NETGEAR FS 726 Manuel utilisateur

MODEL

726

MODEL

750

Modular Fast Ethernet Switch

User‘s Guide

Trademarks

NETGEAR® is a registered trademark of NETGEAR, Inc. in the United States and other countries. All other

trademarks and registered trademarks are the property of their respective owners.

Statement of Conditions

In the interest of improving internal design, operational function, and/or reliability, NETGEAR reserves the

right to make changes to the products described in this document without notice. NETGEAR does not assume

any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Certificate of the Manufacturer/Importer

It is hereby certified that the NETGEAR Model FS726 Modular Fast Ethernet Switch and Model FS750

Modular Fast Ethernet Switch have been suppressed in accordance with the conditions set out in the BMPT-

AmtsblVfg 243/1991 and Vfg 46/1992.The operation of some equipment (for example, test transmitters) in

accordance with the regulations may, however, be subject to certain restrictions. Please refer to the notes in

the operating instructions.

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the

market and has been granted the right to test the series for compliance with the regulations.

Voluntary Control Council for Interference (VCCI) Statement

This equipment is in the first category (information equipment to be used in commercial and/or industrial

areas) and conforms to the standards set by the Voluntary Control Council for Interference by Data

Processing Equipment and Electronic Office Machines that are aimed at preventing radio interference in com-

mercial and/or industrial areas.

Consequently, when this equipment is used in a residential area or in an adjacent area thereto, radio interfer-

ence may be caused to equipment such as radios andTV receivers.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause

undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection against

harmful interference in a residential installation.This equipment generates, uses, and can radiate radio fre-

iii

quency energy and, if not installed and used in accordance with the instructions,may cause harmful interfer-

ence to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

EN 55024 Declaration of Conformity

This is to certify that the NETGEAR Model FS726 Modular Fast Ethernet Switch and Model FS750

Modular Fast Ethernet Switch are shielded against the generation of radio interference in accordance with

the application of Council Directive 89/336/EEC,Article 4a. Conformity is declared by the application of EN

55024 Class A (CISPR 22).

Warning:This is a Class A product. In a domestic environment, this product may cause radio

interference, in which case the user may be required to take appropriate measures.

Canadian Department of Communications Radio Interference Regulations

These digital apparatuses (NETGEAR Model FS726 Modular Fast Ethernet Switch and Model FS750 Modular

Fast Ethernet Switch) do not exceed the Class A limits for radio-noise emissions from digital apparatus as set out in

the Radio Interference Regulations of the Canadian Department of Communications.

Règlement sur le brouillage radioélectrique du ministère des Communications

Ces appareils numériques (NETGEAR Model FS726 Modular Fast Ethernet Switch et Model FS750

Modular Fast Ethernet Switch) respectent les limites de bruits radioélectriques visant les appareils

numériques de classe A prescrites dans le Règlement sur le brouillage radioélectrique du ministère des

Communications du Canada.

Customer Support

For assistance with installing and configuring your NETGEAR system or with questions or problems

following installation:

• Check the NETGEAR Web page at http://www.NETGEAR.com.

• CallTechnical Support in North America at 1-888-NETGEAR. Our technicians are standing by to assist

you 24 hours a day, 7 days a week.If you are outside North America,please refer to the phone numbers

listed on the Support Information Card that shipped with your switch.

• E-mail Technical Support at support@NETGEAR.com.

Defective or damaged merchandise can be returned to your point-of-purchase representative.

Internet/World Wide Web

NETGEAR maintains a World Wide Web home page that you can access at the uniform resource locator

(URL) http://www.NETGEAR.com. A direct connection to the Internet and a Web browser such as Internet

Explorer or Netscape are required.

