Notes:
•
For maximum control, the unit should be placed where easy access to the
control panel is possible.
•
The rear of the unit should always have at least six inches of open area to
allow unrestricted airflow.
•
Be sure power cord and unit is not accessible to small children to prevent
injury.
This unit is equipped with 2 cleaning modes.
Mode 1
is normal air cleaning mode with Ozone turned OFF.
It can be
run in this mode constantly while the room is occupied with people and pets. The
user may also turn UV bulb cleaning on and off on this mode as needed.
Mode 2 is for additional sanitization and the user may engage the Ozone Feature
to ON. The ozone feature is optional and does not have to be engaged by the user
(in fact the user must install ozone plates in the rear of the unit for it to work).
HOWEVER, Ozone at high levels can be a lung irritant and should ONLY be used if
the room is unoccupied by people, animals, and pets. This unit is equipped with
timers so the Ozone can be turned on and then will turn off when the timer runs out.
For example, say the user is working in their office at work and they are the last
person to leave their office for the day. The user could look to make sure nothing
flammable is around the unit, close all windows, and remove all pets and people.
Then they could set the Ozone cleaning to turn on for 2 hours (by setting the timer).
They would then close the door to their office and leave. After 2 hours the unit
would turn off automatically. The next morning the user would come into the room
and open some windows to provide fresh air in the office. This is an example of
the proper way to use Mode 2 for Ozone sanitization.
