Nilfisk-Advance SC500 Manuel utilisateur

Nilfisk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilfisk-advance.com

www.nilfisk.com

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual

2. Fill the tank with a clean water. The

clean water temperature must not

exceed 40 °C.

Make sure the solution valve under

the machine is open.

3. Fill the EcoFlex™ tank with a deter-

gent suitable for cleaning machines

(highly concentrated and low

foaming detergent).

4. Install the squeegee and fasten it

with the knob.

1a. Unplug the Battery charger cable.

Reconnect it to the machine.

1b. Disconnect the battery charger

cable from the electrical socket.

18. Clean the machine using a damp

cloth and where needed use a neu-

tral cleaning product.

16. Press the click-off button and wait

for the brush/pad holder to fall

on the floor. Remove to clean or

change brush.

17. Take the squeegee off and remove

debris. Check and clean the squeegee

blades.

19. Charge the batteries: Connect the

battery charger cable to the electri-

cal socket.

20. Park the machine with the recovery

tank cover open.

13. Empty the recovery tank with the

hose. Then empty the solution tank

with the transparent hose.

12.

Machine with Ecoflex, always end the daily

work with turning off the detergent 2 minutes

before finishing by pressing the detergent but-

ton. To rinse out detergent from the system and

brush before handling and cleaning.

10. If necessary press the extra pressure

function (hold for one second).

If necessary press the silent mode

button for extra low sound level.

11. Press the EcoFlex™ button when-

ever you temporarily need a greater

cleaning power.

14. Empty the debris tray and clean/

wash the recovery tank inside.

15. Clean the filter:

A) Close the solution valve under the machine.

B) Remove the transparent cover and the gasket,

then remove and clean the filter inside.

C) Reassemble the filter.

7. Lower the squeegee with the pedal.

5. Place the brush or the pad-holder

under the deck. Use the appropriate

brush to clean the floor.

6. Insert the operator key, then start

the machine by pressing the One-

Touch button. To engage the brush,

slightly press the drive paddle and

then release it.

8. Push forward the drive paddle to start

cleaning. Adjust maximum speed by

the speed regulation buttons.

9. To change the solution flow level

push the solution button and

change flow level according to the

cleaning performance and applica-

tion.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this

procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE THE CHARGER IS ALWAYS CONNECTED TO THE BATTERIES EVEN IF NOT USED FOR LONGER PERIOD OF TIME TO PREVENT DAMAGE TO THE BATTERY DUE TO LOW VOLTAGE

At the end of the work

OPERATING GUIDELINES

SC500

Nilfisk-Advance A/S

Sognevej 25

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilfisk-advance.com

www.nilfisk.com

ATTENTION! Do not use the machine before you have read and understood the Instructions for use manual

The machine

doesn’t work

as it should?

The suction

doesn’t work

as it should?

The machine

doesn’t clean

as it should?

The brushes

don’t work as they

should?

TROUBLESHOOTING

SC500

1Check if the power cable is correctly

connected.

1Check if the suction hose is

correctly installed and cleaned.

1Check if you have the right

detergent and water settings.

3Check if the brush are correctly in-

stalled and not worn out or if there

are external materials avoiding brush

rotating.

2Check if the battery is charged.

2Open the recovery tank and check

the debris tray and float are clean

and working.

2Check if the solution valve is open.

2Check if there isn’t any brush motor

overload “WARNING ALARM F2”

on the display.

3Restart the machine without press-

ing the paddle.

3Check if squeegee blades are dam-

aged or dirty.

3Check if the solution filter is

cleaned.

1To adjust machine direction turn

front knob until machine is working

straight.

4Check floor inclination is not exeed-

ing specifications.

4Check the lid gasket is in good

and working condition and sealing

when lid is closed.

4Check the EcoFlex™ system is

cleaned, eventually purge the sys-

tem.

Autres manuels pour SC500

Table des matières

Autres manuels Nilfisk-Advance Machine de plancher

Nilfisk-Advance

Nilfisk-Advance 56115530 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SDS 424 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Whirlamatic 20 Ultra Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 7765 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance CS7010 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SC2000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance ER 1600 series Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW 5080 P Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BU800 51BT Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance HARAM CAPTOR ll Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW 750 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance R 253 9087362020 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW4000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance BR 850S Series Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SW4000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance ecoflex SC7000 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance SR 1900 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Cr 1100 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance Terra 128B Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance CS7000 Fuel Cell EcoFlex Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 545 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 56265002 Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 56263501 Aquamatic Selectric Manuel utilisateur

Nilfisk-Advance

Nilfisk-Advance 421 A/B Manuel utilisateur

Manuels Machine de plancher populaires d'autres marques

Numatic

Numatic ET 4045 Manuel utilisateur

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Manuel utilisateur

Mytee

Mytee 8070 Mytee-Lite Manuel utilisateur

Kärcher

Kärcher B 140 R Manuel utilisateur

Triple S

Triple S Ace 26T1 Manuel utilisateur

Tornado

Tornado Marathon 2000 98190 Manuel

Windsor

Windsor ADMIRAL Admiral 8 Manuel utilisateur

Numatic

Numatic TTB 1117/100 Manuel utilisateur

Tennant

Tennant 8210D Manuel utilisateur

Nobles

Nobles Frontier Manuel du produit

lavina

lavina 21-X Manuel utilisateur

KENT

KENT Edge 28B Manuel utilisateur

Tennant

Tennant 215 Manuel du produit

Windsor

Windsor BDP 51/2000C Manuel utilisateur

CleanFreak

CleanFreak DURA-18HD Manuel utilisateur

BETCO

BETCO PB24 Manuel utilisateur

IPC

IPC CT51-71 BT Manuel utilisateur

Isoplam

Isoplam L010001 Manuel utilisateur