Minolta SC-100 Manuel utilisateur

INTRODUCTION

Thank you for purchasing the Minolta Slide Feeder SC-100.

The Slide Feeder SC-100 is designed for use with the Minolta Dimâge Scan Multi

scanner and allows you to automatically feed and continuously scan up to 50

mounted slides at one time.The Slide Feeder can be used with either the

Dimâge Scan Multi utility software, TWAIN driver, or plug-in and allows you to

select the file destination.

Before using the Slide Feeder, please read this instruction manual thoroughly. It

is also necessary to read the Accessory Information section in the scanner’s

software instruction manual.

FOR PROPER AND SAFE USE

To avoid fire or electric shock:

• Do not expose this unit to liquids.

• Do not insert metal objects into this unit.

•Do not attempt to disassemble this product. Take the

product to a Minolta Service facility for repairs.

If there is smoke, a strange smell, or any other unusual

conditions, shut down and unplug the unit, then contact a Minolta

Service Facility.

CAUTION

Unexpected damage may occur if this unit is left unattended near

young children.

Please read and understand each caution before using this product.

TABLE OF CONTENTS

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..1

For Proper and Safe Use . . . . . . . . . . . . . . . . . . . ..2

Names of Parts . . . . . . . . . . . . . . . . . . . . . . . . . . ..4

Attaching the Slide Feeder. . . . . . . . . . . . . . . . . . ..6

Recommended Slide Mounts . . . . . . . . . . . . . . . . 10

Loading Slides. . . . . . . . . . . . . . . . . . . . . . . . . . . 11

Detaching the Slide Feeder . . . . . . . . . . . . . . . . . 14

Removing Jammed Slides . . . . . . . . . . . . . . . . . . 18

Care and Handling. . . . . . . . . . . . . . . . . . . . . . . . 26

Indicator Lamp. . . . . . . . . . . . . . . . . . . . . . . . . . . 27

Technical Details . . . . . . . . . . . . . . . . . . . . . . . . . 28

NAMES OF PARTS

Slide-feeder cover

“IN” column

“OUT” column

Mount cover

Pressure bar

Indicator lamp

Power switch

Inside the Mount Cover

Transport Unit

Spring

Holding screw

Contacts

Holding screw

Slide carrier

ATTACHING THE SLIDE FEEDER

1. Remove the connector

cover from the top of

the scanner.

2. Press the power

switch to turn the

scanner on.

• Set-up will begin.

• The green indicator

lamp blinks slowly

while the scanner is

busy setting-up.Wait

until the lamp turns

off.

7Continued on next page.

3. Insert the slide carrier

into the film-slot in

the direction

indicated by the white

arrow on top of the

carrier.

• Do not insert the slide

carrier at an angle.

• The slide carrier is

included in the slide-

feeder package.

4. Gently push the

carrier into the

scanner until the

insertion mark is

aligned with the film-

slot door.

• The slide carrier will

be automatically

guided in past the

mark.

ATTACHING THE SLIDE FEEDER – CONT’D

5. Shut down the

computer, then turn

the scanner off.

• Always be sure the

scanner is off when

attaching and

detaching the slide

feeder.

6. Attach the slide feeder

to the scanner by

lining up the

scanner’s connector

with the contacts on

the slide feeder.

• Push the slide feeder

straight down so the

contacts are fully

inserted into the

connector.The two

pegs on either side of

the slide feeder’s

contacts should fit into

the notches on the

scanner.

7. Tighten the holding

screws on both sides

of the slide feeder,

then tighten the

holding screw on the

top of the scanner.

• Tighten the holding

screws by pressing

and turning.

8. Press the power

switch on the front of

the slide feeder to

turn the scanner on.

• Set-up will begin.

• The indicator lamp on

the front of the slide

feeder will blink slowly

while the scanner is

setting up. Wait until

the indicator lamp on

the front of the slide

feeder glows.

