SPECIFICATION
Temperature Stability:
50 ppm/°C
Display:
4-digit, 7-segment LED, 57.2mm (2.25”)
with red, green and am er programma le
colors.
Alarm:
Alarm 1 & 2 programma le,
Latch/Unlatch, High, Low, High/Low
SERIAL INTERFACE
Communication Standard:
RS-485, RS-422 or RS-232
Trans er speed (Baud rate):
300, 600, 1200, 2400, 4800, 9600,
19200 ps
Data Format:
7O1-7 it, Odd, 1 stop it, 7E1- 7 it,
even, 1 stop it
8N1 – 8 it, No parity, 1 stop it
Multi-Point Address (RS-485):
0 to 199
Flow Control:
No Flow control
Screw terminals or RS-232/485/422
inter ace
Power Supply:
100-240 Vac
±
10%, 50/60 Hz, 22.5 W
Operating Temperature:
0 to 40°C
Storage Temperature:
-20 to 60°C
Relative Humidity:
0 to 85%
Protection:
NEMA-4x (IP65)
Dimensions:
298Lx137Wx73Dmm
(11.75" x 5.375" x 2.875")
Panel Cutout:
279.4 L x 116.8 W mm
(11.00” L x 4.60” W)
Weight:
1,360 g (3 l s)
Approvals:
CE per EN50081-1, EN50082-2,
EN61010-1
DISPLAYABBREVIATIONS
ALR1 Alarm 1 Status
OFF Alarm 1 set Off ON Alarm 1 set On
A1Md Alarm 1 Mode
A1LO Alarm 1 Low A1HI Alarm 1 High
A1LH Alarm 1 Low/High
LO-1 Alarm 1 Low -999.. Alarm 1 Low Value
..9999
HI-1 Alarm 1 High -999.. Alarm 1 High Value
..9999
A1CR Display color when Alarm 1 triggered
GRN Green Color REd Red Color
AMbR Am er Color
ALR2 Alarm 2 Status
OFF Alarm 2 set Off ON Alarm 2 set On
A2Md Alarm 2 Mode
A2LO Alarm 2 Low A2HI Alarm 2 High
A2LH Alarm 2 Low/High
LO-2 Alarm 2 Low -999.. Alarm 2 Low Value
..9999
HI-2 Alarm 2 High -999.. Alarm 2 High Value
..9999
A2CR Display color when Alarm 2 triggered
GRN Green Color REd Red Color
AMbR Am er Color
OUt Alarm Latched/Unlatched selection
LAtC Latched UNLA Unlatched
NO.CR Display Color in Normal condition
GRN Green Color REd Red Color
AMbR Am er Color
MOdE Data Flow Mode
HOSt Host Mode SLAV Slave Mode
bAUd Baud Rate 300.. Baud Rate Value
..19200
FORM Data Format
7O1 7 Bit, Odd, 7E1 7 Bit, Even,
1 Stop Bit 1 Stop Bit
8N1 8 Bit, No parity,
1 Stop Bit
COMM Communication Standard
232 RS-232 Standard 485 RS-485 Standard
AddR Device Address 0000.. Address Value
..0099
INtF Interface Device
dRNt DRN with dRNP DRN with
Temperature Input Process Input
Miscellaneous:
PEAk Peak Value VALL Valley Value
PROC Process Value RUN Run Mode
OVLd Input Overload StOR Stored Message
1. In Slave Mode the Big Display will wait for
commands and data from the Serial Bus.
2. In Host Mode the Big Display will send data
automatically and continuously into the Serial Bus.
3. When used in RS-485 Mode, the device must e
accessed with an appropriate Address Value.
4. Latched Mode: Alarm remains latched until reset.
To reset already latched alarm select any menu
items and then press “up” or “down” utton.
FLOW CHART _____Underline denotes actory de ault setup
Below is a flowchart showing how to navigate through all menus y pressing front uttons.
aaaaaaa
dddddddd
cb cbcbcbcbcb
d
d
cbd cbdd
dd
d
a
d
cb
d
a
a
ddd
a
cb
cb dd
d
aa
d
cb
d
cb
a
ddd
a
cb
cb dd
d
aa
d
cb
d
cb
d
a
cb
d
bc
cb
cbcb cb
MQS3840/N/0802
iLD24-ACC, iLD24-ACV,
iLD24-FP Big Display
For immediate technical or application assistance please call:
Newport Electronics, Inc.
2229 South Yale Street • Santa Ana, CA • 92704 • U.S.A.
TEL: (714) 540-4914 • FAX: (203) 968-7311
ISO 9001 Certified
Newport Technologies, Inc.
976 Bergar • Laval (Que ec) • H7L 5A1 • Canada
TEL: (514) 335-3183 • FAX: (514) 856-6886
Newport Electronics, Ltd.
One Omega Drive • River Bend Technology Centre
North ank, Irlam • Manchester M44 5BD • United Kingdom
Tel: +44 161 777 6611 • FAX: +44 161 777 6622
Newport Electronics B.V.
Post us 8034 • 1180 LA Amstelveen • The Netherlands
TEL: +31 20 3472121 • FAX: +31 20 6434643
Newport Electronics spol s.r.o.
Rudé armády 1868, 733 01 Karviná 8 • Czech Repu lic
TEL: +420 69 6311899 • FAX: +420 69 6311114
Newport Electronics Gm H
Daimlerstrasse 26 • D-75392 Deckenpfronn • Germany
TEL: 49 7056 9398-0 • FAX: 49 7056 9398-29
Newport Electronique S.A.R.L.
11, rue Jacques Cartier • 78280 Guyancourt • France
TEL: +33 1 61 37 29 00 • FAX: +33 1 30 57 54 27
Mexico and Latin America
TEL: 001-800-826-6342 • FAX: 001 (203) 359-7807
En Español: 001 (203) 359-7803
It is the policy of NEWPORT to comply with all worldwide safety and EMC/EMI regulations that apply.
