IPC CT51-71 BT Manuel utilisateur

This guide is intended for quick consultation only and does not replace the user and maintenance manual.

Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the

instructions.

PREPARATION & OPERATION

CT51-71 BT Quick Guide

2 3

8 9

PLDC03880

PUSH

SET

ECO

AUTO

CHEM

PUSH

REPLACING THE SQUEEGEE BLADES

ATTACHING/REMOVING THE BRUSHES

Open the clip (Ref. 1).

Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.

Remove the blade.

Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the

screws on the body of the squeegee.

Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing

devices inwards.

Close the hook again.

Replace the squeegee on its support, following the instructions described previously.

Automatic brush attachment, version with head lift pedal:

raise the machine head by pushing the head lift pedal (Fig. 1) down and to the left, then using the operation selector, select the Brush control, rest

the brush on the oor in front of the machine and centre it with the head. Lower the head by pushing the head lift pedal (Fig. 2) down and to the right

and activate the drive lever momentarily; the brush will be attached automatically to the hub on the ange. If the operation is not successful, repeat by

pressing the lever again and repeating the centring procedure. Use of abrasive/microbre disks: t the abrasive/microbre disk on the drive disk and

perform the operations described for tting the brush on the scrubber drier.

Automatic brush release, version with head lift pedal: raise the machine head by pushing the head lift pedal (Fig. 1) down and to the left, turn the selector