9. Turn on the computer.

RECOMMENDED SLIDE MOUNTS

Some slide mounts are not recommended for use in the slide feeder. Jamming is

likely to occur with the following slide mounts.

The Slide Feeder can load

approximately 50 mounted slides

(1.6mm thickness).The number of slides

that can be loaded depends on the

thickness of the slide mounts. Slide

mounts should be between 1 – 3mm

thick and have a flat, even surface on

both the top and bottom.

Mounts with indentations on the surface,

such as for labels or slots where film is

to be inserted.

Mounts with rounded edges.

Mounts with rough, uneven edges or

surfaces.

Max. thickness: 3mm

Remount slides if the mount is damaged or coming apart.

Table des matières

Autres manuels Minolta Scanner

Minolta

Minolta Dimage Scan Elite II Manuel utilisateur

Minolta

Minolta Dimage Scan Elite F-2900 Manuel utilisateur

Minolta

Minolta DIMAGE SCAN ELITE 5400 Manuel utilisateur

Minolta

Minolta Dimage Scan Multi2 Manuel utilisateur

Minolta

Minolta DiMAGE Scan Multi PRO AF-5000 Manuel utilisateur

Minolta

Minolta DiMAGE DiMAGE Scan Multi PRO Manuel utilisateur

Minolta

Minolta Dimage Scan Scan Elite I Manuel utilisateur

Minolta

Minolta Dimage Scan Elite II Manuel utilisateur

Minolta

Minolta Dimage Scan Multi Manuel utilisateur

Minolta

Minolta Dimage Scan Multi Manuel utilisateur

Minolta

Minolta Dimage Scan Multi Manuel utilisateur

Minolta

Minolta QuickScan 35 Manuel utilisateur

Minolta

Minolta Dimage Scan Dual2 AF-2820U Manuel utilisateur

Minolta

Minolta DiMAGE Scan Multi PROAF-5000 Manuel utilisateur

Minolta

Minolta Film Scanner II Manuel utilisateur

Minolta

Minolta QUICKSCAN35 Manuel utilisateur

Minolta

Minolta DR1600 Manuel utilisateur

Minolta

Minolta MS 6000 Manuel utilisateur

Minolta

Minolta Dimage Scan Elite F-2900 Manuel utilisateur

Minolta

Minolta PS7000 Manuel utilisateur

Minolta

Minolta Dimage Scan Elite II Manuel utilisateur

Minolta

Minolta DIMAGE SCAN DUAL III Manuel utilisateur

Minolta

Minolta Dimage Scan Elite II Manuel utilisateur

Minolta

Minolta DIMAGE SCAN MULTI PRO Manuel utilisateur

Manuels Scanner populaires d'autres marques

Plustek

Plustek Scanner Manuel utilisateur

Z/I Imaging

Z/I Imaging PhotoScan 2001 Manuel utilisateur

Renkforce

Renkforce DS100-5M Manuel utilisateur

Image Access

Image Access WideTEK A2 Manuel utilisateur

Canon

Canon imageFORMULA CR-120N Manuel utilisateur

Fujitsu

Fujitsu FI-4860C2 Manuel utilisateur

GeoSlam

GeoSlam ZEB Horizon Instructions d'installation

Kodak

Kodak i5800 Scanner Manuel utilisateur

Kodak

Kodak i7300 Manuel utilisateur

Revopoint

Revopoint POP Manuel utilisateur

Fujitsu

Fujitsu fi-4860C Manuel utilisateur

Eddyfi Technologies

Eddyfi Technologies Floormap X Manuel utilisateur

Faselase

Faselase F6 Manuel utilisateur

Fujitsu

Fujitsu CardMinder Manuel utilisateur

Uniden

Uniden BC340CRS Manuel utilisateur

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Manuel utilisateur

Mustek

Mustek PageExpress 4800 Pro Manuel utilisateur

Optex

Optex 750830 Manuel utilisateur