Nilfisk-Advance SW8000 Guide d'installation et d'utilisation

Page: 1

SW8000 How To

Prepare for Sweeping

Before operating any

machine, read the owner’s

manual carefully and take

time to learn the control

panel functions.

Check the machine for

damage, oil and coolant

leaks.

Check the hydraulic

system oil.

Check the battery

electrolyte level

(add

distilled water if needed).

Make sure the battery is

fully charged

Check the fuel level: LP

models – lift the engine

cover and replace the

Propane tank

(secure the

tank with the strap).

Gas and Diesel models -

carefully add fuel through

the fill port.

Check the engine air filter

service indicator – engine

models

(squeeze the rubber

dust cup to release built-up

dust).

Check the tire pressure

(90

- 95 psi for all tires).

Familiarize yourself with

the operator’s interface.

Adjust seat accordingly.

Insert key and turn

ignition on to continue

inspection.

Inspect controls, parking

brake, headlights, horn

and hour meter. Install

appropriate main broom.

Fill dust guard system

with clean water

(optional

for machines with this feature)

Plan cleaning route. Re-

inspect the parking brake

then prepare for sweeping.

Propane

Page: 2

SW8000 How To

Machine Operation

Adjust seat to desired

position.

Start the machine. Release

parking brake.

Engage foot pedal then

transport to designated

work area

(drive safely)

Push the Lower Hopper

Switch.

Move the main broom

level to the sweep

(middle) position.

Turn off the dust control

switch when sweeping

floor with puddles.

Push the Shaker Switch to

clean the dust control

filter.

Check your cleaning path

occasionally to make sure

machine is picking up

debris.

Put the main broom lever

in the Up/Off position.

Use shaker to remove

excess dirt. Drive to

dumping site to empty

hopper.

Hold the raise hopper

switch. Position machine

over trash receptacle

Set parking brake

Press open dump door

switch

Apply Hopper Safety

switch. Lower the hopper.

Inspect hopper door and

front edge seal. Use a

broom to remove litter if

needed. Release parking

brake. Push the hopper

safety handle forward then

lower hopper. Prepare

machine for storage and

daily maintenance.

Page: 3

SW8000 How To

After Use & Daily Maintenance

Shake the Hopper Dust

Control Filter.

Empty the hopper.

Shut down engine:

Raise brooms, change

engine speed to idle

(Gasoline/Diesel models),

turn

service valve off

(LPG),

run

engine until all LOP is

dispelled from the line.

Apply parking brake

Check engine coolant,

engine oil, hydraulic oil

level, parking brake and

clean main and side brooms.

(gas, LPG and diesel models)

Occasional Maintenance

•Rotate Main Broom

•

Clean the DustGuard

Spray Nozzles

•Inspect/adjust booms

•Clean Strainer

•Check/Clean opper

Dust Control Filter

using Method “A”

•Inspect broom

housing skirts

•Inspect hopper seals

•Clean radiator and oil

cooler

•Perform engine

maintenance

•Inspect and grease

steering spindle

•Check/Clean opper

Dust Control Filter

using Method “B”

•Check/Clean opper

Dust Control Filter

using Method “C”

•Change the hydraulic

oil filter

•Change the reservoir

hydraulic oil

•Flush the radiator

•Engine fuel filter(s)

Always refer to your

Mechanical Repair

Service Manual for

detailed maintenance

information.

After

15 Hours

Every 30 Hours

Every

150

Hours

Every 300 Hours

Every

100

0 Hours

Autres manuels pour SW8000

Autres manuels Nilfisk-Advance Scrubber

Nilfisk-Advance

Nilfisk-Advance SC450 Manuel de la liste des pièces

Nilfisk-Advance

Nilfisk-Advance Advance SC5000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance CA 340 ET Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Warrior ST Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Liberty SC60 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC350 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Advance SC401 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BA 600S Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC6500 40C Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BA 450 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Retriever 4000B Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC800 Mode d'emploi

Nilfisk-Advance

Nilfisk-Advance Advance BR 1100S Instructions d'utilisation et d'installation

Nilfisk-Advance

Nilfisk-Advance BRX 700 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance ECOFLEX BR1100S Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC800 Guide d'installation et d'utilisation

Nilfisk-Advance

Nilfisk-Advance SC800 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance C446 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC250 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Nilisk-Alto 866 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Convertamatic 24 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BA 751 Guide de l'utilisateur

Nilfisk-Advance

Nilfisk-Advance Adgressor BR 1050S Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC351 Guide de l'utilisateur

Manuels Scrubber populaires d'autres marques

Olympus

Olympus M200H Manuel utilisateur

Clarke

Clarke BEXT 100H Manuel d'installation et d'exploitation

JOHNY VAC

JOHNY VAC JVC70BCT Manuel utilisateur

RCm

RCm Elan Series Manuel

Kärcher

Kärcher B 120 W Manuel utilisateur

Truvox

Truvox Orbis MotorScrubber 20 Manuel utilisateur

Numatic

Numatic TTB 4045/100 Manuel utilisateur

U.S. Products

U.S. Products PEX 500-C-TICK Mode d'emploi

Mclennan

Mclennan C510 Manuel utilisateur

Tennant

Tennant T20 LPG Manuel utilisateur

Columbus

Columbus ARA 66 BM 100 Manuel utilisateur

Numatic

Numatic TTV 678G / 300T Manuel utilisateur

American-Lincoln

American-Lincoln 505-945 Manuel utilisateur

FIORENTINI

FIORENTINI ET 65-75 Manuel utilisateur

Floorpul

Floorpul ruby 48 blt Guide de l'utilisateur

Onyx

Onyx RX-34 Manuel utilisateur

Dustbane

Dustbane Hurricane 400 Manuel utilisateur

Sana

Sana EUJ-702 Manuel utilisateur