- 10"DD at 7 kHz
It could be the best general search coil that you’ll ever need. It exhibits
excellent dept and discrimination in all conditions. Very efficient in detecting
small targets at great depth. Very fast in isolating individual targets.
- 7"DD at 8 kHz,
General search coil designed for quick scan of new detecting fields and
areas. Very good for searching narrow spaces, holes and ditches. Best
suited for small and medium targets in contaminated areas.
Each coil is tuned to a slightly different frequency within the design range,
to minimise interference from other Nexus detectors. Performance values
for all Nexus detectors will be identical.
To obtain the best results with the Nexus Standard MP, as with all metal
detectors, it is essential to understand the settings and operation of the
detector.
With the Nexus Standard MP professional users can enjoy the benefits of
the deep seeking Nexus technology, .
As a general rule the best results will always be obtained when the Nexus
Standard MP is properly set in manual mode. Therefore users will need to
practice and experiment in order to obtain the best possible results on any
particular site. All sites and soils are different and settings that will give
good results on one site may be less successful if used elsewhere. The
Nexus Standard MP is designed to detect the very deepest of targets and
operates near to the limits of what is achievable with induction balance.
Assembly & Preparation
The Nexus Standard MP is supplied boxed and ready for quick assembly
by simply attaching the two lower stem poles to the top one, tightening the
collars and attaching the coil to the lower stem section, using the plastic
bolt and friction washers supplied and tightened by hand so that coil is held
at the correct angle to the stem; the coil cable plug is inserted to the socket
in the control box and then tighten the knurled ring, taking care when
winding the cable around the stem that the cable is not strained.
The centre stem pole is of the same tube diameter as the top one and can
be left off in circumstances where a short stem is needed; it is meant for
use on steep sites, river banks, caves, ditches and similar conditions.
The Nexus Standard MP is supplied with a drop in battery holder that can
be used for all types of AA size batteries, (alkaline or rechargeable); a
charging socket is provided to the battery box for connecting a charger unit.
To insert or change batteries remove any three of the thumb plastic screws
from the base lid of the battery box (the battery box is below the arm cup at
