NetPilot Internet Security Ltd., Wellington Gallery, Tunbridge Road, Chew Magna, Bristol BS40 8SP
Doc Version 1.5 Aug 11
Tel: +44 (0) 1275 333608 Fax: +44 (0) 1275 33608 Email: info@netpilot.com Web:
www.netpilot.com
Page
1
Note: A full installation Guide is available on: www.netpilot.com/netpilot/support/V6knowledgebase.asp
NetPilot Vanguard R2100
-
Front Buttons and LEDs
NetPilot Vanguard R2100
-
Rear Connectors
Getting Started – Physical Connection
1. Remove unit from packaging.
2. Site the NetPilot in a suitable location without blocking any of the unit’s air ventilation.
3. If using a direct connection between the PC (from which you will configure the unit) and the NetPilot
utilising a crossover cable - connect LAN cable to NetPilot port LAN1. If using straight cables with a
hub or switch, again connect LAN cable to port LAN1 on NetPilot unit.
4. Connect NetPilot LAN2 port to external ADSL router/modem or other router providing internet
connectivity. You may use a direct connection or be using intermediate hub or switch.
5. Connect external PSU unit to NetPilot unit.
6. Switch on power to NetPilot and observe Ready LED on front panel.
7. Once the NetPilot is operational power up your PC to undertake initial configuration.
Note: LAN3 is used for DMZ or other separate connection and can be configured later.
Note: All software configuration is conducted via a browser using LAN.
Monitor & Keyboard is for diagnostic use only.
POWER LED
DISK LED
LAN2 LED
