Morphy Richards IB40460 Manuel utilisateur

This guarantee is valid in the UK and Ireland

only. It is in your interest to retain the retailers receipt as

proof of purchase. Please quote the following information

if the product develops a fault. These numbers can be

found on the base of the product.

Model No. Serial No.

All Morphy Richards Products are individually tested

before leaving the factory. In the unlikely event of any

appliance proving to be faulty within 28 days of purchase it

should be returned to the place of purchase for it to be

replaced.

If the fault develops after 28 days and within 24

months of original purchase, you should contact the

freephone number quoting Model number and Serial

number on the product, or write to the address below.

You will be asked to return the product (in secure,

adequate packaging) to the address below along with a

copy of proof of purchase. Subject to the exclusions set

out below (see ‘Exclusions’) the faulty appliance will then

be repaired or replaced and dispatched usually within 7

working days of receipt.

If for any reason this item is replaced during the 2 year

guarantee period, the guarantee on the new item will be

calculated from original purchase date. Therefore it is vital

to retain your original till receipt or invoice to indicate the

date of initial purchase.

To qualify for the 2 year guarantee the appliance must

have been used according to the manufacturers

instructions. For example kettles should have been

regularly descaled or an iron cord should have been

stored as recommended by the instructions.

EXCLUSIONS

Morphy Richards shall not be liable to replace or

repair the goods under the terms of the Guarantee where:

1 The fault has been caused or is attributable to

accidental use, mis-use, negligent use or used contrary

to the manufacturers recommendations or where the

fault has been caused by power surges or damage

caused in transit.

2 The appliance has been used on a voltage supply other

than that stamped on the products.

3 Repairs have been attempted by persons other than

our service staff (or authorised dealer).

4 Where the appliance has been used for hire purposes

or non-domestic use.

5 Morphy Richards are not liable to carry out any type of

servicing work, under the guarantee.

6 Plastic filters for all Morphy Richards kettles and coffee

makers are not covered by the guarantee.

This guarantee does not confer any rights other than

those expressly set out above and does not cover any

claims for consequential loss or damage. This guarantee is

offered as an additional beneﬁt and does not affect your

statutory rights as a consumer.

Service Department, Morphy Richards Ltd, Mexborough, South Yorkshire, England, S64 8AJ

Freephone (office hours): UK 0800 424848, Republic of Ireland 1800 409119

Two year guarantee

Sprinter iron

IMPORTANT

SAFEGUARDS

1Read all instructions.

2Use the iron only for its intended use.

3To protect against a risk of electric

shock, do not immerse the iron in

water or other liquids.

4The power socket should always be

switched off before plugging or

unplugging from outlet. Never yank

cord to disconnect from outlet;

instead, grasp plug and pull to

disconnect.

5Do not allow cord to touch hot

surfaces. Let iron cool completely

before putting away. Loop cord loosely

around iron when storing.

6Always disconnect iron from electrical

outlet when filling with water or

emptying, and when not in use.

7Do not operate the iron with a

damaged cord or if the iron has been

dropped or damaged. To avoid the risk

of electric shock, do not disassemble

the iron, but telephone Morphy

Richards for advice. Incorrect

reassembly can cause a risk of electric

shock when the iron is used.

8 Place all electrical appliances out

of the reach of children. Close

supervision is necessary for an

appliance being used near children.

9Do not leave the iron unattended

whilst plugged in or on an ironing

board. Never allow the power cord

to overhang the work surface.

10 Burns can occur from touching hot

metal parts, hot water or steam. Use

caution when you turn a steam iron

upside down - there may be hot water

in the reservoir.

SPECIAL

INSTRUCTIONS

1If your iron does not work, check the

following points:

Has the temperature control been set

to the required temperature? Is the

plug in its socket? Is the plug itself or

the socket faulty? (Check by plugging in

another appliance)

2 Warning: When in use, your iron

should never be placed flat and

left on an ironing board.

3To prevent damage to the textile being

ironed, follow the temperature guide

carefully. (Test the inside of the hem of

the garment).

4When ironing is complete, remove the

plug from the socket, empty any

remaining water from the tank, and

allow to cool before storing.

5If you drop or severely knock your

iron this could cause internal damage

even if the outside appears alright.

Have it checked by a qualified

electrician.

6It is recommended that you use up one

beaker of water by operating your

iron’s steam function before ironing

any clothes as some dripping may

occur while your iron’s steam system

is activated.

