SPECIFICATION
Temperature Stability:
50 ppm/°C
Display:
6-digit, 7-segment LED,
101.6mm (4.00”)
with red, green
nd mber progr mm ble colors.
Alarm:
Al rm 1 & 2 progr mm ble,
L tch/Unl tch, High, Low,
High/Low
SERIAL INTERFACE
Communication Standard:
RS-485, RS-422 or RS-232
Trans er speed (Baud rate):
300, 600, 1200, 2400, 4800,
9600,19200 bps
Data Format:
7O1-7 bit, Odd, 1 stop bit,
7E1- 7 bit,
even, 1 stop bit
8N1 – 8 bit, No p rity, 1 stop bit
Multi-Point Address (RS-485):
0 to 199
Flow Control:
No Flow control
Screw terminals or
RS-232/485/422 inter ace
Power Supply:
100-240 V c
±
10%,
50/60 Hz, 22.5 W
Operating Temperature:
0 to 40°C
Storage Temperature:
-20 to 60°C
Relative Humidity:
0 to 85%
Protection:
NEMA-4x (IP65)
Dimensions:
641.6 L x 210.8 W x 95.4 D mm
(25.26" x 8.31" x 3.76")
Panel Cutout:
596.9 L x 179.4 W mm
(23.50” L x 7.06” W)
Weight:
3,175 g (7.0 lbs)
Approvals:
CE per EN61010-1:2001
DISPLAY ABBREVIATIONS
ALR1 Al rm 1 St tus
OFF Al rm 1 set Off ON Al rm 1 set On
A1Md Al rm 1 Mode
A1LO Al rm 1 Low A1HI Al rm 1 High
A1LH Al rm 1 Low/High
LO-1 Al rm 1 Low -999.. Al rm 1 Low V lue
..9999
HI-1 Al rm 1 High -999.. Al rm 1 High V lue
..9999
A1CR Displ y color when Al rm 1 triggered
GRN Green Color REd Red Color
AMbR Amber Color
ALR2 Al rm 2 St tus
OFF Al rm 2 set Off ON Al rm 2 set On
A2Md Al rm 2 Mode
A2LO Al rm 2 Low A2HI Al rm 2 High
A2LH Al rm 2 Low/High
LO-2 Al rm 2 Low -999.. Al rm 2 Low V lue
..9999
HI-2 Al rm 2 High -999.. Al rm 2 High V lue
..9999
A2CR Displ y color when Al rm 2 triggered
GRN Green Color REd Red Color
AMbR Amber Color
OUt Al rm L tched/Unl tched selection
LAtC L tched UNLA Unl tched
NO.CR Displ y Color in Norm l condition
GRN Green Color REd Red Color
AMbR Amber Color
MOdE D t Flow Mode
HOSt Host Mode SLAV Sl ve Mode
bAUd B ud R te 300.. B ud R te V lue
..19200
FORM D t Form t
7O1 7 Bit, Odd, 7E1 7 Bit, Even,
1 Stop Bit 1 Stop Bit
8N1 8 Bit, No p rity,
1 Stop Bit
COMM Communic tion St nd rd
232 RS-232 St nd rd 485 RS-485 St nd rd
AddR Device Address 0000.. Address V lue
..0099
INtF Interf ce Device
dRNt DRN with dRNP DRN with
Temper ture Input Process Input
Miscell neous:
PEAk Pe k V lue VALL V lley V lue
PROC Process V lue RUN Run Mode
OVLd Input Overlo d StOR Stored Mess ge
1. In Slave Mode the Big Displ y will w it for
comm nds nd d t from the Seri l Bus.
2. In Host Mode the Big Displ y will send d t
utom tic lly nd continuously into the Seri l Bus.
3. When used in RS-485 Mode, the device must be
ccessed with n ppropri te Address V lue.
4. Latched Mode: Al rm rem ins l tched until reset.
To reset lre dy l tched l rm select ny menu
items nd then press “up” or “down” button.
