Motorola Symbol IP54 Guide de configuration

One Symbol Plaza, Holtsville, NY 11742-1300 • 1.631.738.2400 • www.symbol.com

Cleaning Instructions for

Symbol IP54 Devices

Purpose:

The purpose of this document is to demonstrate the proper methods and solutions to clean Symbol

mobile computer IP54 devices as well as their respective cradles.

Materials used:

•Alcohol wipes

•Lens tissue

•Cotton tipped applicators (Puritan)

•Isopropyl Alcohol or any solution containing ethanol

•Can compressed air with a tube (Micro Blast)

Cleaning the Mobile Computer

Mobile Computer Plastic Housing

Using the alcohol wipes, wipe:

•The front of the device including keys and in- between keys

•back of the device

•sides of the device

•top of the device

•bottom of the device

One Symbol Plaza, Holtsville, NY 11742-1300 • 1.631.738.2400 • www.symbol.com

Display

The display can be wiped down with the alcohol wipe indicated above, but care should be taken not

to allow any pooling of liquid around the edges of the display. Immediately dry the display with a soft,

non-abrasive cloth to prevent streaking.

Scanner Exit Window

Wipe the scanner exit window periodically with a lens tissue or other material suitable for cleaning

optical material such as eyeglasses.

Connector

1- Remove the main battery from mobile computer. Refer to the devices’ User Guide for

instructions.

2- Close battery door.

3- Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.

4- Insert the cotton portion of the cotton tipped applicator inside the connector on the bottom of

the mobile computer as shown below. Ensure the tip of the cotton applicator touches the back

of the connector. Do not leave any cotton residue inside the connector.

5- Twist the cotton tipped applicator and slowly move it back-and-forth from one side of the

connector to the other. Repeat at least three times then remove cotton tipped applicator from

the connector.

6- Use the cotton tipped applicator dipped in alcohol to remove any grease and dirt near the

connector area.

7- Use a dry cotton tipped applicator and repeat steps 3 through 5.

One Symbol Plaza, Holtsville, NY 11742-1300 • 1.631.738.2400 • www.symbol.com

8- Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away

from the surface. Caution: Do not point nozzle at yourself and others, ensure the nozzle or

tube is away from your face.

9- Inspect the area for any grease or dirt, repeat steps 3 to step 8 as required.

10-Ensure that there is no lint left by the cotton tipped applicator. Remove lint if found.

One Symbol Plaza, Holtsville, NY 11742-1300 • 1.631.738.2400 • www.symbol.com

Cleaning Cradle Connector

1- Remove the DC power cable from the cradle.

2- Position the cradle as shown below.

3- Dip the cotton portion of the cotton tipped applicator in isopropyl alcohol.

4- Rub the cotton portion of the cotton tipped applicator along the pins of the connector as shown

below. Slowly move the applicator back-and-forth from one side of the connector to the other.

Do not let any cotton residue on the connector.

One Symbol Plaza, Holtsville, NY 11742-1300 • 1.631.738.2400 • www.symbol.com

5- All sides of the connector (shown below) should also be rubbed with the cotton tipped

applicator.

6- Spray compressed air in the connector area by pointing the tube/nozzle about ½ inch away

from the surface. Caution: do not point nozzle at yourself and others, ensure the nozzle or tube

is pointed away from your face.

7- Ensure that there is no lint left by the cotton tipped applicator, remove lint if found.

8- If grease and other dirt can be found on other areas of the cradle, use lint free cloth and

alcohol to remove.

9- Allow at least 10 to 30 minutes (depending on ambient temperature/humidity)* for the alcohol

to air dry before applying power to cradle.

10-If the temperature is low and humidity is high, longer drying time is required. Warm

temperature and dry humidity requires less drying time. DO NOT PLACE PRODUCTS IN AN

OVEN OR UNDER HEAT LAMPS!

Cleaning Frequency

The frequency of these cleanings is up to the customer’s discretion due to the varied environments in

which the mobile computers are used. They may be cleaned as frequently as required. However

when used in dirty environments it may be advisable to periodically clean the scanner exit window to

ensure optimum scanning performance.

Caution:

•Always wear eye protection

•Read warning label on compressed air and alcohol product before using.

•If you have to use any other solution for medical reasons please contact Symbol for more

information.

WARNING! Avoid exposing this product to contact with hot oil or other flammable liquids. If such exposure occurs, unplug the unit and

clean the product immediately in accordance with these guidelines.

Table des matières

Autres manuels Motorola portable

Motorola

Motorola TETRA MTM800 Dessin dimensionnel

Motorola

Motorola MC2100 Series Manuel utilisateur

Motorola

Motorola MC65 Manuel utilisateur

Motorola

Motorola WA9901 Instructions de montage

Motorola

Motorola MC9190-G Instructions de montage

Motorola

Motorola Symbol TC70 Manuel utilisateur

Motorola

Motorola MC65 Manuel utilisateur

Motorola

Motorola MC31XX Series Instructions de montage

Motorola

Motorola Workabout Pro4 Manuel utilisateur

Motorola

Motorola ES400 Manuel utilisateur

Motorola

Motorola MC21XX SERIES Instructions de montage

Motorola

Motorola HC700-G Manuel utilisateur

Motorola

Motorola WT4090 Manuel utilisateur

Motorola

Motorola TETRA MTM800 Manuel d'utilisation et d'entretien

Motorola

Motorola MC9500-K - Win Mobile 6.1 806 MHz Manuel utilisateur

Motorola

Motorola MC40 Manuel utilisateur

Motorola

Motorola 7528X Manuel utilisateur

Motorola

Motorola F4705A Manuel utilisateur

Motorola

Motorola MC919Z Instructions de montage

Motorola

Motorola MC18 Manuel utilisateur

Motorola

Motorola MC3090Z Manuel utilisateur

Motorola

Motorola MC92N0-G Manuel utilisateur

Motorola

Motorola MC5590 Manuel utilisateur

Motorola

Motorola LEX L10g Manuel utilisateur

Manuels portable populaires d'autres marques

Honeywell

Honeywell Dolphin 9900 Manuel utilisateur

Honeywell

Honeywell CN75 Manuel utilisateur

MiTAC

MiTAC Mio 168 Manuel utilisateur

Wasp

Wasp WDT92 Manuel utilisateur

Texas Instruments

Texas Instruments TI-Nspire Manuel utilisateur

AXEM Technology

AXEM Technology MBS Manuel utilisateur

Armstrong

Armstrong Brain Wave Instructions de montage

Unitech

Unitech TB128 Manuel utilisateur

Symbol

Symbol MC9000-G Manuel d'installation et d'exploitation

Unitech

Unitech HT1 1D Batch Manuel utilisateur

Ingenico

Ingenico IWL220 GPRS Manuel utilisateur

Intermec

Intermec CK61 Manuel utilisateur

Symbol

Symbol c2000 Manuel utilisateur

Symbol

Symbol MC18 Manuel d'installation et d'exploitation

Acer

Acer n20 Manuel utilisateur

Intermec

Intermec CK61 Manuel utilisateur

Docomo

Docomo F-04H Manuel utilisateur

Toshiba

Toshiba e350 Series Manuel utilisateur