niu NQi GTS Manuel utilisateur
USER MANUAL
V 1.0
CONTENTS
Attach the
SN Code here
The SN Code of your scooter.
Please see P.6 for detailed information.
General Notice
Precautions
Safety Notice
Installation Guide
Downloading the APP
Parts Info
Dashboard Display Info
Operation Guide
Battery Use and Maintenance Guide
DOs and DON'Ts while Riding
Maintenance and Repair
Regular Maintenance Checklist
Technical Parameters
Maintenance Record
01
02
03
04
06
07
09
12
17
23
25
28
33
36
General Notice Precautions
Please read this User Manual carefully for proper operation before riding the scooter.
For your safety, please check whether the parts are in good condition according to this User
Manual before riding. Contact your dealer in time in case of any problems.
Please follow the traffic laws. Slow down on slippery roads in bad weather to allow greater
braking distance for your safety.
Please pay attention to deep water. It may cause rusting or failure of the motor, battery, or
other parts if water level reaches wheel axle.
Do not dismantle the scooter on your own. Please contact your dealer for replacement or
purchase of original parts.
For others' safety and preventing unnecessary damage to your scooter, do not lend your
scooter to those who can’t operate.
For more produce information or maintenance need, please visit our
website:www.niu.com/en
Rider and Passenger
This scooter is not designed for a ride of more than 2 persons.
Road Conditions
This scooter is not designed for off-road use.
This User Manual should be deemed as a permanent document of this scooter. If this
scooter is transferred to others, this User Manual should also be handed over to the
new owner.
Reproduction or reprint of any part of this User Manual is strictly prohibited.
ATTENTION: Do not exceed speed limit and apply brakes cautiously. Always use side
stand or central stand when parking.
0201
WARNING: Failure to follow the instructions herein may lead to serious casualties,
personal injury, or scooter damage.
Safety Notice Installation Guide
Using a helmet and protective goggles is strongly advised.
You are advised to take proper training or exercise before using on open roads.
Please follow the Operation Guide (P.12) to fully understand how to properly operate the
scooter.
It should be noted that the braking distance in bad weather will be much longer. Please avoid
braking on paint markers, manhole covers, and oil stains to prevent slipping. Pay extra
attention when riding through railway crossings, junctions, tunnels, and bridges. Slow down
if road conditions are unclear.
Do not use high beam indiscriminately. Continuous use of high beam may disturb the vision
of other drivers and pedestrians.
Do not use mobile phones or other electronic devices which may draw your attention while
riding.
Do not change the lane without signaling. Changing the lane at will is one of the major
causes for accidents. When you need to change the lane, remember to switch on the Turn
Signal Indicator first. Always check the vehicles approaching from behind before changing
the lane.
0403
Insert the key to the main lock and turn to the icon
of "OPEN" as shown in the left figure.
Step 1
Open the saddle to take out the key box, windshield
package (with rubber pads and standard parts),
and installation tools.
Insert the key into the keyhole in the rear storage
and turn it to open the battery compartment. Take
out the charger and rearview mirrors package
inside.
Step 2
0605
Adjust the rearview mirrors to an appropriate
position and then tighten nuts on the rearview
mirror with a spanner. Properly set the dust cover.
Install the right rearview mirror in the same way.
Step 4
Align the windshield rubber part with the
windshield holes and then install it.
Tighten the two screws with the screwdriver to
secure the windshield.
Step 5
Step 6
Downloading the APP
Step 1
Step 2
Step 3
Functions such as checking battery level, locating, and management can be implemented on the
electric scooter through the app.
NOTE:
The mobile phone system is required to be at least Android 4.0 or iOS 8. Make sure that the
mobile phone has been connected to the Internet when running the app (Wi-Fi / 2G / 3G / 4G).
Scan the QR code below to download the APP
titled Niu E-Scooter.
Run Setup after downloading and register.
Please scan the QR code on the inside of cover
page for app registration.
Take out the rearview mirrors and check them
carefully. Install the left rearview mirror into the
mounting hole on the left brake lever and turn it
clockwise. The bolt shall be screwed in for more
than 15 mm.
Step 3
08
07
Parts Info
Right Combination
Switch
Foot PegsHandrail
Reflector
Turn Signal
Indicator
Headlight
Front
Storage
Left Combination
Switch
Rear Storage
Side Stand Central Stand
Taillight
Battery
Compartment
Rearview
MirrorWindshield
1009
Left Turn Indicator The Left Turn Indicator is on.
The Right Turn Indicator is on.
The High Beam is on.
Right Turn Indicator
Ready Indicator In Riding Mode.
Battery level less than 10%.
Now is 10:00
Ideal energy consumption status.
The scooter is in Cruise Mode.
Energy is being recycled from braking.
The Diagnostic Code is 30.
Please see the “Troubleshooting List”.
No flashing: Signal strong.
Bars are falshing: Signal weak.
Entire icon flashing: No signal.
