2. Product presentation
MiR AI Camera Getting started (en) 09/2019 - v.1.0 ©Copyright 2019: Mobile Industrial Robots A/S. 7
To reset the camera, you must hold down the Reset button for ten seconds.
2.2 MiRFleet and operating requirements
The MiR AI Camera is a product that must be connected to MiRFleet to be used as intended.
The list below describes the requirements for being able to use MiR AI Camera with your
MiRFleet. Some of these points are only applicable if you choose to use a WiFi connection to
the camera instead of Ethernet.
•Your MiRFleet must be configured to use a host network interface. This is the default con-
figuration for MiRFleet.
•MiR AI Camera should be in the same physical location as MiRFleet.
•Minimum bandwidth of 1 Mbit per AIcamera with a maximum latency of 150 mS.
•Signal strength not less than -75 dBm. Signal-to-noise ratio should be at least 20 dB.
•MiRFleet must be updated to a software that supports MiR AI Camera.
•MiR AI Camera performs best in well lit areas.
2.3 Light indicator
The light indicator on MiR AI Camera is used to provide feedback on its current status. Table
2.1 describes the status linked to the various colors.
Color Status
White Busy, such as updating or starting up.
Yellow WiFi setup mode active, waiting for network connection.
Green Connected to network, but with no uploaded data model.The light blinks
when changing to this state.
Red Error, such as connection errors. The light blinks when changing to this
state.
Cyan Object detection mode active.
Dark blue Collection mode active.
2.1. Light indicator color statuses