vContents

CONTENTS

CHAPTER 1

Introduction 1-1

Description 1-1

Features 1-2

Key Features 1-2

Additional Features 1-3

Package Contents 1-5

CHAPTER 2

Physical Description 2-1

Front and Back Panels 2-1

10/100 Mbps RJ-45 Ports 2-3

LED Mode Button and LED Descriptions 2-4

Module Bays 2-5

Auto Uplink 2-5

Reset Button 2-7

CHAPTER 3

Applications 3-1

Desktop Switching 3-1

Segment Switching and Bridging from 10 Mbps to 100 Mbps 3-2

Media Compatibility and Conversion 3-2

CHAPTER 4

Installation 4-1

Preparing the Site 4-2

Installing the Switch 4-3

Installing the Switch on a Flat Surface 4-3

Installing the Switch in a Rack 4-3

Connecting Devices to the Switch 4-4

Using Gigabit Ethernet Modules 4-5

Checking the Installation 4-6

Applying AC Power 4-6

contents vi

CHAPTER 5

Troubleshooting Information 5-1

AdditionalTroubleshooting Suggestions 5-3

Network Adapter Cards 5-3

Configuration 5-3

Switch Integrity 5-3

Auto Negotiation 5-3

APPENDIX A

Technical Specifications A-1

Network Protocol and Standards Compatibility A-1

Data Rate A-1

Interface A-1

Performance Specifications A-2

Bandwidth A-2

Electrical Specifications A-3

Power Consumption A-3

Physical Specifications A-3

Environmental Specifications A-3

Electromagnetic Emissions A-4

Electromagnetic Susceptibility A-4

Safety Agency Approvals A-4

APPENDIX B

Connector Pin Assignments B-1

RJ-45 Plug and RJ-45 Connector B-1

Duplex SC Plug and Duplex SC Connector B-3

viicontents

APPENDIX C

Cabling Guidelines C-1

Fast Ethernet Cable Guidelines C-1

Category 5 Cable C-2

Category 5 Cable Specifications C-3

Twisted Pair Cables C-3

Patch Panels and Cables C-5

Using 1000BASE-T Gigabit Ethernet over Category 5 Cable C-5

Overview C-5

Cabling C-6

Length C-6

Return Loss C-6

Near End Crosstalk (NEXT) C-7

Patch Cables C-7

Conclusion C-7

Fiber Optic Cables C-8

Fiber Cable Specifications C-8

Gigabit Cable Guidelines C-8

INDEX I-1

FIGURES

figures viii

Figure 1-1. Package Contents 1-5

Figure 2-1. Front and Back Panels of the FS726 Switch 2-2

Figure 2-2. Front and Back Panels of the FS750 Switch 2-3

Figure 2-3. Creating Redundant Paths between

Network Devices (Example 1) 2-6

Figure 2-4. Creating Redundant Paths between

Network Devices (Example 2) 2-6

Figure 3-1. Example of Desktop Switching 3-1

Figure 3-2. Example of Segment Switching and Bridging 3-2

Figure 3-3. Example of Media Compatibility

and Conversion 3-3

Figure 4-1. Attaching Mounting Brackets 4-3

Figure 4-2. Connecting Devices to the Switch 4-4

Figure B-1. RJ-45 Plug and RJ-45 Connector

with Built-in LEDs B-1

Figure B-2 Duplex SC Cconnector and Duplex SC Plug B-3

Figure C-1. Straight-ThroughTwisted-Pair Cable C-4

Figure C-2. CrossoverTwisted-Pair Cable C-4

Figure C-3. Category 5 UTP Cable with

Male RJ-45 Plug at Each End C-5

TABLES

ixtables

Table 1-1. Key Features 1-2

Table 2-1. Front Panel LEDs 2-4

Table 4-1. Site Requirements 4-2

Table 5-1. Troubleshooting Information 5-1

Table B-1. 10/100 Mbps RJ-45 Plug and

RJ-45 Connector Pin Assignments B-2

Table B-2. 100/1000 Mbps RJ-45 Plug and

RJ-45 Connector Pin Assignments B-2

Table C-1. Electrical Requirements

of Category 5 Cable C-3

Table C-2. Electrical Requirements of

Fiber Optic Cable C-8

Table C-3. Gigabit Cable Guidelines C-8

1-1introduction

CHAPTER 1: INTRODUCTION

This installation guide describes the NETGEAR FS726 and FS750 Modular Fast

Ethernet Switches.