SAVE THESE

INSTRUCTIONS

Electrical requirements

Check that the voltage on the rating plate of

your appliance corresponds with your house

electricity supply which must be A.C. (Alternating

Current).

If the socket outlets in your home are not

suitable for the plug supplied with this appliance,

the plug should be removed and the appropriate

one fitted.

WARNING: The plug removed from the

mains lead, if severed, must be destroyed as a

plug with bared flexible cord is hazardous if

engaged into a live socket outlet.

WARNING: THIS APPLIANCE MUST

BE EARTHED

Should the fuse in the 13 amp plug require

replacement, a BS1362 13 amp fuse must be

fitted.

Components of your

iron

⁄

Temperature control dial

Temperature indicator light

‹

Water filler hole

›

Soleplate

ﬁ

Spray button (certain models only)

ﬂ

On-off steam button

‡

Water tank viewing window

Instructions for use

Temperature Guide

Heat setting markings on the adjustable control dial of all Morphy Richards irons match those of

the International Textile Care Labelling Code.

⁄

‹

ﬁ

‡

ﬂ

›

Symbol 67 8 9

(120°C Max) Cool (160°C Max) Warm (210°C Max) Hot

Control knob Do not iron ● ●● ●●●

positions at all

Fabric Nylon, Acetates Wool, Polyester Cotton, Linen

E.g. Acrilan mixtures e.g. Rayon, Rayon

Courtelle, Orlon, Polyester/Cotton mixtures,

Triacetates, e.g. e.g. Rayon/Linen

Tricel/Polyester

Ironing Iron on wrong side. Fabrics requiring

If moisture required this setting usually

use damp cloth require steam

(Not Acetate) pressing for heavy

cotton, denim etc

With water in tank Dry and Spray Steam/spray

Without water in tank Dry ironing

4 4

Before use

Note: The Steam facility should only be used

on garments which are suitable for ironing at the

3 dot setting.

Textiles and clothes are supposed to carry

ironing instructions. If they don’t you should

follow the temperature guide on page 3, but be

sure to test the temperature by ironing the hem

of the garment or similar area first. If you turn

the control dial down from a hot setting to a

cooler setting, wait until the iron temperature

has stabilised before you continue ironing.

Filling

Before filling your iron make sure that it is not

plugged in and ensure that the iron is in the

‘steam off’ position. To do this slide the steam

button into the ‘down’ position E.

Grasp the iron by the handle and fill as shown

A, using the beaker provided.

Your iron has a large 250ml water tank. Your

iron has been specially designed for use with tap

water. Never use battery topping up fluid or

water containing any substances such as starch or

sugar, or defrosted water from a refrigerator. In

hard water areas the use of distilled or

demineralised water is recommended. Warning:

When filling your iron with tap water

always use your beaker. Never fill directly

under the tap.

Temperature control

Plug in the iron and

switch on. Set the heat

control dial Bto the

temperature required, but

don’t start ironing

immediately. If you wait a

few minutes, the iron will

stabilise at the required

setting. Your Morphy

Richards iron is fitted

with an indicator light which will go on and off

while you are ironing. This is perfectly normal as

it shows that the iron is maintaining the heat

setting you have chosen.

It is always a good idea to begin with ‘cool’

fabrics and work up to higher settings.

An iron heats up quicker than it cools down

so you’ll save time and electricity.

For the correct temperature always set the

control dial with the required setting at the

bottom of the dial nearest the front of the iron.

Features of your iron

Temperature indicator light

The temperature indicator light shows that

the iron is warming up. When the required

temperature is reached the light will go out and

will cycle on-off during operation.

Dry ironing

You can use your iron as a dry iron only.

Make sure the steam control is off E. Any

temperature setting may be used depending on

the garment. The spray feature (if fitted) may be

used provided there is water in the tank (see

filling section). You do not need to put any water

in the tank when dry ironing only.

Spray (certain models only)

Press the spray button Cand aim spray of

water at stubborn creases. You can do this whilst

dry ironing providing

there is water in the tank.

When using the water

spray it may be necessary

to push the button a few

times to get the spray

pump primed.

Steam ironing

Ensure that the temperature control dial is set

in the steam range Band that there is water in

the tank. Rest the iron on its heel and let it heat

up. Before you start ironing, slide the steam

button up to the steam

position D.

