2.9 Display and delete data
Wait until the scooter has been on for 5 seconds, then hold
and buttons at the same time. This will make the
single trip riding time (TM) and single trip distance (DST)
flash. Press button to delete this data.
3. Automatically prompt interface.
3.1 Error Code Display
error code meaning
01_info Throttle issue
03_info Motor hall signal issue
05_info Axis speed sensor issue (only applies to torque sensor)
06_info Motor or controller has short circuit issue
Electronic control system failure will display a (flashing) fault code.
Once the fault has been removed, the fault code display interface will
automatically be removed.
3.2 Motor temperature alarm
If the motor temperature reaches the warning temperature, the text
MOTOR °C (°F) will flash on the display. If this occurs, shut off the motor
as soon as possible and wait for the motor temperature to decrease.
2.8 Battery charge indicator
When charge is above 70%, four battery bars (full battery)
will appear. Bars will reduce as battery charge reduces.
When charge is below 15%, zero bars will appear. If the motor
shuts off because of a low battery (0% battery charge), the
battery indicator will flash. At this point, the scooter should
be shut down completely and charged.
Battery indicator automatically identifies 24V, 36V and 48V
batteries (when supported batteries are being used).
2.7 Brake status display
When using the brakes, the brake status will be displayed.
16 17
N1e- USER MANUAL
NITO ELECTRIC KICK SCOOTER
