressor
where the heat generated by the compres-
sor causes it to evaporate.
Cleaning
Before cleaning the appliance, unplug it
from the main supply. The cabinet is best
cleaned using warm water (max. 65°C) with
a little mild detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly. Never
use sharp or pointed implements. Avoid un-
necessary cleaning of the wooden shelves,
as these are made of untreated natural
material. Cleaning agents may discolour the
shelves.
The sealing strip around the door must be
cleaned regularly to prevent discolouration
and prolong service life. Use clean water.
After cleaning the sealing strip, check that it
continues to provide a tight seal.
Dust collecting on the condenser under-
neath the cabinet, on the compressor and
in the compressor compartment is best
removed using a vacuum cleaner.
Replacingthelighting
Light-emitting diodes designed to last the
entire service life of the appliance are
used. If it, however, becomes necessary
to replace the light source, please call for
service.
Defrosting,cleaning,andmaintenance.
Removingtheshelves
Push the shelf all the way back and tip it. It is
now possible to remove the shelf.
CLASS1LEDPRODUCT
9
GB
Faultnding.
Fault Possiblecause Remedy
The appliance does
not work
The appliance is switched off.
Power failure; the fuse is blown;
the appliance is not plugged in
correctly.
Press the on/off switch.
Check that power is connected.
Reset the fuse.
Water collects in
the bottom of the
cabinet.
The defrost water pipe is
blocked.
Clean the defrost water channel
and the drain hole on the rear
wall of the cabinet.
Vibration or
bothersome noise.
The appliance is not level.
The appliance is resting against
other kitchen elements.
Containers or bottles inside the
cabinet are rattling against one
another.
Level the appliance using a spirit
level.
Move the appliance away from
the kitchen elements or appli-
ances it is in contact with.
Move containers and/or bottles
apart.
Compressor runs
continuously.
High room temperature. Ensure adequate ventilation.
10
GB
Warranty,sparepartsandservice.
Warrantydisclaimer
Faults and damage caused directly or
indirectly by incorrect operation, misuse,
insufcient maintenance, incorrect building,
installation or mains connection. Fire, ac-
cident, lightening, voltage variation or other
electrical interference, including defective
fuses or faults in mains installations are not
covered by the warranty.
Repairs performed by others than approved
service centres and any other faults and
damage that the manufacturer can sub-
stantiate are caused by reasons other than
manufacturing or material faults are not
covered by the warranty.
Please note that changes to the construc-
tion of the appliance or changes to the
component equipment of the appliance will
invalidate warranty and product liability, and
the appliance cannot be used lawfully. The
approval stated on rating plate will also be
invalidated.
Transport damage discovered by the buyer
is primarily a matter to be settled between
the buyer and the distributor, i.e. the dis-
tributor must ensure that such complaints
are resolved to the buyer’s satisfaction.
Before calling for technical assistance,
please check whether you are able to rectify
the fault yourself. If your request for assist-
ance is unwarranted, e.g. if the appliance
has failed as a result of a blown fuse or
incorrect operation, you will be charged
the costs incurred by your call for technical
assistance.
Spareparts
When ordering spare parts, please state
the type, serial and production numbers of
your appliance. This information is given on
the rating plate. The rating plate contains
various technical information, including type
and serial numbers.
Note: Always use approved service centres
when your appliance is to be repaired or
replaced!
MO DEL:M 85 SLIMLINE
Bottle Cooler
0.6A
40Kg
R600a
N
30g
0.7W
96W
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels Nordcap Accessoires