If you need to refill the

water tank during use, unplug

the iron and follow the filling

instructions taking care not to

spill any water over the iron.

Emptying and storing

When you have finished

ironing unplug your iron.

Ensure that the steam button

is down, in the ‘Steam off’

position Eand empty any

remaining water out of the

filler hole F.

Do not store in the box, but in an upright

position, so that any drops of water remaining

cannot leak out and discolour the soleplate. Your

iron has a cable tidy feature.

To clean an aluminium soleplate

To keep the soleplate of your iron clean and

free of limescale, make a paste of mild scouring

powder and a little water. Apply a small amount

to the soleplate, rub and then remove with a

damp cloth. Wipe thoroughly with a clean cloth.

To clean the exterior

Allow to cool and wipe over with a damp

soapy cloth, then dry with a clean dry cloth.

Steam on

Steam off

Morphy Richards Limited, Mexborough,

South Yorkshire, England S64 8AJ

Morphy Richards products are intended for household use only.

Morphy Richards has a policy of continuous improvement in product quality and design.

The Company, therefore, reserves the right to change the specification of its models at any time.

441/3752/11 Rev 1

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Morphy Richards Fer

Morphy Richards

Morphy Richards RN40715 Manuel utilisateur

Morphy Richards

Morphy Richards IB40622 Manuel utilisateur

Morphy Richards

Morphy Richards Atomist Manuel utilisateur

Morphy Richards

Morphy Richards INTELLIDOME Manuel utilisateur

Morphy Richards

Morphy Richards INTELLIDOME Manuel utilisateur

Morphy Richards

Morphy Richards RN40635 Manuel utilisateur

Morphy Richards

Morphy Richards ELITE S Manuel utilisateur

Morphy Richards

Morphy Richards COMFIGRIP Manuel utilisateur

Morphy Richards

Morphy Richards TURBOSTEAM RN40513 Manuel utilisateur

Morphy Richards

Morphy Richards TURBOSTEAM IRON - MANUAL 2 Manuel utilisateur

Morphy Richards

Morphy Richards Saturn Steam Manuel utilisateur

Morphy Richards

Morphy Richards breeze Manuel utilisateur

Morphy Richards

Morphy Richards Precise Steam Iron steam/spray shot Manuel utilisateur

Morphy Richards

Morphy Richards TURBOSTEAM RN40630 MUK REV2 Manuel utilisateur

Morphy Richards

Morphy Richards 303100 Manuel utilisateur

Morphy Richards

Morphy Richards Jet Steam 333024 Manuel utilisateur

Morphy Richards

Morphy Richards 40734 Manuel utilisateur

Morphy Richards

Morphy Richards 40707 Manuel utilisateur

Morphy Richards

Morphy Richards breeze Manuel utilisateur

Morphy Richards

Morphy Richards IB4070X Manuel utilisateur

Morphy Richards

Morphy Richards 40725 Manuel utilisateur

Morphy Richards

Morphy Richards IB40310 Manuel utilisateur

Morphy Richards

Morphy Richards Semi-electronic iron Manuel utilisateur

Morphy Richards

Morphy Richards SPEED STEAMPRO Manuel utilisateur

Manuels Fer populaires d'autres marques

Clatronic

Clatronic DB 3703 Manuel utilisateur

TEFAL

TEFAL FV4093Z0 Manuel utilisateur

Gorenje

Gorenje SIH 2200 BS Manuel utilisateur

Philips

Philips GC6012 Manuel utilisateur

Bosch

Bosch 2 Series Manuel utilisateur

Riffel

Riffel Catena KB-819 Manuel utilisateur

Texi

Texi Hestia Manuel utilisateur

Maxwell

Maxwell MW-3010 Manuel utilisateur

TREVIDEA

TREVIDEA Girmi ST60 Manuel utilisateur

Philips

Philips HI5914/30 Manuel utilisateur

Primula

Primula Vapormat Manuel utilisateur

Magio

Magio MG-541 Manuel utilisateur

Scarlett

Scarlett SC-1334S Manuel utilisateur

Bosch

Bosch Sensixx B22L Manuel utilisateur

Philips

Philips GC651 Manuel utilisateur

Vitek

Vitek VT-1247 VT Manuel utilisateur

Cleanmaxx

Cleanmaxx 3397 Manuel utilisateur

Philips

Philips GC800 Manuel utilisateur