LX-8080 Basic Karaoke Connection Diagram (Figure 10) Specifications
LX-8080 Charger Model 21 (Figure 11)
6 7
RF Carrier Frequency Range
169.445 to 221.350 MHz
Working Range
100 ft under typical conditions.
Audio Frequency Response
50 to 15,000 Hz, +/-2 dB
Audio Output Level (+/-15 kHz deviation, 1 kHz tone)
1/4~inch connector (into 3 k Ohm load): -8.8 dBV (Hi Z)
1/4~inch connector (into 3 k Ohm load): -18 dBV (mix)
RF Power Output: about 30 mWatt
Battery Size: 9V rechargeable
Receiver Dimensions: 350mm(L)x200mm(D)x45mm(H)
Handheld Transmitter Dimensions: 250mm(L)x50mm(H)
Net Weight: 2 lbs
Shipping Weight: 8 lbs
Note One year warranty for receiver and hand-held transmitter. No
warranty for re-chargeable battery. Any form of tampering with this
product will result in its warranty being void.
Caution: To reduce the risk of electrical
shock, do not remove the cover (or back).
No user serviceable parts inside: refer
servicing to qualified personnel.
Warning: To reduce the risk of fire or
electrical shock, do not expose this
appliance to rain or moisture.
Warning: To charge the microphone properly, you must place the
microphone in such a way that the turn on/off switch of the
microphone is perpendicular to the white spot on the receiver.
Otherwise, the microphone cannot be charged.
This symbol, wherever it
appears, alerts you to the
presence of uninsulated
dangerous voltage inside the
enclosure voltage that may
be sufficient to constitute a
risk of shock.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol, wherever it
appears, alerts you to
important operating and
maintenance instructions in
the accompanying literature.
Read the manual.
DVD
DVD Karaoke Player
MIC 1 MIC 2
Unbalance Connection
Nissindo Trademark All Right Reserved.
Engineered And Design In U.S.A.
Model: Lx-8080
Serial:
Frequency: A MHz
Frequency: B MHz BALANCEDUNBALANCED UNBALANCED
OUTPUT
CHANNEL B
MIXED A & B
CHANNEL OUTPUT DC-POWER
SQ
DC 17V 600mA
UNBALANCEDBALANCED
OUTPUT
CHANNEL A
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Taking apart or modifying the receiver
may lead to electric shock, fire, or
damage to the receiver and will void
your warranty.
Rear View
GETTOTHEPOINT
GETTOTHEPOINT
CHARGER 21
BATT LOW
ON
OFF
BATT LOW
ON
OFF
14 453 6 7 82 2
1. Charger 21 base.
2. Positive connector.
3. White spot (the accurate point for charging microphone).
4. The positioning needle (that is connected to the hole on the bottom
of the microphone).
5. Negative connector.
6. Indicates charging signal (left side transmitter).
7. DC-power 17V 600mA input connected signal (red color).
8. Indicates charging signal (right side transmitter).
53