FLOW CHART _____Underline denotes actory de ault setup
Below is flowch rt showing how to n vig te through ll menus by pressing front buttons.
aaaaaaa
dddddddd
cb cbcbcbcbcb
d
d
cbd cbdd
dd
d
a
d
cb
d
a
a
ddd
a
cb
cb dd
d
aa
d
cb
d
cb
a
ddd
a
cb
cb dd
d
aa
d
cb
d
cb
d
a
cb
d
bc
cb
cbcb cb
For immedi te technic l or pplic tion ssist nce ple se c ll:
Newport Electronics, Inc.
2229 South Y le Street • S nt An , CA • 92704 • U.S.A.
TEL: (714) 540-4914 • FAX: (203) 968-7311
ISO 9001 Certified
Newport Technologies, Inc.
976 Berg r • L v l (Quebec) • H7L 5A1 • C n d
TEL: (514) 335-3183 • FAX: (514) 856-6886
Newport Electronics, Ltd.
One Omeg Drive • River Bend Technology Centre
Northb nk, Irl m • M nchester M44 5BD • United Kingdom
Tel: +44 161 777 6611 • FAX: +44 161 777 6622
Newport Electronics B.V.
Postbus 8034 • 1180 LA Amstelveen • The Netherl nds
TEL: +31 20 3472121 • FAX: +31 20 6434643
Newport Electronics spol s.r.o.
Fryst tsk 184, 733 01 K rviná • Czech Republic
TEL: +420 59 6311899 • FAX: +420 59 6311114
Newport Electronics GmbH
D imlerstr sse 26 • D-75392 Deckenpfronn • Germ ny
TEL: 49 7056 9398-0 • FAX: 49 7056 9398-29
Newport Electronique S.A.R.L.
11, rue J cques C rtier • 78280 Guy ncourt • Fr nce
TEL: +33 1 61 37 29 00 • FAX: +33 1 30 57 54 27
Mexico nd L tin Americ
FAX: 001 (203) 359-7807
En Esp ñol: 001 (203) 359-7803
It is the policy of NEWPORT to comply with ll worldwide s fety nd EMC/EMI regul tions th t pply.
NEWPORT is const ntly pursuing certific tion of its products to the Europe n New Appro ch Directives.
NEWPORT will dd the CE m rk to every ppropri te device upon certific tion.
The inform tion cont ined in this document is believed to be correct, but NEWPORT Electronics, Inc.
ccepts no li bility for ny errors it cont ins, nd reserves the right to lter specific tions without notice.
TRADEMARK NOTICE:
, , , nd newportUS.com
re tr dem rks of NEWPORT Electronics, Inc.
This device is m rked with the intern tion l c ution symbol. It is import nt to re d the
Setup Guide before inst lling or commissioning this device, s the guide cont ins import nt
inform tion rel ting to s fety nd EMC.
WARNING: These products re not designed for use in, nd should not be used for, p tient-
connected pplic tions.
WARRANTY/DISCLAIMER
NEWPORT Electronics, Inc. w rr nts this unit to be free of defects in m teri ls nd workm nship for period of
one (1) year from the d te of purch se. In ddition to NEWPORT’s st nd rd w rr nty period, NEWPORT
Electronics will extend the w rr nty period for our (4) additional years if the w rr nty c rd enclosed with e ch
instrument is returned to NEWPORT.
If the unit m lfunctions, it must be returned to the f ctory for ev lu tion. NEWPORT’s Customer Service
Dep rtment will issue n Authorized Return (AR) number immedi tely upon phone or written request. Upon
ex min tion by NEWPORT, if the unit is found to be defective, it will be rep ired or repl ced t no ch rge.
NEWPORT’s WARRANTY does not pply to defects resulting from ny ction of the purch ser, including but not
limited to mish ndling, improper interf cing, oper tion outside of design limits, improper rep ir, or un uthorized
modific tion. This WARRANTY is VOID if the unit shows evidence of h ving been t mpered with or shows
evidence of h ving been d m ged s result of excessive corrosion; or current, he t, moisture or vibr tion;
improper specific tion; mis pplic tion; misuse or other oper ting conditions outside of NEWPORT’s control.
Components which we r re not w rr nted, including but not limited to cont ct points, fuses, nd tri cs.
