Neltronics MCCD-655 Manuel utilisateur
MCCD-655
Wiring
Red DC
Ignition power
Black DC
Permanent power
White RCA
Audio
Brown wire
Reverse trigger +12v
-+Both Red and Black DC
sockets are positive tip
INSTALLATION
(1) Find an appropriate location for installation (Illustration 1).
(2) Drill holes according to the size of U-bracket as illustration 3 and fix the U-bracket as illustration 2.
(Illustration 1)
Φ20 hole
(Illustration 2)
Camera
U-bracket
(Illustration 3) Unit: mm (Illustration 4)
Camera
Hex head screw (stainless steel)
Washer (stainless steel)
Washer (nylon)
M4*12
M4*0.8
M4*1
(5) Connect the camera tail and the extension cable inside the car (Illustration 5).
(Illustration 6)
Back of Vehicle Body
Bumper
Monitor Image
A
ngle of the Lens
about 90°
Vehicle Bod
y
(6) Loosen the screw between the camera and the fixed U-bracket and adjust the camera to a best viewing angle (Illustration 6).
(3) Drill a Φ20mm next to the U-bracket (Illustration 2).
(4) Fix the camera to the U-bracket (illustration 4).
Rubber Grommet
Extension Cable
Camera Tail
Direction Arrow
(Illustration 5)
Table des matières
Autres manuels Neltronics Caméra embarquée