NEWPORT is constantly pursuing certification of its products to the European New Approach Directives.
NEWPORT will add the CE mark to every appropriate device upon certification.
The information contained in this document is elieved to e correct, ut NEWPORT Electronics, Inc.
accepts no lia ility for any errors it contains, and reserves the right to alter specifications without notice.
TRADEMARK NOTICE:
, , , and newportUS.com
are trademarks of NEWPORT Electronics, Inc.
This device is marked with the international caution sym ol. It is important to read the
Setup Guide efore installing or commissioning this device, as the guide contains important
information relating to safety and EMC.
WARNING: These products are not designed for use in, and should not e used for, patient-
connected applications.
WARRANTY/DISCLAIMER
NEWPORT Electronics, Inc. warrants this unit to e free of defects in materials and workmanship for a period of
one (1) year from the date of purchase. In addition to NEWPORT’s standard warranty period, NEWPORT
Electronics will extend the warranty period for our (4) additional years if the warranty card enclosed with each
instrument is returned to NEWPORT.
If the unit malfunctions, it must e returned to the factory for evaluation. NEWPORT’s Customer Service
Department will issue an Authorized Return (AR) num er immediately upon phone or written request. Upon
examination y NEWPORT, if the unit is found to e defective, it will e repaired or replaced at no charge.
NEWPORT’s WARRANTY does not apply to defects resulting from any action of the purchaser, including ut not
limited to mishandling, improper interfacing, operation outside of design limits, improper repair, or unauthorized
modification. This WARRANTY is VOID if the unit shows evidence of having een tampered with or shows
evidence of having een damaged as a result of excessive corrosion; or current, heat, moisture or vi ration;
improper specification; misapplication; misuse or other operating conditions outside of NEWPORT’s control.
Components which wear are not warranted, including ut not limited to contact points, fuses, and triacs.
NEWPORT is pleased to o er suggestions on the use o its various products. However, NEWPORT neither
assumes responsibility or any omissions or errors nor assumes liability or any damages that result rom
the use o its products in accordance with in ormation provided by NEWPORT, either verbal or written.
NEWPORT warrants only that the parts manu actured by it will be as speci ied and ree o de ects.
NEWPORT MAKES NO OTHER WARRANTIES OR REPRESENTATIONS OF ANY KIND WHATSOEVER,
EXPRESS OR IMPLIED, EXCEPT THAT OF TITLE, AND ALL IMPLIED WARRANTIES INCLUDING ANY
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE HEREBY
DISCLAIMED.
LIMITATION OF LIABILITY: The remedies o purchaser set orth herein are exclusive, and the total liability
o NEWPORT with respect to this order, whether based on contract, warranty, negligence, indemni ication,
strict liability or otherwise, shall not exceed the purchase price o the component upon which liability is
based. In no event shall NEWPORT be liable or consequential, incidental or special damages.
CONDITIONS: Equipment sold y NEWPORT is not intended to e used, nor shall it e used: (1) as a "Basic
Component" under 10 CFR 21 (NRC), used in or with any nuclear installation or activity; or (2) in medical
applications or used on humans. Should any Product(s) e used in or with any nuclear installation or activity,
medical application, or used on humans, or misused in any way, NEWPORT assumes no responsi ility as set forth
in our asic WARRANTY/DISCLAIMER language, and, additionally purchaser will indemnify NEWPORT and hold
NEWPORT harmless from any lia ility or damage whatsoever arising out of the use of the Product(s) in such a
manner.
RETURN REQUEST/INQUIRIES
Direct all warranty and repair requests/inquiries to the NEWPORT Customer Service Department. BEFORE
RETURNING ANY PRODUCT(S) TO NEWPORT, PURCHASER MUST OBTAIN AN AUTHORIZED RETURN
(AR) NUMBER FROM NEWPORT’S CUSTOMER SERVICE DEPARTMENT (IN ORDER TO AVOID
PROCESSING DELAYS). The assigned AR num er should then e marked on the outside of the return package
and on any correspondence.
The purchaser is responsi le for shipping charges, freight, insurance and proper packaging to prevent reakage
in transit.
FOR WARRANTY RETURNS, FOR NON-WARRANTY REPAIRS,
please consult NEWPORT for current have the following information availa le
repair BEFORE contacting NEWPORT: charges. Have the following information
availa le BEFORE contacting NEWPORT:
1. Purchase Order num er under which 1. Purchase Order num er to cover the
the product was PURCHASED, COST the repair,
2. Model and serial num er of the 2. Model and serial num er of product,
product under warranty, and and
3. Repair instructions and/or specific 3. Repair instructions and/or specific
pro lems relative to the product. pro lems relative to the product.
NEWPORT’s policy is to make running changes, not model changes, whenever an improvement is possi le. This
affords our customers the latest in technology and engineering.
© Copyright 2002 NEWPORT Electronics, Inc. All rights reserved.
This document may not e copied, photocopied, reproduced, translated, or reduced to any electronic medium or
machine-reada le form, in whole or in part, without the prior written consent of NEWPORT Electronics, Inc.
PATENT NOTICE: This product is covered y one or more of the following patents: U.S. Pat. No. Des. 336,895;
5,274,577; 6,243,021/ Canada 2052599; 2052600/ Italy 1249456; 1250938/ France Brevet No. 91 12756/ Spain
2039150; 2048066/ UK Patent No. GB2 249 837; GB2 248 954/ Germany DE 41 34398 C2. ™is a Trademark of
OMEGA ENGINEERING, INC. USED UNDER LICENSE. Other U.S. and International patents pending or applied
for.
