Mircom TX3-BBCX-4W Guide de référence
TX3-BBCX-4W Wiring
! " #
MOUNT THE CARD ACCESS CONTROLLERS
1. Mount up to 4 card access controllers in the enclosure. Mount each card so that
the P7 LED display port is on the left.
2. Mount the cards in two layers using the standos.
3. Connect the LED ribbon cables to the P7 LED display ports on the card access
controllers.
Figure 1. Mounting the card access controllers
© Mircom 2014
Printed in Canada
Subject to change without prior notice
LT-1182 rev 0
A complete library of product
information is available at:
www.TX3.mircom.com
WIRE THE CARD ACCESS CONTROLLERS
There are two battery shelves.
1. Connect the two upper cards to the batteries on the top shelf with the longer
cables.
2. Connect the two lower cables to the batteries on the lower shelf with the
shorter cables.
3. Connect the battery cables to the BAT + (red) and BAT - (black) terminals on the
card access controllers.
Longer cables to
upper battery shelf
Shorter cables to
lower battery shelf
Figure 2. Wiring the card access controllers to the batteries
© Mircom 2014
Printed in Canada
Subject to change without prior notice
LT-1182 rev 0
A complete library of product
information is available at:
www.TX3.mircom.com
Upper cards
Lower cards
Autres manuels pour TX3-BBCX-4W
1
Table des matières
Autres manuels Mircom Contrôleurs
Mircom
Mircom TX3 Series Manuel
Mircom
Mircom OpenBAS-HV-NX4AO Manuel utilisateur
Mircom
Mircom RB-MD-1086 Series Manuel utilisateur
Mircom
Mircom RAM-2944LCD Manuel utilisateur
Mircom
Mircom OpenBAS-NWK-ETH3 Manuel utilisateur
Mircom
Mircom OpenBAS-HV-NX10 Series Manuel utilisateur
Mircom
Mircom TX3 Series Manuel utilisateur
Mircom
Mircom TX3 Series Manuel utilisateur
Mircom
Mircom OpenBAS-LC-NX12R Manuel utilisateur
Mircom
Mircom TX3-BBCX-4W Manuel utilisateur