Low Battery Indicator
Time
Economic Mode
GPS Signal
GSM Signal
Cruise Mode
Diagnostic Code
Energy Recycling Status
High Beam
Dashboard Display Info
Left Turn Indicator Right Turn IndicatorReady Indicator
Low Battery IndicatorHigh Beam
Time
Riding Mode
Cruise Mode
Energy
Recycling
GPS Signal
GSM Signal
Charging
Percentage
Speed
Diagnostic Code
Battery Bar
Charging
Distance Travelled
Battery Percentage&
Remaining Charging Time
Instant
Electric Current
Economic Mode
1211
USB Charging Port
Main Lock
Main Lock
Hook
Front Storage
Open Saddle Turn on the Scooter
Push the key and
turn to LOCK
position to lock the
Steering Handlebar
OffOpen Saddle
to access
Rear Storage
Lock the
Steering
Handlebar
On
Battery Bar Current battery level is 80~89%.
Current battery level is 85%.
The remaining charging time is 3.2 h
(using scooter charging port).
Battery Percentage (Small)
Battery is being charged.
Distance Travelled is 802 miles.
Indicates instant power output.
Sport Mode
Dynamic Mode
Energy Saving Mode
Current speed is 26 mph.
Currentbatterychargingprogress is 13%
(using scooter charging port).
Charging
Distance Travelled
Instant Electric Current
Riding Mode
Speed
ChargingPercentage (Large)
Remaining Charging Time
Operation GuideDashboard Display Info
Front Storage Area
1
1
22
3
3
44
PUSH
Remarks: To signal overtaking with flashing light, the rider
may press and release the left part of the button repeatedly.
1413
High/Low Beam Light: Press the upper part to switch to high
beam; press the lower part to switch to low beam.
Turn Signal Indicator: Push the button left to turn on the Left
Turn Signal Indicator; push the button right to turn on the
Right Turn Signal Indicator. Press the button to turn off.
Cruising Mode: Push the button to cruise at current speed.
Press again or brake to turn it off.
Mode Selector
Hazard Light Switch
Start/Stop Button
Right Combination Switch
1
2
3
1 1
2
3
2
34
High/Low Beam Light
Turn Signal Indicator
Horn
Cruising Mode
Left Combination Switch
1
2
3
4
PRESS
Mode Selector: Press right part to switch up the mode. Press
left part to switch down the mode.
Switch down Switch up
Hazard Light Switch: Push the switch left to
turn on the Hazard Light; push the switch
right to turn it off.
Turn on the Hazard Light Turn off the Hazard Light
Start/Stop Button: Press and hold the button for 2 seconds to set the
scooter in the riding mode. The indicator on the dashboard will
light up and you are ready to go. Press the button again to turn it off.
Low
Beam
High
Beam
1615
Turn the steering handlebar to the left, then push the key inward and turn it anticlockwise to
LOCK position.
Unlock Button
Locating Button
Lock Button
Start the Scooter Locking Steering Handlebar
The scooter can only be locked when the scooter is turned off. Press the Lock Button on the
Remote Controller within an effective distance to turn on the Alarm. The Turn Signal Indicators
will stay on for 2 seconds after the scooter is properly locked.
Locking with Remote Controller
Press the Locating Button and the Turn Signal Indicators will flash for 10 seconds. If no further
operation during this period, the Alarm will be on for 10 seconds. The Alarm can be cancelled
by pressing the Unlock or Lock Button.
Locating
Key Remote Controller
Step 1
Step 2
Step 3
Step 4
Press the Unlock button of the remote controller. After the Turn Signal Indicators flash
twice, the scooter is unlocked.
After the scooter is unlocked, insert the key into the Keyhole and turn clockwise to
position.
After system diagnostic, hold the brake and press the Start Button for 2 seconds.
The indicator will light up. Release the brake and the scooter will be ready to go.
Autres manuels pour NQi GTS
1
Table des matières
Autres manuels niu Scooter
niu
niu KQi2 Manuel utilisateur
niu
niu M1 Sport Manuel utilisateur
niu
niu UQiGT Series Manuel utilisateur
niu
niu Kick Scooter KQi3 Manuel utilisateur
niu
niu N Series Manuel utilisateur
niu
niu NQi GTS Manuel utilisateur
niu
niu N-GT Manuel utilisateur
niu
niu M+ Manuel utilisateur
niu
niu N1S Manuel utilisateur
niu
niu KQi3 Series Fiche technique
Manuels Scooter populaires d'autres marques
First Choice Mobility
First Choice Mobility Roma Medical Corella S741 Manuel utilisateur
Carrera
Carrera impel Manuel utilisateur
Afikim
Afikim Superlight SL-3 Manuel utilisateur
CareCo
CareCo ZOOM Manuel utilisateur
Douglas
Douglas Vespa G.S. Manuel utilisateur
Gazelle
Gazelle with BOSCH System Manuel utilisateur