NETGEAR’s FS726 and FS750 are expandable, high-performance, IEEE-compliant

network switches designed for users who require a large number of ports and want the

high-speed capability of 10/100 switching to eliminate bottlenecks, boost performance,

and increase productivity. Both switches are designed with front module bays that will

accommodate either copper gigabit modules or fiber gigabit modules for high-speed

connection to a server or your network backbone.Built-in modularity gives you the flex-

ibility to buy according to your immediate needs,then add to your system later.You can

purchase the optimal combination of copper and fiber gigabit modules for your network

– both the same or one of each, as either will function in each module bay.To simplify

installation, both switch models are shipped ready for use,with no configuration

required. Everything necessary for setup comes in the box.

This chapter provides the following information:

• Description

• Features

• Package contents

Description

NETGEAR’s FS726 and FS750 Modular Fast Ethernet Switches are flexible, powerful,

and easy-to-use network solutions.Both switches have two front panel module bays that

can be used with gigabit uplinks to create a high-performance backbone connection.

Each module bay accepts either a copper Gigabit Ethernet module (1000BASE-T,

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels NETGEAR Routeur réseau

NETGEAR

NETGEAR Nighthawk RAX80 Manuel utilisateur

NETGEAR

NETGEAR Nighthawk X10 Guide de dépannage

NETGEAR

NETGEAR R6900P Manuel utilisateur

NETGEAR

NETGEAR R6300 Manuel utilisateur

NETGEAR

NETGEAR S8000 Manuel utilisateur

NETGEAR

NETGEAR DG834Gv2 - 54 Mbps Wireless ADSL Firewall... Manuel utilisateur

NETGEAR

NETGEAR DGFV338 - ProSafe Wireless ADSL Modem VPN Firewall... Manuel d'utilisation

NETGEAR

NETGEAR PR2000 Manuel utilisateur

NETGEAR

NETGEAR RT328 Manuel utilisateur

NETGEAR

NETGEAR FVX538v1 - ProSafe VPN Firewall Dual WAN Manuel utilisateur

NETGEAR

NETGEAR Orbi RBK753 Manuel utilisateur

NETGEAR

NETGEAR PR2000 Manuel utilisateur

NETGEAR

NETGEAR RO318 Manuel utilisateur

NETGEAR

NETGEAR XS512EM Manuel utilisateur

NETGEAR

NETGEAR WNDR4300v2 Manuel utilisateur

NETGEAR

NETGEAR Nighthawk RAX200 Manuel utilisateur

NETGEAR

NETGEAR FVS318G - ProSafe Gigabit VPN Firewall Data Sheet... Manuel utilisateur

NETGEAR

NETGEAR FVX538v1 - ProSafe VPN Firewall Dual WAN Manuel technique

NETGEAR

NETGEAR Nighthawk CAX30 Manuel utilisateur

NETGEAR

NETGEAR AC1450 Manuel utilisateur

NETGEAR

NETGEAR JNR3210 Mode d’emploi

NETGEAR

NETGEAR GS908E Manuel utilisateur

NETGEAR

NETGEAR GS716T-200NAS Manuel

NETGEAR

NETGEAR Nighthawk AC1900 D7000v2 Manuel utilisateur

Manuels Routeur réseau populaires d'autres marques

Allnet

Allnet ALL0333AU Manuel utilisateur

HomeSeer

HomeSeer HT-SEL Manuel utilisateur

Sercomm

Sercomm Genesis OC3505D Manuel utilisateur

Billion

Billion BIPAC 5102 Series Manuel utilisateur

TP-Link

TP-Link TD-8817 Manuel utilisateur

Motorola

Motorola MR1900 Manuel utilisateur

Digi

Digi IX14 Manuel utilisateur

Cisco

Cisco NCS 540 Manuel

XAVi

XAVi X8821e Manuel utilisateur

BEC

BEC 6200WZL Manuel utilisateur

MikroTik

MikroTik hAP ac3 Series Manuel utilisateur

Korenix

Korenix JetNet 5428G Series Manuel utilisateur

Korenix

Korenix JetNet 5710G Series Manuel utilisateur

Automated Logic

Automated Logic ZN551 Manuel du propriétaire

Cisco

Cisco ASR 1000 Series Manuel de l'opérateur

EnGenius

EnGenius ESR-9710 Manuel utilisateur

Cisco

Cisco 805 Series Instructions d'utilisation et de sécurité

LevelOne

LevelOne FBR-1416 Manuel utilisateur