The WECAM Series WiFi+Ethernet C-mount CMOS Camera Help Manual
6/ 11
6WECAM Camera Application Configurations
6.1 Camera working in WLAN AP mode
Figure 2 The PC or Mobile Device Connect to the Camera through WLAN AP Mode
The steps to start the camera are listed below:
⚫Install the ToupView/ToupLite on your PC or install the ToupView App on the mobile device;
⚫Insert the power adapter to the camera’s power jack;
⚫Press down the AP/STA Switch Button, the LED will flash fast with about 2HZ frequency, which means
the camera is in the WLAN AP mode;
⚫Connect the PC or mobile device to the camera;
⚫Start the ToupView/ToupLite software or ToupView App and check the configuration. Normally, active
WECAM cameras are automatically recognized. The connected cameras will be listed in the Camera List
group of the Camera Control Bar of ToupView/ToupLite on PC. On mobile device, connected cameras
will be listed in the Camera Thumbnail page of ToupView App. Click the corresponding camera to start
the stream.
6.2 Connecting multi-cameras to the router with WLAN STA mode for the
network application
In WLAN STA mode, the camera is supposed to connect to router.
Figure 3 Multi WECAM Cameras Connecting to the Router through the WLAN STA Mode
⚫Install the ToupView /ToupLite software on your PC. Alternatively, install the free ToupView App on the
mobile device;
⚫Insert the power adapter to the camera’s power jack;
⚫Connect the camera to the router with WLAN STA mode: Pop up the AP/STA Switch Button, the LED
will flash slowly, this means the camera is in WLAN STA mode and has connected to the router(See Sec.
7 on how to set the router’s name and password in the camera);
⚫Connect PC or mobile device to router(by LAN or WLAN). Start the ToupView/ToupLite software or