NEWPORT is pleased to o er suggestions on the use o its various products. However, NEWPORT neither
assumes responsibility or any omissions or errors nor assumes liability or any damages that result rom
the use o its products in accordance with in ormation provided by NEWPORT, either verbal or written.
NEWPORT warrants only that the parts manu actured by it will be as speci ied and ree o de ects.
NEWPORT MAKES NO OTHER WARRANTIES OR REPRESENTATIONS OF ANY KIND WHATSOEVER,
EXPRESS OR IMPLIED, EXCEPT THAT OF TITLE, AND ALL IMPLIED WARRANTIES INCLUDING ANY
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY
DISCLAIMED.
LIMITATION OF LIABILITY: The remedies o purchaser set orth herein are exclusive, and the total liability
o NEWPORT with respect to this order, whether based on contract, warranty, negligence, indemni ication,
strict liability or otherwise, shall not exceed the purchase price o the component upon which liability is
based. In no event shall NEWPORT be liable or consequential, incidental or special damages.
CONDITIONS: Equipment sold by NEWPORT is not intended to be used, nor sh ll it be used: (1) s "B sic
Component" under 10 CFR 21 (NRC), used in or with ny nucle r inst ll tion or ctivity; or (2) in medic l
pplic tions or used on hum ns. Should ny Product(s) be used in or with ny nucle r inst ll tion or ctivity,
medic l pplic tion, or used on hum ns, or misused in ny w y, NEWPORT ssumes no responsibility s set forth
in our b sic WARRANTY/DISCLAIMER l ngu ge, nd, ddition lly purch ser will indemnify NEWPORT nd hold
NEWPORT h rmless from ny li bility or d m ge wh tsoever rising out of the use of the Product(s) in such
m nner.
RETURN REQUEST/INQUIRIES
Direct ll w rr nty nd rep ir requests/inquiries to the NEWPORT Customer Service Dep rtment. BEFORE
RETURNING ANY PRODUCT(S) TO NEWPORT, PURCHASER MUST OBTAIN AN AUTHORIZED RETURN
(AR) NUMBER FROM NEWPORT’S CUSTOMER SERVICE DEPARTMENT (IN ORDER TO AVOID
PROCESSING DELAYS). The ssigned AR number should then be m rked on the outside of the return p ck ge
nd on ny correspondence.
The purch ser is responsible for shipping ch rges, freight, insur nce nd proper p ck ging to prevent bre k ge
in tr nsit.
FOR WARRANTY RETURNS, FOR NON-WARRANTY REPAIRS,
ple se consult NEWPORT for current h ve the following inform tion v il ble
rep ir BEFORE cont cting NEWPORT: ch rges. H ve the following inform tion
v il ble BEFORE cont cting NEWPORT:
1. Purch se Order number under which 1. Purch se Order number to cover the
the product w s PURCHASED, COST the rep ir,
2. Model nd seri l number of the 2. Model nd seri l number of product,
product under w rr nty, nd nd
3. Rep ir instructions nd/or specific 3. Rep ir instructions nd/or specific
problems rel tive to the product. problems rel tive to the product.
NEWPORT’s policy is to m ke running ch nges, not model ch nges, whenever n improvement is possible. This
ffords our customers the l test in technology nd engineering.
© Copyright 2005 NEWPORT Electronics, Inc. All rights reserved.
This document m y not be copied, photocopied, reproduced, tr nsl ted, or reduced to ny electronic medium or
m chine-re d ble form, in whole or in p rt, without the prior written consent of NEWPORT Electronics, Inc.
PATENT NOTICE: This product is covered by one or more of the following p tents: U.S. P t. No. Des. 336,895;
5,274,577; 6,243,021/ C n d 2052599; 2052600/ It ly 1249456; 1250938/ Fr nce Brevet No. 91 12756/ Sp in
2039150; 2048066/ UK P tent No. GB2 249 837; GB2 248 954/ Germ ny DE 41 34398 C2. ™is Tr dem rk of
OMEGA ENGINEERING, INC. USED UNDER LICENSE. Other U.S. nd Intern tion l p tents pending or pplied
for.
O ERATION MANUAL
iLD46-C2
Big Remote Display
with RS-232 Input
